Moultrie Pro Magnum Feeder manual

Moultrie Pro Magnum Feeder
7.5 · 1
PDF manual
 · 2 pages
English
manualMoultrie Pro Magnum Feeder
Drum
Feeder
Kit
Turn drum over, measure and mark the center of the bottom.
Center the provided template on the bottom of the drum
and secure with tape. Drill three 5/16" Feeder Leg Holes.
Using a Hole Saw, drill a 2-1/4" hole in the center of the
bottom of your drum.
caution: wear eye protection
Pro Magnum will mount to the bottom of any drum or bucket
Inside Drum
Outside Drum
Bolt
Flat Nut
Feeder Mounting
Holes

Instructions for Pro Magnum Feeder

THANK YOU for your purchase of the Pro Magnum Feeder. Please read this sheet before
operating the unit. If you should have any questions about this product or any other Moultrie
product, please contact us using the information on the back of this sheet. To help us to
better serve you and to activate your Lifetime Warranty, please submit your warranty
information online at http://www.moultriefeeders.com/warranty

DRILLING YOUR DRUM/BARREL/BUCKET

A

MOUNTING THE FEEDER

B
Turn drum over, measure and mark the center of the bottom.
Center the provided template on the bottom of the drum
and secure with tape. Drill three 5/16” Feeder Leg Holes.
Using a Hole Saw, drill a 2.25” hole in the center of the
bottom of your drum.
From the inside of the drum, slide the three provided Bolts
through the holes on the bottom and into the provided
Flat Nuts. From the inside, using a Phillips head screwdriver,
turn the Bolt clockwise until the Flat Nut is tight against
the bottom.
Slide feeder over three Bolts that are sticking rmly through
the bottom of the drum. Attach Feeder Kit to the Drum
using the three provided Wing-Nuts.
Pro Magnum will mount to the bottom of any drum or bucketNOTE: If you purchased a Moultrie barrel, go to step II
DO NOT EXCEED 400 LBS
OF FEED IN 55-GAL FEEDERS
Pro Magnum
Feeder Kit
Belly Band
Ring
Bolt
Spacer
Lock
Washer
Nut
NOTE: DO NOT LOAD FEEDER until it is standing up and in place (see Section E).
DO NOT EXCEED 200 LBS
OF FEED IN 30-GAL FEEDERS
Belly Band
Ring
Slide the bolt through the Belly Band Ring, Spacer and
Lock Washer as shown. Tighten nut on bolt until metal
Belly Band Ring tabs are touching spacer on each side.
Turn the Metal Drum upside down and slide the Belly Band Ring
around perimeter and make sure that belly band is snug against
the bottom structure ring as shown (Moultrie barrel only).
s

View the manual for the Moultrie Pro Magnum Feeder here, for free. This manual comes under the category Not categorized and has been rated by 1 people with an average of a 7.5. This manual is available in the following languages: English. Do you have a question about the Moultrie Pro Magnum Feeder or do you need help? Ask your question here

Need help?

Do you have a question about the Moultrie and the answer is not in the manual? Ask your question here. Provide a clear and comprehensive description of the problem and your question. The better your problem and question is described, the easier it is for other Moultrie owners to provide you with a good answer.

Number of questions: 0

General
Moultrie
Pro Magnum Feeder
Not categorized
English
User manual (PDF)

Can't find the answer to your question in the manual? You may find the answer to your question in the FAQs about the Moultrie Pro Magnum Feeder below.

Is your question not listed? Ask your question here

No results