Miele DA 1260 es manual

Miele DA 1260 es
5.9 · 1
PDF manual
 · 44 pages
English
manualMiele DA 1260 es

Installation

*INSTALLATION*
38
- The diameter of the exhaust ducting
must not be smaller than the cross-
section of the exhaust duct (see
Appliance dimensions”). This applies
in particular when using flat ducting.
- The exhaust ducting should be as
short and straight as possible.
- Only use wide radius bends.
- The exhaust ducting must not be
kinked or compressed.
- All connections must be strong and
airtight.
- If the exhaust ducting has flaps,
these must be opened whenever the
cooker hood is switched on.
Any constriction of the air throughput
will reduce extraction performance
and increase operating noise.
Flue
If the exhaust air is to be ducted into a
flue, the ducting must be directed in the
flow direction of the flue.
If the flue is used by several ventilation
units, the cross-section of the flue must
be large enough.
A non-return flap ensures that when the
cooker hood is not in operation, the
duct is closed to prevent unwanted
exchange of room air and outside air.
If the exhaust is ducted through an
outside wall, a Miele wall vent or roof
vent (available as an optional
accessory) is recommended. Both of
these have a built-in non-return flap.
If the on-site ventilation system does
not have a non-return flap, you can
purchase one as an optional accessory.
Condensation
If the exhaust ducting is to run through
cool rooms or ceiling space, for
example, the significant variations in
temperature between the different areas
can cause condensation to form.
Insulate the exhaust ducting to reduce
temperature variations.
If the exhaust ducting is to be laid
horizontally, it must be laid with a
downwards sloping gradient of at least
1cm per meter. This is to ensure that
condensation cannot drain back into
the cooker hood.

Manual

View the manual for the Miele DA 1260 es here, for free. This manual comes under the category exhaust hoods and has been rated by 1 people with an average of a 5.9. This manual is available in the following languages: English. Do you have a question about the Miele DA 1260 es or do you need help? Ask your question here

Index

Need help?

Do you have a question about the Miele and is the answer not in the manual?

  • Receive updates on solutions
  • Get answers to your question

Question and answer

Number of questions: 0

Miele DA 1260 es specifications

Below you will find the product specifications and the manual specifications of the Miele DA 1260 es.

General
BrandMiele
ModelDA 1260 es
Productexhaust hood
LanguageEnglish
FiletypeUser manual (PDF)

Frequently Asked Questions

Can't find the answer to your question in the manual? You may find the answer to your question in the FAQs about the Miele DA 1260 es below.

When should I replace the carbon filter on my extractor hood?

The carbon filter should be replaced every three to twelve months.

How often should I clean the metal hood grease filters?

The metal grease filters should be cleaned every eight to ten weeks.

Where can I find the model number of my cooker ectractor hood?

The model number of the hood is usually found on a white label inside the hood.

Is the manual of the Miele DA 1260 es available in English?

Yes, the manual of the Miele DA 1260 es is available in English .

Is your question not listed? Ask your question here

No results