Miele DA 1260 es manual

Miele DA 1260 es
5.9 · 1
PDF manual
 · 44 pages
English
manualMiele DA 1260 es

Installation

*INSTALLATION*
37

For recirculation mode

Fit the charcoal filter (see “Cleaning
and care”).

Electrical connection

Refer to the notes in “Electrical
connection” and “Warning and
Safety instructions” before
connecting to the electricity supply.
Connect the cooker hood to the
electricity supply.

Functional check

To do this, switch the fan on.
- In air extraction mode air should not
come out of the recirculation grille at
the front of the cooker hood.
- In recirculation mode the air should
come out of the recirculation grille at
the front of the cooker hood.
If this does not happen, the deflector is
not installed correctly (see “Deflector”).

Electrical connection

Refer to the notes in “Electrical
connection” and “Warnings and
safety notes” before connecting to
the power supply.
The connection data (voltage,
frequency) on the data plate must
match the data of the mains power
supply. The position of the data plate is
explained in the “Service” chapter.
The cooker hood is equipped with a
power cable and a safety plug.
The connection must be made via a
socket which remains accessible after
the cooker hood has been installed. If
the socket is no longer accessible after
installation or if you are using a hard-
wired connection, there must be a
suitable means of disconnection for all
poles in the household electrical system
which meets the requirements of
overvoltage category III.
Safety can be increased by fitting the
appliance with a residual current
device.
Only qualified electricians are permitted
to carry out work on the household
electrical system.
This appliance must be earthed.

Connection for air extraction

If the cooker hood is used at the

same time as a heating appliance
that relies on oxygen from the same
room, there is a risk in certain
circumstances of toxic fumes
building up.
It is essential that the “Warning and
Safety” instructions are observed.
The cooker hood should be installed
according to local and national
building regulations. Seek approval
from the building inspector where
necessary.
Only use smooth pipes or flexible
exhaust ducting made from
approved non-flammable materials
for exhaust ducting.
To achieve the most efficient air
throughput with the lowest noise levels,
please note the following:

Manual

View the manual for the Miele DA 1260 es here, for free. This manual comes under the category exhaust hoods and has been rated by 1 people with an average of a 5.9. This manual is available in the following languages: English. Do you have a question about the Miele DA 1260 es or do you need help? Ask your question here

Index

Need help?

Do you have a question about the Miele and is the answer not in the manual?

  • Receive updates on solutions
  • Get answers to your question

Question and answer

Number of questions: 0

Miele DA 1260 es specifications

Below you will find the product specifications and the manual specifications of the Miele DA 1260 es.

General
BrandMiele
ModelDA 1260 es
Productexhaust hood
LanguageEnglish
FiletypeUser manual (PDF)

Frequently Asked Questions

Can't find the answer to your question in the manual? You may find the answer to your question in the FAQs about the Miele DA 1260 es below.

When should I replace the carbon filter on my extractor hood?

The carbon filter should be replaced every three to twelve months.

How often should I clean the metal hood grease filters?

The metal grease filters should be cleaned every eight to ten weeks.

Where can I find the model number of my cooker ectractor hood?

The model number of the hood is usually found on a white label inside the hood.

Is the manual of the Miele DA 1260 es available in English?

Yes, the manual of the Miele DA 1260 es is available in English .

Is your question not listed? Ask your question here

No results