MicroView MVID-02IR-E manual

MicroView MVID-02IR-E
5.6 · 1
PDF manual
 · 172 pages
English
manualMicroView MVID-02IR-E
Network Camera User Manual
83
Enable Third Stream to reboot the system and enable the third stream.
The main stream is usually for recording and live view with good bandwidth,
and the sub-stream can be used for live view when the bandwidth is limited.
To enable the third stream, go to System>Maintenance>System Service>
Software and check the checkbox of Enable Third Stream to reboot the system
and enable the third stream.
3. You can customize the following parameters for the selected stream type.
Video Type:
Select the stream type to video stream, or video & audio composite stream. The
audio signal will be recorded only when the Video Type is Video & Audio.
Resolution:
Select the resolution of the video output.
Bitrate Type:
Select the bitrate type to constant or variable.
Video Quality:
When bitrate type is selected as Variable, 6 levels of video quality are selectable.
Frame Rate:
Set the frame rate. The frame rate is to describe the frequency at which the video
stream is updated and it is measured by frames per second (fps). A higher frame rate
is advantageous when there is movement in the video stream, as it maintains image
quality throughout.
Max. Bitrate:
Set the max. bitrate from 32 to 16384 Kbps. The higher value corresponds to the
higher video quality, but the better bandwidth is required.
Note: The maximum limit of the max. bitrate value varies according to different
camera platforms. For certain cameras, the maximum limit is 8192 Kbps or 12288
Kbps.
Video Encoding:
If the Stream Type is set to main stream, H.264 and H.265 are selectable, and if the
stream type is set to sub stream or third stream, H.264, MJPEG, and H.265 are

Manual

View the manual for the MicroView MVID-02IR-E here, for free. This manual comes under the category security cameras and has been rated by 1 people with an average of a 5.6. This manual is available in the following languages: English. Do you have a question about the MicroView MVID-02IR-E or do you need help? Ask your question here

Index

Need help?

Do you have a question about the MicroView and is the answer not in the manual?

  • Receive updates on solutions
  • Get answers to your question

Question and answer

Number of questions: 0

MicroView MVID-02IR-E specifications

Below you will find the product specifications and the manual specifications of the MicroView MVID-02IR-E.

The MicroView MVID-02IR-E is a security camera with a total of 2 megapixels and a maximum resolution of 1920 x 1080 pixels, providing Full HD quality images. It features a CMOS sensor, with a single sensor and an optical sensor size of 1/2.8 inches. The camera offers progressive scan and video streaming capabilities, utilizing multicast streaming method. Equipped with a fixed focal length of 2.8 millimeters, the MVID-02IR-E also includes Digital Wide Dynamic Range (DWDR) and 3D Noise Reduction (NR) features for enhanced image clarity. It can be powered using a DC power source or Power over Ethernet (PoE) for added flexibility. With an International Protection (IP) code of IP67, this camera is suitable for outdoor use and is resistant to dust and water ingress. The 2MP Mini IR Dome IP Camera WDR 1080p Full HD Outdoor model offers night vision capabilities up to 30 meters using its built-in infrared lights. It can be easily connected to a Network Video Recorder (NVR) using a standard CAT 5 computer network cable. The camera is compatible with EasyView and most other Video Management System (VMS) providers, featuring an OnVif driver and easy installation with the IP-Tool from MicroView.

General
BrandMicroView
ModelMVID-02IR-E | MVID-02IR-E
Productsecurity camera
EAN5711783405108
LanguageEnglish
FiletypeUser manual (PDF)
Video
Full HDYes
Total megapixels2 MP
Maximum resolution1920 x 1080 pixels
Video streamingYes
Digital Wide Dynamic Range (DWDR)Yes
3D NR (Noise Reduction)Yes
Video formats supportedH.264, H.264+, M-JPEG
Bit rate32 Kbps - 8 Mbps
Supported graphics resolutions352 x 240,352 x 288,640 x 360,1280 x 720 (HD 720),1280 x 960,1920 x 1080 (HD 1080)
Frame rate30 fps
Image quality adjustmentBrightness, Contrast, Saturation
Back Light Compensation (BLC)Yes
Image sensor
Sensor typeCMOS
Number of sensors1
Optical sensor size1/2.8 "
Progressive scanYes
Network
Streaming methodMulticast
Quality of Service (QoS) supportYes
Supported network protocolsTCP/IP, UDP, ICMP, HTTP, HTTPS, FTP, DHCP, DNS, DDNS, RTP, RTSP, RTCP, PPPoE, NTP, UPnP, SMTP, SNMP, IGMP, 802.1X, QoS, IPv6, Bonjour
Ethernet LANYes
Wi-Fi-
Bluetooth-
Ethernet interface typeFast Ethernet
Networking standardsIEEE 802.3af
Lens system
Fixed focal length2.8 mm
Number of lenses1
Power
Power source typeDC, PoE
Power consumption (typical)5.3 W
Design
International Protection (IP) codeIP67
WeatherproofYes
IK codeIK10
Mounting typeCeiling
Protection featuresShock resistant
Form factorDome
Product colorBlack, White
Night vision
Night visionYes
Night vision distance30 m
LED typeIR
Storage
Card reader integratedYes
Built-in HDD-
Compatible memory cardsMicroSD (TransFlash), MicroSDHC, MicroSDXC
Camera
Minimum illumination0.01 lx
Camera shutter speed1/3 - 1/10000 s
Field of view (FOV) angle106 °
Performance
Infrared (IR) cut-off filterYes
Connectivity technologyWired
Alarm input/outputYes
TypeIP security camera
Placement supportedOutdoor
Audio
Audio formats supportedG.711, G.726
Management features
Behavior analysisIntrusion detection, Line crossing detection
Security
Video motion detectionYes
Digital watermarkYes
Packaging content
Number of cameras1
Ports & interfaces
Ethernet LAN (RJ-45) ports1
Operational conditions
Operating temperature (T-T)-30 - 60 °C
Weight & dimensions
Diameter111 mm
Height82 mm
Weight500 g
show more

Frequently Asked Questions

Can't find the answer to your question in the manual? You may find the answer to your question in the FAQs about the MicroView MVID-02IR-E below.

What is the weight of the MicroView MVID-02IR-E?

The MicroView MVID-02IR-E has a weight of 500 g.

What is a megapixel?

The number of megapixels denotes how many pixels there are in the sensor. 1 megapixel equals 1 million pixels. The more pixels, the higher the potential image quality.

What does the abbreviation 'MP' stand for?

MP stands for MegaPixels.

What is the height of the MicroView MVID-02IR-E?

The MicroView MVID-02IR-E has a height of 82 mm.

Is the manual of the MicroView MVID-02IR-E available in English?

Yes, the manual of the MicroView MVID-02IR-E is available in English .

Is your question not listed? Ask your question here

No results