MicroView MVIC-01IR-E manual

MicroView MVIC-01IR-E
8.1 · 1
PDF manual
 · 172 pages
English
manualMicroView MVIC-01IR-E
Network Camera User Manual
83
Enable Third Stream to reboot the system and enable the third stream.
The main stream is usually for recording and live view with good bandwidth,
and the sub-stream can be used for live view when the bandwidth is limited.
To enable the third stream, go to System>Maintenance>System Service>
Software and check the checkbox of Enable Third Stream to reboot the system
and enable the third stream.
3. You can customize the following parameters for the selected stream type.
Video Type:
Select the stream type to video stream, or video & audio composite stream. The
audio signal will be recorded only when the Video Type is Video & Audio.
Resolution:
Select the resolution of the video output.
Bitrate Type:
Select the bitrate type to constant or variable.
Video Quality:
When bitrate type is selected as Variable, 6 levels of video quality are selectable.
Frame Rate:
Set the frame rate. The frame rate is to describe the frequency at which the video
stream is updated and it is measured by frames per second (fps). A higher frame rate
is advantageous when there is movement in the video stream, as it maintains image
quality throughout.
Max. Bitrate:
Set the max. bitrate from 32 to 16384 Kbps. The higher value corresponds to the
higher video quality, but the better bandwidth is required.
Note: The maximum limit of the max. bitrate value varies according to different
camera platforms. For certain cameras, the maximum limit is 8192 Kbps or 12288
Kbps.
Video Encoding:
If the Stream Type is set to main stream, H.264 and H.265 are selectable, and if the
stream type is set to sub stream or third stream, H.264, MJPEG, and H.265 are

Manual

View the manual for the MicroView MVIC-01IR-E here, for free. This manual comes under the category security cameras and has been rated by 1 people with an average of a 8.1. This manual is available in the following languages: English. Do you have a question about the MicroView MVIC-01IR-E or do you need help? Ask your question here

Index

Need help?

Do you have a question about the MicroView and is the answer not in the manual?

  • Receive updates on solutions
  • Get answers to your question

Question and answer

Number of questions: 0

MicroView MVIC-01IR-E specifications

Below you will find the product specifications and the manual specifications of the MicroView MVIC-01IR-E.

General
BrandMicroView
ModelMVIC-01IR-E | MVIC-01IR-E
Productsecurity camera
EAN5711783405092
LanguageEnglish
FiletypeUser manual (PDF)
Video
Total megapixels2 MP
Maximum resolution1920 x 1080 pixels
Supported graphics resolutions1280 x 720 (HD 720),1280 x 960,1920 x 1080 (HD 1080)
Supported video modes1080p
Digital Wide Dynamic Range (DWDR)Yes
3D NR (Noise Reduction)Yes
Video streamingYes
Video formats supportedH.264, M-JPEG
Bit rate32 Kbps - 8 Mbps
Image quality adjustmentBrightness, Contrast, Saturation
Back Light Compensation (BLC)Yes
Image sensor
Sensor typeCMOS
Number of sensors1
Progressive scanYes
Optical sensor size1/2.8 "
Audio
Audio system2-way
Built-in microphoneYes
Built-in speaker(s)Yes
Audio formats supportedG.711, G.726
Lens system
Fixed focal length2.8 mm
Number of lenses1
Power
Power source typeDC, PoE
Power consumption (typical)4.5 W
Network
Wi-FiYes
Ethernet LANYes
Bluetooth-
Streaming methodMulticast
Quality of Service (QoS) supportYes
Supported network protocolsTCP/IP, ICMP, HTTP, HTTPS, FTP, DHCP, DNS, DDNS, RTP, RTSP, RTCP, NTP, UPnP, SMTP, IGMP, 802.1X, Q oS, IPv6, Bonjour
Ethernet interface typeFast Ethernet
Wi-Fi standards802.11b, 802.11g, Wi-Fi 4 (802.11n)
Frequency band2.4 - 2.4835 GHz
Networking standardsIEEE 802.3af
Night vision
Night visionYes
Night vision distance10 m
Camera
Minimum illumination0.028 lx
Camera shutter speed1/3 - 1/100000 s
Storage
Card reader integratedYes
Built-in HDD-
Compatible memory cardsMicroSD (TransFlash), MicroSDHC, MicroSDXC
Maximum memory card size128 GB
Management features
Behavior analysisIntrusion detection, Line crossing detection
Security
Video motion detectionYes
Active tampering alarmYes
Security algorithms64-bit WEP, 128-bit WEP, WPA, WPA-PSK, WPA2, WPA2-PSK, WPS
Ports & interfaces
Ethernet LAN (RJ-45) ports1
Performance
Connectivity technologyWired
Alarm input/outputYes
TypeIP security camera
Placement supportedIndoor
Operational conditions
Operating temperature (T-T)-10 - 40 °C
Technical details
Integrated PIR sensorYes
Weight & dimensions
Width72.3 mm
Depth89.9 mm
Height131.3 mm
Weight400 g
Design
Form factor-
Product colorBlack, White
Mounting type-
Packaging content
Number of cameras1
show more

Frequently Asked Questions

Can't find the answer to your question in the manual? You may find the answer to your question in the FAQs about the MicroView MVIC-01IR-E below.

What is the weight of the MicroView MVIC-01IR-E?

The MicroView MVIC-01IR-E has a weight of 400 g.

What is a megapixel?

The number of megapixels denotes how many pixels there are in the sensor. 1 megapixel equals 1 million pixels. The more pixels, the higher the potential image quality.

What does the abbreviation 'MP' stand for?

MP stands for MegaPixels.

What is the height of the MicroView MVIC-01IR-E?

The MicroView MVIC-01IR-E has a height of 131.3 mm.

What is the width of the MicroView MVIC-01IR-E?

The MicroView MVIC-01IR-E has a width of 72.3 mm.

What is the depth of the MicroView MVIC-01IR-E?

The MicroView MVIC-01IR-E has a depth of 89.9 mm.

Is the manual of the MicroView MVIC-01IR-E available in English?

Yes, the manual of the MicroView MVIC-01IR-E is available in English .

Is your question not listed? Ask your question here

No results