View the manual for the Medisana IN 520 here, for free. This manual comes under the category inhalators and has been rated by 1 people with an average of a 7.5. This manual is available in the following languages: English. Do you have a question about the Medisana IN 520 or do you need help? Ask your question here
Can't find the answer to your question in the manual? You may find the answer to your question in the FAQs about the Medisana IN 520 below.
To determine if you are using the Medisana IN 520 inhalator for its intended use, follow these steps: 1. Read the user manual thoroughly before using the device. Pay special attention to the safety instructions provided. 2. Ensure that the device is used only for the purpose described in the manual. The inhalator is designed for aerosol therapy and the nebulization of liquids and liquid medicines for the treatment of the upper and lower airways. 3. Do not use the inhalator near flammable anesthetic mixtures with oxygen or nitrous oxide (laughing gas). 4. The device is not suitable for anesthesia or lung ventilation. 5. Use the original accessories specified in the manual for the inhalator. 6. Do not use the device if you notice any damage or unusual behavior. Contact the manufacturer or authorized service center for assistance. 7. Follow the safety regulations for electronic equipment, such as not touching the device with wet or moist hands, placing it on a stable surface during use, and not pulling the power cable forcefully. 8. Confirm that the electrical data on the label at the bottom of the device match the power supply. 9. Keep the device protected from water, extreme temperatures, shocks, dirt, dust, strong sunlight, heat, and cold. 10. Remember that the use of the inhalator is not a substitute for a medical visit. Consult your doctor for proper diagnosis and treatment. By following these steps, you can ensure that you are using the Medisana IN 520 inhalator for its intended purpose and in a safe manner.
If the Medisana IN 520 inhalator is not assembling properly, follow these steps: 1. Check if all the components of the inhalator are present and undamaged. Ensure that you have the nebulizer set, compressor, mouthpiece or face mask, and any other accessories mentioned in the manual. 2. Make sure that you are assembling the inhalator correctly according to the instructions provided in the manual. Pay attention to the orientation and alignment of the components. 3. If the nebulizer is not fitting properly, check if it is clean and free from any obstructions. Clean the nebulizer as instructed in the manual and ensure that it is dry before assembling. 4. Verify that the connections between the nebulizer, compressor, and other accessories are secure. Ensure that the connections are tight but not overly tightened to avoid damaging the components. 5. If you are still experiencing difficulties in assembling the inhalator, contact the manufacturer or authorized service center for assistance. They will be able to provide further guidance or arrange for repairs if necessary. By following these steps, you can troubleshoot and address any issues related to the assembly of the Medisana IN 520 inhalator.
If the nebulizer of the Medisana IN 520 inhalator is not filling with the prescribed inhalation solution, follow these steps: 1. Ensure that the nebulizer is properly assembled. Check if all the parts are securely connected and in the correct position. 2. Verify that the nebulizer is clean and free from any obstructions. Wash all parts of the nebulizer, including the atomizer head, mouthpiece, and nose piece, under running water. If necessary, place them in boiling water for a specified duration as mentioned in the manual. 3. Confirm that the required inhalation solution is poured into the nebulizer. Ensure that the solution is within the recommended fill quantity range specified in the manual. 4. Check if the air tube is properly attached to both ends of the nebulizer. Ensure that the air tube is not compressed, bent, dirty, or blocked. If needed, replace it with a new one. 5. Make sure that the nebulizer is completely assembled and that the colored atomizer head is correctly positioned and not blocked. 6. If the issue persists, contact the manufacturer or authorized service center for further assistance. They will be able to provide additional troubleshooting steps or arrange for repairs if necessary. By following these steps, you can address the issue of the nebulizer not filling with the prescribed inhalation solution for the Medisana IN 520 inhalator.
If you are experiencing discomfort or difficulty during inhalation with the Medisana IN 520 inhalator, follow these steps: 1. Ensure that you are using the correct accessories for inhalation. Use the mouthpiece or face mask as recommended by your doctor or healthcare professional. 2. Sit in an upright and relaxed position during inhalation. Avoid lying down or slouching, as this may restrict the airflow and affect the effectiveness of the treatment. 3. Breathe slowly and deeply through the mouth or nose, depending on the instructions provided by your doctor. Take gentle and controlled breaths to allow the medication to reach your airways effectively. 4. If you feel any discomfort or irritation during inhalation, stop the inhalation immediately and consult your doctor or healthcare professional. They can provide guidance on adjusting the inhalation technique or recommend alternative treatments if necessary. 5. After completing the prescribed inhalation time, turn off the inhalator and remove the mouthpiece or face mask. Clean and disinfect the accessories according to the instructions provided in the manual to maintain hygiene. Remember, the Medisana IN 520 inhalator is not a substitute for medical advice. If you have any concerns or persistent difficulties during inhalation, seek guidance from your healthcare provider.
To clean and disinfect the Medisana IN 520 inhalator and its accessories, follow these steps: 1. Before and after each use, turn the upper part of the nebulizer anticlockwise to open it and remove the atomizer head. Wash all parts of the nebulizer, mouthpiece, nose piece, and nasal shower under running water. You can also place them in boiling water for a specified duration. 2. Wash the masks and air tube with warm water. 3. Assemble the nebulizer parts again and connect the nebulizer to the air tube. 4. Switch on the device and leave it in use for 10-15 minutes. 5. Use only cold sterilization solutions according to the manufacturer's instructions. Do not boil or autoclave the masks and air tube. 6. Regularly check and replace the air filter after about 500 hours of use or one year. Remove the air filter and replace it with a new one. Do not attempt to clean the filter for reuse. 7. For maintenance and care, replace the nebulizer after a relatively long period of non-use or if it has deformations, cracks, or a blocked atomizer head. Use only the original nebulizer. By following these steps, you can effectively clean and disinfect the Medisana IN 520 inhalator and its accessories, ensuring proper hygiene and performance.
To use the nasal shower attachment for the Medisana IN 520 inhalator, follow these steps: 1. Remove the cover of the nasal shower attachment by turning it 90° in an anticlockwise direction. 2. Fill the container of the nasal shower attachment with the rinsing solution according to the instructions provided by the manufacturer. 3. Screw the cover back on by turning it in a clockwise direction. 4. Connect the nasal shower attachment to the air tube. The other end of the air tube should already be connected to the main device at position 3. 5. Place the nose piece of the nasal shower attachment onto one nostril and breathe through the nose. 6. Switch on the inhalator by turning the On/Off switch to the "I" position. 7. Guide your finger over the small opening on the lower part of the nasal shower attachment to begin the treatment. During use, breathe in and out slowly through the nose and tilt your head slightly to the opposite side of the affected nostril to allow the saline mist to penetrate deeply into your nostril. 8. You can pause or stop the nasal shower by removing your finger from the opening. By following these steps, you can effectively use the nasal shower attachment for the Medisana IN 520 inhalator to provide nasal irrigation.
Yes, the manual of the Medisana IN 520 is available in English .
Is your question not listed? Ask your question here
No results
Need help?
Do you have a question about the Medisana and is the answer not in the manual?
Question and answer
Number of questions: 0