Maytag MHW6630HW manual

Maytag MHW6630HW
8 · 4
PDF manual
 · 66 pages
English
manualMaytag MHW6630HW
51

Si les problèmes

suivants surviennent

Causes possibles Solution

Le code d’erreur s’affiche sur l’afficheur (pour les affichages à 2 et 3 caractères)

Une fois que tout problème éventuel a été résolu, toucher le bouton POWER (mise sous tension) pour effacer le code. Sélectionner à

nouveau et remettre le programme en marche.

“Sd” ou “Sud” (mousse

excessive) apparaît sur

l’afficheur

Il y a trop de mousse dans la laveuse.

La laveuse exécute une procédure de

réduction de la quantité de mousse.

Laisser la machine continuer. Utiliser uniquement un détergent

HEz. Toujours suivre les recommandations du fabricant de

détergent pour déterminer la quantité de détergent à utiliser.

La quantité de détergent doit aussi tenir compte de la charge à

laver. Les détergents identifiés HE ne sont pas tous identiques

et ne produisent pas tous la même quantité de mousse. Par

exemple, les détergents HE, naturels, organiques et faits

maison peuvent produire une plus grande quantité de mousse.

Si l’un de ces produits est utilisé et que le code d’erreur

“Sd” ou “Sud” s’affiche sur l’afficheur, l’utilisation d’un autre

détergent HE est conseillée.

Lo suivi de FL ou F8 suivi

de E1

ou

Lo suivi de FL ou F08

suivi de E01 (erreur

d’alimentation en eau)

apparaît sur l’afficheur

Vérifier que l’alimentation en eau est

adéquate.

L’appareil évacue l’eau pendant 8 minutes tandis que la porte

reste verrouillée. Le programme de drainage doit pouvoir se

terminer pour que les codes d’erreurs puissent être supprimés.

Une fois terminé, toucher une fois POWER (mise sous tension)

pour effacer le code. Toucher de nouveau le bouton POWER

(mise sous tension) pour redémarrer la laveuse. Si le code

réapparaît, faire un appel de service.

Les deux tuyaux doivent être fixés et l’eau doit pénétrer dans

la valve d’arrivée.

Les robinets d’eau chaude et d’eau froide doivent être ouverts

tous les deux.

Les tamis des valves d’arrivée d’eau de la laveuse sont peut-

être obstrués.

Éliminer toute déformation du tuyau d’arrivée.

Si utilisés, les raccords d’arrêt automatique et les tuyaux

doivent être installés correctement et en bon état de

fonctionnement.

Vérifier que les tuyaux d’arrivé d’eau

sont appropriés.

Utiliser uniquement les tuyaux d’arrivé d’eau recommandés

par le fabricant.

F9 suivi de E1

ou

F09 suivi de E01 (erreur

du système de pompe

de vidange) apparaît sur

l’afficheur

Inspecter le circuit de plomberie pour

vérifier que le tuyau de vidange est

correctement installé. Le tuyau de

vidange se prolonge dans le tuyau

rigide de rejet à l’égout au-delà de

4
1

2" (114mm).

Vérifier que le tuyau de vidange est correctement installé.

Vérifier que le tuyau d’évacuation n’est pas déformé, écrasé ou

obstrué.

Retirer toute obstruction du tuyau de vidange.

Utiliser la bride de retenue pour tuyau de vidange et la fixer

solidement au tuyau rigide de rejet à l’égout ou à la cuve.

Abaisser le tuyau de vidange si l’extrémité se trouve à plus de

96" (2,4m) au-dessus du plancher.

Détergent HE non utilisé ou utilisation

excessive de détergent HE.

Utiliser uniquement un détergent HE. Toujours mesurer le

détergent et suivre les instructions du fabricant en fonction de

la taille et du niveau de saleté de la charge.

F5 suivi de E2

ou

F05 suivi de E02 (la porte

ne se verrouille pas)

apparaît sur l’afficheur

La porte de la laveuse ne se verrouille

pas.

Toucher le bouton POWER (mise sous tension) pour annuler

le programme. Vérifier que la porte est parfaitement fermée

et verrouillée. Vérifier qu’aucun article dans le tambour de la

laveuse n’est susceptible d’empêcher la porte de se fermer

complètement.

“rL” (retirer la charge)

apparaît sur l’afficheur

Charge détectée dans le tambour

durant le programme Clean Washer

with affresh

®

(nettoyage de la laveuse

avec affresh).

Retirer les articles du tambour et redémarrer le programme

Clean Washer with affresh

®
.

DÉPANNAGE

Essayer d’abord les solutions suggérées ici ou visiter notre site Web au www.maytag.com/product_help
Au Canada, visiter le www.maytag.ca pour obtenir de l’aide et pour éviter une visite de service.

View the manual for the Maytag MHW6630HW here, for free. This manual comes under the category washing machines and has been rated by 4 people with an average of a 8. This manual is available in the following languages: English. Do you have a question about the Maytag MHW6630HW or do you need help? Ask your question here

Need help?

Do you have a question about the Maytag and is the answer not in the manual?

  • Receive updates on solutions
  • Get answers to your question

Question and answer

Number of questions: 53
C
Chad March 12, 2023

fabric softener is not draining, It is not getting drawn / sucked into the drum during the wash cycle. How do I fix this?

fabric softener is not draining, It is not getting drawn / sucked into the drum during the wash cycle.  How do I fix this?
zoom-in
View photo
1 comment
E
Emma of manua.lsDecember 18, 2023

To fix the problem of fabric softener not draining or being drawn into the drum during the wash cycle, you can try the following: 1. Make sure you are using the correct amount and type of fabric softener. 2. Clean the dispenser drawer and fabric softener compartment. 3. Check for any clogs or blockages in the fabric softener dispenser. 4. Ensure the washing machine is level and stable. 5. Run a cleaning cycle with hot water and vinegar. If the problem persists, please seek further assistance.

This answer is automatically generated
S
Scott HarrisMay 9, 2023

We have error code e1 f9…trying to access the filter…removed too if machine…and plastic control panel and front panel is loose…but door is locked due to stopping mid wash…machine has water in it…Cannot complete front panel removal due to locked door…we understand that we may have water flood out but need to unlock the door to disconnect from assembly and complete filter cleaning…

We have error code e1 f9…trying to access the filter…removed too if machine…and plastic control panel and front panel is loos...
zoom-in
View photo
1 comment
E
Emma of manua.lsDecember 18, 2023

The error code "e1 f9" on the Maytag MHW6630HW washing machine indicates a drain pump system error. Here are the steps to troubleshoot and resolve the issue: 1. Check the plumbing for correct drain hose installation. Ensure that the drain hose extends into the standpipe no farther than 41⁄2" (114 mm). 2. Inspect the drain hose for proper installation. Make sure it is not kinked, pinched, or blocked. Remove any clogs from the drain hose. 3. Use the drain hose form and securely attach it to the drainpipe or tub. 4. Lower the drain hose if the end is higher than 96" (2.4 m) above the floor. 5. Verify that you are using HE detergent and following the manufacturer's directions based on the load size and soil level.

This answer is automatically generated
E
EddieAugust 14, 2020

Is there anyway to bypass (or reset) the 3 second countdown in order to start the machine? I would like to press the start button and simply have the machine start without holding down the button and waiting for the countdown to end.

1 comment
B
Bernadine BellaJanuary 22, 2021

what does 5D error message mean

K
Keith NicholsonApril 6, 2021

how to determine the problem with the washer (MHW6630HW) that won't start. Can this be a rest problem?

D
Donna FerrierApril 17, 2021

How do you increase the sound of the Cycle Signal on a Maytag Frontload Washer "MHW6630HW2

How do you increase the sound of the Cycle Signal on a Maytag Frontload Washer "MHW6630HW2
zoom-in
View photo
2 comments
J
JT McConnellJuly 7, 2021

how do you download this manual?

C
Connie HowardOctober 14, 2021

How do you download this manual?

J
Jeff NielsenJune 20, 2021

washer is stuck in the on mode on door wont release open , how do i get the washer to drain and open door.

J
James oneilApril 25, 2022

2 Control board issues When I put the dial on any of the options the time alloted is very short.( 1:30) for a regular wash. Not sure how to reset the board? Also when wash is complete the washer does not turn off

M
Mae ShimizuFebruary 5, 2023

In the dark after the machine completely turns off from use, there is a faint light glow of the numbers and letter on the screen. Is this normal?

D
Donna FApril 29, 2024

Can the short cycle be set for a different time. I'm used to my previous Maytag and the short cycle was a little longer. Thx.

D
Donna FerrierApril 17, 2021

Which number in the "Cycle Signal" selection button on Maytag Frontload Washer MHW6630HW2 makes the loudest sound

Which number in the "Cycle Signal" selection button on Maytag Frontload Washer MHW6630HW2  makes the loudest sound
zoom-in
View photo

The Maytag MHW6630HW is a front-loading washing machine that comes with a capacity of 4.8 cubic feet. It features a stainless-steel drum that resists odors and offers durability for long-lasting use. The machine is equipped with an Internal Heater that ensures that the water is heated to the optimum temperature for cleaning the clothes. The washing machine has 12 wash cycles, including a Sanitize cycle that uses steam to remove up to 99.9% of household bacteria, ensuring that clothes remain hygienic. The Maytag MHW6630HW also has a Fresh Hold option that tumbles clothes periodically after the cycle ends to prevent them from getting stale. It features an additional rinse option that helps remove any remaining detergent from clothes, preventing skin irritation. The washing machine has a maximum spin speed of 1160RPM, which helps in faster drying of clothes. The machine comes with a delay-start feature that enables users to start the washing cycle at a later time, ensuring flexibility in usage. It has a control lock option that restricts its use for safety purposes. The Maytag MHW6630HW is Energy Star Certified, meaning that it is energy-efficient and helps users save on their electricity bills. In summary, the Maytag MHW6630HW is a reliable and efficient front-loading washing machine that offers various wash cycles and options, making it ideal for households of all sizes.

General
BrandMaytag
ModelMHW6630HW
Productwashing machine
EAN883049456966
LanguageEnglish
FiletypeUser manual (PDF), Installation Guide (PDF), Quickstart Guide (PDF), Energy label (PDF), Warranty information (PDF), Datasheet (PDF)

Can't find the answer to your question in the manual? You may find the answer to your question in the FAQs about the Maytag MHW6630HW below.

What temperature should I use for my laundry?

The washing label of your garment shows the recommended washing temperature.

Do I need to use an anti-scaling agent for my washing machine?

It is not necessary to use an anti-scaling agent. Scale deposits can be prevented by limiting washing at high temperatures and using the recommended amount of detergent per wash.

How do I prevent my washing machine from smelling?

Unpleasant odours can be avoided by occasionally washing at 60 degrees and using the recommended amount of detergent per wash.

Why is my washing machine not turning on?

Make sure the power cord is securely plugged into a grounded power outlet. Also, check if the circuit breaker has tripped and reset it if needed.

How do I properly load my laundry into the washing machine?

It's important to distribute the load evenly to avoid imbalance issues. Place the garments loosely, allowing enough space for them to move freely during the wash cycle.

What should I do if the water is not draining from the machine?

Check if the drain hose is clogged or if it is kinked, preventing proper water flow. Clear any obstructions and ensure the hose is unrestricted for effective drainage.

How can I troubleshoot excessive vibration during the spin cycle?

Ensure that your washing machine is level and stable on the floor. Adjust the leveling feet if necessary, and avoid overloading the machine, as it can cause imbalance and increased vibrations.

How can I resolve issues with bad odors coming from the washer?

Regular cleaning of the washing machine, including the drum and dispenser compartments, can help prevent unpleasant odors. Also, leave the door slightly ajar after each use to allow air circulation and minimize moisture buildup.

Is the manual of the Maytag MHW6630HW available in English?

Yes, the manual of the Maytag MHW6630HW is available in English .

Is your question not listed? Ask your question here

No results