Maytag MHW6630HW manual

Maytag MHW6630HW
8 · 4
PDF manual
 · 66 pages
English
manualMaytag MHW6630HW
20

If you experience Possible Causes Solution

Error Code Appears in Display (for 2- and 3-digit displays)

Once any possible issues are corrected, touch POWER once to clear the code. Reselect and restart the cycle.

“Sd” or “Sud”

(excess suds) appears

in display

Excessive suds in washer. Washer is

running a suds-reduction routine.

Allow the washer to continue. Use only HE detergent. Always

follow the detergent manufacturer’s instructions to determine

the amount of detergent to use and base detergent quantity

on load size. Not all detergents labeled as High Efciency are

identical in formulation and their ability to reduce suds. For

example, natural, organic, or homemade HE detergents may

generate a high level of suds. If you use one of these and see

an “Sd” or “Sud” error code appear in the display, consider

using a different HE detergent.

Lo followed by FL or F8

followed by E1

or

Lo followed by FL or

F08 followed by E01

(water supply error)

appears in display

Check for proper water supply. Unit will drain for 8 minutes while door remains locked. The

drain cycle must be allowed to complete or the error code

cannot reset. When complete, touch POWER once to clear the

code. Then touch POWER again to restart washer.

If code appears again, call for service.

Both hoses must be attached and have water owing to the

inlet valve.

Both hot and cold water faucets must be ON.

Inlet valve screens on washer may be clogged.

Remove any kinks in the inlet hose.

If used, auto shut-off connectors and hoses must be properly

installed and in working order.

Check for proper inlet hoses. Use only manufacturer’s recommended inlet hoses.

F9 followed by E1

or

F09 followed by E01

(drain pump system

error) appears in display

Check plumbing for correct drain

hose installation. Drain hose extends

into standpipe farther than 4

1

2"

(114 mm).

Check drain hose for proper installation.

Make sure the drain hose is not kinked, pinched, or blocked.

Remove any clogs from drain hose.

Use drain hose form and securely attach to drainpipe or tub.

Lower drain hose if the end is higher than 96" (2.4 m) above

the oor.

Not using HE detergent or using too

much HE detergent.

Use only HE detergent. Always measure detergent and follow

manufacturer’s directions based on load size and soil level.

F5 followed by E2

or

F05 followed by E02

(door will not lock)

appears in display

Washer door not locking. Touch POWER to cancel the cycle. Check that the door is

closed completely and latching. Check for items in the washer

drum that may be keeping the door from closing completely.

“rL” (remove load)

appears in display

Load detected in drum during Clean

Washer with affresh

®

cycle.

Remove items from washer drum and restart Clean Washer

with affresh

®

cycle.

TROUBLESHOOTING

First try the solutions suggested here or visit our website at www.maytag.com/product_help
In Canada www.maytag.ca for assistance and to possibly avoid a service call.

View the manual for the Maytag MHW6630HW here, for free. This manual comes under the category washing machines and has been rated by 4 people with an average of a 8. This manual is available in the following languages: English. Do you have a question about the Maytag MHW6630HW or do you need help? Ask your question here

Need help?

Do you have a question about the Maytag and is the answer not in the manual?

  • Receive updates on solutions
  • Get answers to your question

Question and answer

Number of questions: 53
C
Chad March 12, 2023

fabric softener is not draining, It is not getting drawn / sucked into the drum during the wash cycle. How do I fix this?

fabric softener is not draining, It is not getting drawn / sucked into the drum during the wash cycle.  How do I fix this?
zoom-in
View photo
1 comment
E
Emma of manua.lsDecember 18, 2023

To fix the problem of fabric softener not draining or being drawn into the drum during the wash cycle, you can try the following: 1. Make sure you are using the correct amount and type of fabric softener. 2. Clean the dispenser drawer and fabric softener compartment. 3. Check for any clogs or blockages in the fabric softener dispenser. 4. Ensure the washing machine is level and stable. 5. Run a cleaning cycle with hot water and vinegar. If the problem persists, please seek further assistance.

This answer is automatically generated
S
Scott HarrisMay 9, 2023

We have error code e1 f9…trying to access the filter…removed too if machine…and plastic control panel and front panel is loose…but door is locked due to stopping mid wash…machine has water in it…Cannot complete front panel removal due to locked door…we understand that we may have water flood out but need to unlock the door to disconnect from assembly and complete filter cleaning…

We have error code e1 f9…trying to access the filter…removed too if machine…and plastic control panel and front panel is loos...
zoom-in
View photo
1 comment
E
Emma of manua.lsDecember 18, 2023

The error code "e1 f9" on the Maytag MHW6630HW washing machine indicates a drain pump system error. Here are the steps to troubleshoot and resolve the issue: 1. Check the plumbing for correct drain hose installation. Ensure that the drain hose extends into the standpipe no farther than 41⁄2" (114 mm). 2. Inspect the drain hose for proper installation. Make sure it is not kinked, pinched, or blocked. Remove any clogs from the drain hose. 3. Use the drain hose form and securely attach it to the drainpipe or tub. 4. Lower the drain hose if the end is higher than 96" (2.4 m) above the floor. 5. Verify that you are using HE detergent and following the manufacturer's directions based on the load size and soil level.

This answer is automatically generated
E
EddieAugust 14, 2020

Is there anyway to bypass (or reset) the 3 second countdown in order to start the machine? I would like to press the start button and simply have the machine start without holding down the button and waiting for the countdown to end.

1 comment
B
Bernadine BellaJanuary 22, 2021

what does 5D error message mean

K
Keith NicholsonApril 6, 2021

how to determine the problem with the washer (MHW6630HW) that won't start. Can this be a rest problem?

D
Donna FerrierApril 17, 2021

How do you increase the sound of the Cycle Signal on a Maytag Frontload Washer "MHW6630HW2

How do you increase the sound of the Cycle Signal on a Maytag Frontload Washer "MHW6630HW2
zoom-in
View photo
2 comments
J
JT McConnellJuly 7, 2021

how do you download this manual?

C
Connie HowardOctober 14, 2021

How do you download this manual?

J
Jeff NielsenJune 20, 2021

washer is stuck in the on mode on door wont release open , how do i get the washer to drain and open door.

J
James oneilApril 25, 2022

2 Control board issues When I put the dial on any of the options the time alloted is very short.( 1:30) for a regular wash. Not sure how to reset the board? Also when wash is complete the washer does not turn off

M
Mae ShimizuFebruary 5, 2023

In the dark after the machine completely turns off from use, there is a faint light glow of the numbers and letter on the screen. Is this normal?

D
Donna FApril 29, 2024

Can the short cycle be set for a different time. I'm used to my previous Maytag and the short cycle was a little longer. Thx.

D
Donna FerrierApril 17, 2021

Which number in the "Cycle Signal" selection button on Maytag Frontload Washer MHW6630HW2 makes the loudest sound

Which number in the "Cycle Signal" selection button on Maytag Frontload Washer MHW6630HW2  makes the loudest sound
zoom-in
View photo

The Maytag MHW6630HW is a front-loading washing machine that comes with a capacity of 4.8 cubic feet. It features a stainless-steel drum that resists odors and offers durability for long-lasting use. The machine is equipped with an Internal Heater that ensures that the water is heated to the optimum temperature for cleaning the clothes. The washing machine has 12 wash cycles, including a Sanitize cycle that uses steam to remove up to 99.9% of household bacteria, ensuring that clothes remain hygienic. The Maytag MHW6630HW also has a Fresh Hold option that tumbles clothes periodically after the cycle ends to prevent them from getting stale. It features an additional rinse option that helps remove any remaining detergent from clothes, preventing skin irritation. The washing machine has a maximum spin speed of 1160RPM, which helps in faster drying of clothes. The machine comes with a delay-start feature that enables users to start the washing cycle at a later time, ensuring flexibility in usage. It has a control lock option that restricts its use for safety purposes. The Maytag MHW6630HW is Energy Star Certified, meaning that it is energy-efficient and helps users save on their electricity bills. In summary, the Maytag MHW6630HW is a reliable and efficient front-loading washing machine that offers various wash cycles and options, making it ideal for households of all sizes.

General
BrandMaytag
ModelMHW6630HW
Productwashing machine
EAN883049456966
LanguageEnglish
FiletypeUser manual (PDF), Installation Guide (PDF), Quickstart Guide (PDF), Energy label (PDF), Warranty information (PDF), Datasheet (PDF)

Can't find the answer to your question in the manual? You may find the answer to your question in the FAQs about the Maytag MHW6630HW below.

What temperature should I use for my laundry?

The washing label of your garment shows the recommended washing temperature.

Do I need to use an anti-scaling agent for my washing machine?

It is not necessary to use an anti-scaling agent. Scale deposits can be prevented by limiting washing at high temperatures and using the recommended amount of detergent per wash.

How do I prevent my washing machine from smelling?

Unpleasant odours can be avoided by occasionally washing at 60 degrees and using the recommended amount of detergent per wash.

Why is my washing machine not turning on?

Make sure the power cord is securely plugged into a grounded power outlet. Also, check if the circuit breaker has tripped and reset it if needed.

How do I properly load my laundry into the washing machine?

It's important to distribute the load evenly to avoid imbalance issues. Place the garments loosely, allowing enough space for them to move freely during the wash cycle.

What should I do if the water is not draining from the machine?

Check if the drain hose is clogged or if it is kinked, preventing proper water flow. Clear any obstructions and ensure the hose is unrestricted for effective drainage.

How can I troubleshoot excessive vibration during the spin cycle?

Ensure that your washing machine is level and stable on the floor. Adjust the leveling feet if necessary, and avoid overloading the machine, as it can cause imbalance and increased vibrations.

How can I resolve issues with bad odors coming from the washer?

Regular cleaning of the washing machine, including the drum and dispenser compartments, can help prevent unpleasant odors. Also, leave the door slightly ajar after each use to allow air circulation and minimize moisture buildup.

Is the manual of the Maytag MHW6630HW available in English?

Yes, the manual of the Maytag MHW6630HW is available in English .

Is your question not listed? Ask your question here

No results