Maytag MHW5630HW manual

Maytag MHW5630HW
8.7 · 5
PDF manual
 · 66 pages
English
manualMaytag MHW5630HW
51

Si les problèmes

suivants surviennent

Causes possibles Solution

Le code d’erreur s’affiche sur l’afficheur (pour les affichages à 2 et 3 caractères)

Une fois que tout problème éventuel a été résolu, toucher le bouton POWER (mise sous tension) pour effacer le code. Sélectionner à

nouveau et remettre le programme en marche.

“Sd” ou “Sud” (mousse

excessive) apparaît sur

l’afficheur

Il y a trop de mousse dans la laveuse.

La laveuse exécute une procédure de

réduction de la quantité de mousse.

Laisser la machine continuer. Utiliser uniquement un détergent

HEz. Toujours suivre les recommandations du fabricant de

détergent pour déterminer la quantité de détergent à utiliser.

La quantité de détergent doit aussi tenir compte de la charge à

laver. Les détergents identifiés HE ne sont pas tous identiques

et ne produisent pas tous la même quantité de mousse. Par

exemple, les détergents HE, naturels, organiques et faits

maison peuvent produire une plus grande quantité de mousse.

Si l’un de ces produits est utilisé et que le code d’erreur

“Sd” ou “Sud” s’affiche sur l’afficheur, l’utilisation d’un autre

détergent HE est conseillée.

Lo suivi de FL ou F8 suivi

de E1

ou

Lo suivi de FL ou F08

suivi de E01 (erreur

d’alimentation en eau)

apparaît sur l’afficheur

Vérifier que l’alimentation en eau est

adéquate.

L’appareil évacue l’eau pendant 8 minutes tandis que la porte

reste verrouillée. Le programme de drainage doit pouvoir se

terminer pour que les codes d’erreurs puissent être supprimés.

Une fois terminé, toucher une fois POWER (mise sous tension)

pour effacer le code. Toucher de nouveau le bouton POWER

(mise sous tension) pour redémarrer la laveuse. Si le code

réapparaît, faire un appel de service.

Les deux tuyaux doivent être fixés et l’eau doit pénétrer dans

la valve d’arrivée.

Les robinets d’eau chaude et d’eau froide doivent être ouverts

tous les deux.

Les tamis des valves d’arrivée d’eau de la laveuse sont peut-

être obstrués.

Éliminer toute déformation du tuyau d’arrivée.

Si utilisés, les raccords d’arrêt automatique et les tuyaux

doivent être installés correctement et en bon état de

fonctionnement.

Vérifier que les tuyaux d’arrivé d’eau

sont appropriés.

Utiliser uniquement les tuyaux d’arrivé d’eau recommandés

par le fabricant.

F9 suivi de E1

ou

F09 suivi de E01 (erreur

du système de pompe

de vidange) apparaît sur

l’afficheur

Inspecter le circuit de plomberie pour

vérifier que le tuyau de vidange est

correctement installé. Le tuyau de

vidange se prolonge dans le tuyau

rigide de rejet à l’égout au-delà de

4
1

2" (114mm).

Vérifier que le tuyau de vidange est correctement installé.

Vérifier que le tuyau d’évacuation n’est pas déformé, écrasé ou

obstrué.

Retirer toute obstruction du tuyau de vidange.

Utiliser la bride de retenue pour tuyau de vidange et la fixer

solidement au tuyau rigide de rejet à l’égout ou à la cuve.

Abaisser le tuyau de vidange si l’extrémité se trouve à plus de

96" (2,4m) au-dessus du plancher.

Détergent HE non utilisé ou utilisation

excessive de détergent HE.

Utiliser uniquement un détergent HE. Toujours mesurer le

détergent et suivre les instructions du fabricant en fonction de

la taille et du niveau de saleté de la charge.

F5 suivi de E2

ou

F05 suivi de E02 (la porte

ne se verrouille pas)

apparaît sur l’afficheur

La porte de la laveuse ne se verrouille

pas.

Toucher le bouton POWER (mise sous tension) pour annuler

le programme. Vérifier que la porte est parfaitement fermée

et verrouillée. Vérifier qu’aucun article dans le tambour de la

laveuse n’est susceptible d’empêcher la porte de se fermer

complètement.

“rL” (retirer la charge)

apparaît sur l’afficheur

Charge détectée dans le tambour

durant le programme Clean Washer

with affresh

®

(nettoyage de la laveuse

avec affresh).

Retirer les articles du tambour et redémarrer le programme

Clean Washer with affresh

®
.

DÉPANNAGE

Essayer d’abord les solutions suggérées ici ou visiter notre site Web au www.maytag.com/product_help
Au Canada, visiter le www.maytag.ca pour obtenir de l’aide et pour éviter une visite de service.

View the manual for the Maytag MHW5630HW here, for free. This manual comes under the category washing machines and has been rated by 5 people with an average of a 8.7. This manual is available in the following languages: English. Do you have a question about the Maytag MHW5630HW or do you need help? Ask your question here

Need help?

Do you have a question about the Maytag and is the answer not in the manual?

  • Receive updates on solutions
  • Get answers to your question

Question and answer

Number of questions: 61
V
Vivianne Côté September 23, 2022

Hi, my washing machine is stuck on 1hr41min. How can I change it back to what it was before. Thank you

Hi, my washing machine is stuck on 1hr41min. How can I change it back to what it was before. Thank you
zoom-in
View photo
This message has been automatically translated
L
Lucretia JohnstonFebruary 11, 2024

Does my Maytag MHW5630HW3 have the optimal Dispense Drawer so i can load up to 14.3 oz of my liquid HE detergent and if so is this the tab I’m supposed to lift up. I’m not sure how to use this if i even can add it the tab thing supposed to be up add do i even have it in the dispenser right

Does my Maytag MHW5630HW3 have the optimal  Dispense Drawer so i can load up to 14.3 oz of my liquid HE detergent and if so i...
zoom-in
View photo
1 comment
E
Emma of manua.lsFebruary 19, 2024

Yes, the Maytag MHW5630HW washing machine has the Optimal Dispense Drawer. You can use this drawer to load up to 14.3 oz of liquid HE detergent. To use the dispenser drawer, follow the instructions in the manual.

This answer is automatically generated
A
Annette appelSeptember 30, 2022

Clothes are very wet at end of cycle. I even tried using the spin and drain afterwards. any ideas on what is wrong?

2 comments
E
Emma of manua.lsDecember 18, 2023

If the clothes are very wet at the end of the cycle, there are a few possible reasons for this issue: 1. Overloading: Make sure you are not overloading the washing machine. Overloading can prevent proper water drainage and spinning, resulting in wet clothes. Follow the load size recommendations provided. 2. Improper spin speed: Check the spin speed setting for the cycle you are using. Ensure that the spin speed is set to an appropriate level for the type of load you are washing. Higher spin speeds help remove more water from the clothes. 3. Drainage issues: Check if the washing machine is properly draining the water. Make sure the drain hose is not kinked or clogged. Additionally, ensure that the drain filter is clean and free from debris. 4. Unbalanced load: An unbalanced load can prevent the washing machine from spinning properly. If the load is unevenly distributed, redistribute the clothes evenly in the drum and restart the cycle. 5. Incorrect cycle selection: Ensure that you are selecting the appropriate cycle for the type of clothes you are washing. Some cycles may have lower spin speeds or shorter spin times, resulting in wetter clothes.

This answer is automatically generated
M
M cabralJune 3, 2023

Same what do I do

J
Joseph MarbaughDecember 5, 2022

Does this model have a filter, and where is it?

Does this model have a filter, and where is it?
zoom-in
View photo
1 comment
E
Emma of manua.lsDecember 25, 2023

Yes, the Maytag MHW5630HW model has a filter.

This answer is automatically generated
M
Melissa FraedrichMay 28, 2024

My maytag washer has nothing showing up on the screen but the power supply is good. I put it through a self cleaning cycle and then it just stopped working. Any quick suggestions to get it back up and running?

R
Ronald KuhbanderJune 29, 2021

How do I change the wash time. It started at 55 minutes when new. Now it says 1 hour and 30 minutes. What changed it . how do I get it back

D
Diane RoselliDecember 2, 2022

How to I know if I have an optimal dispenser drawer? And if so, how do I know when detergent is depleted?

S
SandyDecember 9, 2022

Does my washer have a volume for the end of cycle ringer, its so low I can’t tell when load is ended. Model mhw5630hw

K
karenDecember 22, 2022

Does maytag front loader modelMHW5630HW3 have a filter that needs to be removed and cleaned out. If so where is it located at?

1 comment
K
Kathy M MackApril 13, 2024

@karen

The Maytag MHW5630HW is a washing machine that offers efficient and reliable performance. With its sleek and modern design, this washing machine seamlessly integrates into any laundry room. The MHW5630HW features a generous drum capacity, allowing for large loads of laundry to be cleaned at once. The machine also offers a variety of wash cycles and options, accommodating different fabrics and clothing types. Equipped with advanced technology, the MHW5630HW delivers powerful and thorough cleaning results. Its high spin speed ensures effective water extraction, reducing overall drying time. The machine also features a variety of wash modes, including delicates, heavy-duty, and quick wash, providing flexibility for different laundry needs. In terms of energy efficiency, the MHW5630HW is Energy Star certified, utilizing less water and energy during each wash cycle. This not only helps to reduce utility bills but also contributes to a more sustainable environment. Operating the MHW5630HW is simple and user-friendly, with a clear and intuitive control panel. The machine also includes useful features such as a delay start option, allowing users to set the washing machine to start at a specific time. Overall, the Maytag MHW5630HW is a reliable and efficient washing machine that offers a range of features to suit different laundry needs. With its durability and advanced technology, this washing machine is built to last and provide excellent performance over time.

General
BrandMaytag
ModelMHW5630HW
Productwashing machine
EAN883049456959
LanguageEnglish
FiletypeUser manual (PDF), Installation Guide (PDF), Quickstart Guide (PDF), Datasheet (PDF), Warranty information (PDF), Energy label (PDF)

Can't find the answer to your question in the manual? You may find the answer to your question in the FAQs about the Maytag MHW5630HW below.

What temperature should I use for my laundry?

The washing label of your garment shows the recommended washing temperature.

Do I need to use an anti-scaling agent for my washing machine?

It is not necessary to use an anti-scaling agent. Scale deposits can be prevented by limiting washing at high temperatures and using the recommended amount of detergent per wash.

How do I prevent my washing machine from smelling?

Unpleasant odours can be avoided by occasionally washing at 60 degrees and using the recommended amount of detergent per wash.

Why is my washing machine not turning on?

Ensure that the power cord is properly plugged into a functioning electrical outlet. Check if the circuit breaker or fuse related to the washing machine is tripped or blown. Make sure the door is securely closed, as the machine will not start if the door is ajar.

How can I resolve excessive vibration during the wash cycle?

Confirm that the washing machine is level by adjusting the leveling feet underneath. Avoid overloading the machine, as it can lead to imbalance. Ensure that all four shipping bolts have been removed from the back of the machine, as their presence can cause excessive vibration.

My clothes are not coming out clean, what could be the issue?

Check that you have selected an appropriate wash cycle, as different cycles address various levels of soil and fabric types. Properly distribute the clothes inside the drum for efficient cleaning. Avoid overloading the machine, as it can hinder the washing action and prevent adequate soil removal.

Why is the cycle time taking longer than usual?

Examine if any additional options or features, such as extra rinse or extended spin, have been selected, as they can prolong the cycle duration. Verify that the water supply is sufficient and the water pressure is within the recommended range. A delay may also occur if the machine detects an unbalanced load and attempts to redistribute it for effective spinning.

How can I address unpleasant odors coming from the washing machine?

Regularly clean the machine by running a Washer Cleaning cycle with an appropriate cleaner. After each wash, leave the door slightly ajar to allow air circulation and prevent the growth of mold and mildew. Additionally, wipe down the gasket and the inside of the door regularly to remove any residue or moisture buildup.

Is the manual of the Maytag MHW5630HW available in English?

Yes, the manual of the Maytag MHW5630HW is available in English .

Is your question not listed? Ask your question here

No results