2
ENGLISH (Orig inal instruct ions)
SPECIFICATIONS Model RP0910 RP1 1 10C
Collet chuck cap acity 8 mm or 1/4" 8 mm or 1/4"
Plunge capacity 0 - 57 mm 0 - 57 mm
No load speed ( min
-1
) 27,000 8,000 - 24,000
Overall height 260 mm 260 mm
Net weight 3.3 kg 3.4 kg
Safety class /II /II
• Due to our conti nuing progr a m of research and d evelopment, the specificatio ns herein are subj ect to change without notice.
• S pecifications may dif fer from country to country .
• Weight acc ording to EPT A-Procedure 01/2003
END201-7
Symbols The following show the symbols used for the equipment.
Be sure that y ou understand their meaning before use.
・ Read instruction manual.
・ DOUBLE INSULA TION
・ Only for EU co untries
Do not dispose of elec tric equipment
together with hou sehold waste material!
In observance of the Europea n
Direct ive, o n Waste Elect ric and
Electronic Equipment and it s
implementation in accord ance with
national law , electric equipment th at
have reached the end of their life must
be collected sep arately and returned to
an environmentally compatible
recycling facility .
ENE010-1
Intended use
The tool is intended for flush trimming and profiling of
wood, plastic and similar materials.
ENF002-2
Power supply
The tool should be connected only to a pow er supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply . They
are double-insulated and can, therefore, also be used
from socket s without earth wire.
ENG905-1
Noise
The typical A-weighted noise level determined ac cording
to EN60745:
Model RP0910
Sound pressure level (L
pA
) : 83 dB (A)
Sound power level (L
WA
) : 94 dB (A)
Uncertainty (K) : 3 dB (A)
Model RP1 110C
Sound pressure level (L
pA
) : 81 dB (A)
Sound power level (L
WA
) : 92 dB (A)
Uncertainty (K) : 3 dB (A)
Wear ear protection
ENG900-1
Vibration
The vibration to tal value (tri-axial vector sum)
determined according to EN60745:
Model RP0910
Work mode : cuttig groov es in MDF
Vibration emi ssion (a
h
) : 8.0 m/ s
2
Uncertainty (K) : 1.5 m/s
2
Model RP1 110C
Work mode : cuttig groov es in MDF
Vibration emi ssion (a
h
) : 5.0 m/ s
2
Uncertainty (K) : 1.5 m/s
2
ENG901-1
•
The declared vibration emission v alue has been
measured in accordance with the standard te st
method and may be used fo r comparing one tool
with another .
• The declared vibration emission value may also be
used in a preliminary assessment of exposure.
W ARNING :
•
The vibration emissi on during actual use of the power
tool can differ from the d eclared em ission value
depending on the ways in w hich the tool i s used.
• Be sure to identi fy safety measur es to protect the
operator that are based on an estimation of
exposure in the actua l conditions of use (taki ng
account of all p arts of the operating cy cle such as
the times when th e tool is switched of f and when it
is running idle in addition to the trigger time).
Need help?
Do you have a question about the Makita and is the answer not in the manual?
Question and answer
Number of questions: 0