Luxor LVNB40DL275BMS manual

Luxor LVNB40DL275BMS
6.9 · 2
PDF manual
 · 76 pages
English
manualLuxor LVNB40DL275BMS
English - 46 -
Safety Information
Don’t operate your TV in extreme ambient
conditions as this may cause damage to your TV.

CAUTION

RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK DO
NOT REMOVE COVER (OR BACK).
NO USER-SERVICEABLE PARTS INSIDE. REFER
SERVICING TO QUALIFIED SERVICE PERSONNEL.
Note: Follow the on screen instructions for operating the
related features.
In extreme weather (storms, lightning) and long
inactivity periods (going on holiday) disconnect
the TV set from the mains. The mains plug is
used to disconnect TV set from the mains and
therefore it must remain readily operable.
This sign is present wherever there is very
important information on operation and
maintenance of the appliance in the literature
accompanying it.

IMPORTANT - Please read these

instructions fully before installing or

operating

WARNING: Never let people (including
children) with reduced physical, sensory or
mental capabilities or lack of experience and / or
knowledge use electrical devices unsupervised.
For ventilation purposes, leave a free space of at
least 10 cm all around the set.
•Do not block ventilation holes.
•Do not place the TV on sloping or unstable surfaces,
the TV may tip over.
Use this device in moderate climates.
The power cord plug should be easily accessible. Do
not place the TV, furniture, etc. on the power cord.
A damaged power cord/plug can cause re or give
you an electric shock. Handle the power cord by the
plug, do not unplug the TV by pulling the power cord.
Never touch the power cord/plug with wet hands
as this could cause a short circuit or electric shock.
Never make a knot in the power cord or tie it with
other cords. When damaged it must be replaced,
this should only be done by qualied personnel.
•Do not use this TV in a humid or damp environment.
Do not expose the TV to liquids. In case the cabinet
contacts any liquids unplug the TV immediately
and have it checked by qualied personnel before
operating it any further.
•Do not expose the TV to direct sunlight,
open ames or place it near intense heat
sources such as electric heaters.
Listening in excessive volumes from earphones and
headphones may cause hearing loss.
Ensure that no open ame sources, such as lit
candles, are placed on top of the TV.
To prevent injuries, this TV must be securely
attached to a wall by carefully following the
instructions (if the option is available).
Occasionally, a few non-active pixels may appear
on the screen as a xed blue, green or red point.
Please note that this does not affect the performance
of your product. Take care not to scratch the screen
with ngernails or other hard objects.
Before cleaning, unplug the TV from the wall socket.
Only use a soft, dry cloth while cleaning.
Warning
Serious injury or death risk
Risk of electric shock
Dangerous voltage risk
Caution
Injury or property damage risk
Important
Operating the system correctly
Notice
Additional notes marked
Markings on the Product
The following symbols are used on the product as
a marker for restrictions and precautions and safety
instructions. Each explanation shall be considered
where the product bears related marking only. Note
such information for security reasons.
Class II Equipment: This appliance is
designed in such a way that it does not require
a safety connection to electrical earth.
Class II Equipment With Functional
Earthing: This appliance is designed in such
a way that it does not require a safety
connection to electrical earth, the earth connection is
used for functional purposes.
Protective Earth Connection: The marked
terminal is intended for connection of the
protective earthing conductor associated with
the supply wiring.
Hazardous Live Terminal: The marked
terminal(s) is/are hazardous live under normal
operating conditions.
Caution, See Operating Instructions: The
marked area(s) contain(s) user replaceable
coin or button cell batteries.
Class 1 Laser Product:
This product contains Class
1 laser source that is safe
under reasonably foreseeable
conditions of operation.
i
CLASS 1
LASER PRODUCT

Manual

View the manual for the Luxor LVNB40DL275BMS here, for free. This manual comes under the category televisions and has been rated by 2 people with an average of a 6.9. This manual is available in the following languages: English. Do you have a question about the Luxor LVNB40DL275BMS or do you need help? Ask your question here

Need help?

Do you have a question about the Luxor and is the answer not in the manual?

  • Receive updates on solutions
  • Get answers to your question

Question and answer

Number of questions: 0

Luxor LVNB40DL275BMS specifications

Below you will find the product specifications and the manual specifications of the Luxor LVNB40DL275BMS.

The Luxor LVNB40DL275BMS television is a model that offers a screen size of 40 inches. It is equipped with built-in speakers for audio output. The television is designed with a black finish and has a resolution of 1920 x 1080 pixels. It has multiple connectivity options, including HDMI and USB ports for external device connections. The television also features a slim design for sleek aesthetics in a viewing space. Additionally, it comes with a remote control for easy operation from a distance. The Luxor LVNB40DL275BMS television is suitable for various viewing needs, from watching movies to playing video games. It provides a standard viewing experience with its screen size and resolution. It is manufactured with quality materials to ensure durability and performance over time. Overall, the Luxor LVNB40DL275BMS television is a reliable option for those seeking a basic viewing solution in their home.

General
BrandLuxor
ModelLVNB40DL275BMS
Producttelevision
LanguageEnglish
FiletypeUser manual (PDF)

Frequently Asked Questions

Can't find the answer to your question in the manual? You may find the answer to your question in the FAQs about the Luxor LVNB40DL275BMS below.

What's the best viewing distance for my Luxor television?

The ideal viewing distance for your Luxor television depends on the screen size. As a rule of thumb you can assume that approximately 2.4 times the screen diagonal is the ideal viewing distance.

My television has no signal anymore, now what?

If your television has no signal, you can check the following: - Check whether your television is set to the correct source. - Check if your TV receiver is properly connected via the HDMI or SCART input.

What screen dimensions does my television have?

The size of your television is usually expressed in inches, 1 inch is 2.54 centimetres. The size is the diagonal size of your television, so you measure the screen from bottom left to top right.

What is HDMI?

HDMI stands for High-Definition Multimedia Interface. An HDMI cable is used to transport audio and video signals between devices.

Can bluetooth devices of different brands be connected to each other?

Yes, bluetooth is a universal method that allows different devices equipped with bluetooth to connect to each other.

How can I check the average power consumption of the Luxor LVNB40DL275BMS television?

To check the average power consumption of the Luxor LVNB40DL275BMS television, follow these steps: 1. Look for the "On mode average power consumption" in the manual. This value represents the average power consumed by the television when it is turned on. In the case of the Luxor LVNB40DL275BMS, the value is 48 Watts. Please note that the average power consumption may vary depending on the settings and usage of the television. It is always a good idea to refer to the manual for the most accurate information regarding power consumption. Remember to consider energy-saving features and adjust the settings of the television accordingly to optimize power consumption and reduce energy usage.

How do I change the display resolution on the Luxor LVNB40DL275BMS television?

To change the display resolution on the Luxor LVNB40DL275BMS television, follow these steps: 1. Refer to the manual for a list of supported display resolutions. The manual provides a table that lists various resolutions and their corresponding frequencies. 2. Use the remote control to access the television's settings menu. Look for the "Display" or "Picture" settings option. 3. Navigate to the display resolution settings within the menu. The exact location may vary depending on the television's user interface. 4. Select the desired display resolution from the available options. Choose a resolution that is supported by the television, as indicated in the manual. 5. Confirm the selection and exit the settings menu. The television will apply the new display resolution. Please note that changing the display resolution may affect the clarity and quality of the image. If you experience any issues or have difficulty selecting a suitable resolution, refer to the troubleshooting section of the manual or contact the manufacturer for further assistance.

How do I operate the Luxor LVNB40DL275BMS television using the remote control?

To operate the Luxor LVNB40DL275BMS television using the remote control, follow these steps: 1. Ensure that the remote control has batteries inserted. Open the battery compartment on the back of the remote control and insert two AAA batteries, making sure to observe the correct polarity. 2. Point the remote control towards the television and press the power button or the "Standby" button to turn on the TV from standby mode. 3. To change the volume, use the up and down buttons on the remote control. Press the up button to increase the volume and the down button to decrease the volume. 4. To change the channel, press the middle button on the remote control. This will display an information banner on the screen. Scroll through the stored channels by pressing the up or down buttons. 5. To change the source, press the middle button twice. This will display the source list on the screen. Scroll through the available sources by pressing the up or down buttons. 6. To access the main menu, press the menu button on the remote control. Use the directional buttons to navigate the menu tabs and press OK to enter a menu. Use the directional buttons again to select or set an item. Press the return/back or menu button to exit a menu. 7. To switch to different input sources, press the source button on the remote control consecutively. Please note that these instructions are specific to the Luxor LVNB40DL275BMS television and may vary for other models.

How can I reduce the standby power consumption of the Luxor LVNB40DL275BMS television?

To reduce the standby power consumption of the Luxor LVNB40DL275BMS television, follow these steps: 1. Access the television's settings menu using the remote control. Look for the "Energy Saving" or "Power Saving" option. 2. Navigate to the energy-saving settings within the menu. The exact location may vary depending on the television's user interface. 3. Select the desired energy-saving mode from the available options. Choose a mode that suits your preferences and reduces power consumption during standby. 4. Adjust the backlight settings if available. Lowering the backlight level can further reduce power consumption. 5. Consider enabling the automatic power-down feature. This feature automatically turns off the television after a specified period of inactivity, helping to conserve energy. 6. When the television is not in use, switch it off or disconnect it from the mains plug to minimize standby power consumption. Please note that the specific options and menu names may vary depending on the television model. Refer to the user manual for detailed instructions tailored to the Luxor LVNB40DL275BMS television.

What should I do if the Luxor LVNB40DL275BMS television does not respond to the remote control?

If the Luxor LVNB40DL275BMS television does not respond to the remote control, you can try the following steps: 1. Check the batteries in the remote control. Open the battery compartment on the back of the remote control and ensure that the batteries are inserted correctly and have enough power. Replace the batteries if necessary. 2. Make sure there are no obstructions between the remote control and the television. Remove any objects that may be blocking the signal. 3. Point the remote control directly at the television and press the buttons firmly. Sometimes, a weak or partial button press may not register. 4. If the television still does not respond, try resetting the remote control. Remove the batteries from the remote control and press each button a few times to discharge any residual power. Then, reinsert the batteries and try using the remote control again. 5. If none of the above steps work, try using the control buttons on the television itself. These buttons are usually located on the side or bottom of the television. Use the directional buttons to navigate the menu and the volume buttons to adjust the volume. If the issue persists, refer to the troubleshooting section of the manual or contact the manufacturer for further assistance.

Is the manual of the Luxor LVNB40DL275BMS available in English?

Yes, the manual of the Luxor LVNB40DL275BMS is available in English .

Is your question not listed? Ask your question here

No results