Lego Traveller

Lego Traveller manual

(1)
  • Operating Instructions
    Traveller Portable Projection Screen by Draper
    Copyright © 2010 Draper Inc. Form Traveller_Inst10 Print ed in U.S.A.
    Setting Up the Screen
    Collapsing the Screen
    Generally reverse procedures used for screen setup.
    Caution: Do not let go of the screen bail when collapsing the screen;
    damage to screen could result. Slowly allow screen to roll into the case.
    Rotate legs (attached to bottom) until they are perpendicular to screen
    case (see Fig. 1).
    Troubleshooting
    Screen will not fully extend:
    Make sure the screen surface is not “catching” on anything. Make sure case
    lid is fully open. Make sure roller is properly seated.
    Screen will not close:
    Check roller to make sure nothing is interfering with operation.
    Screen tips forward or backward:
    Make sure legs are perpendicular to screen case. If they are, screen may be
    located on too severe an incline.
    Case Latches will not open:
    Press gently down on screen case just above each latch while opening.
    Case Latches will not close:
    Press gently down on screen case just above each latch while closing.
    Carrying strap will not rotate out of the way so case will open:
    Loosen or remove carrying strap altogether (see below).
    Figure 2 (side view)
    Caution
    Read instructions through completely before proceeding, and save for
    future reference.
    Nothing should be fastened to screen case or viewing surface.
    Do not write on viewing surface.
    Do not let go of the screen handle when collapsing the screen; damage
    to the screen could result. Slowly allow the screen to roll into the case.
    Do not use solvents or abrasives for cleaning.
    Beware of pinching hands and fi ngers when adjusting upright.
    NOTE: Screen has been thoroughly inspected and tested at factory and
    found to be operating properly prior to shipment.
    Figure 3
    ®
    Place upright in upright stand, located inside case and centered on back
    of screen. Adjust upright according to necessary screen height (see
    Fig. 3).
    Grasp screen bail and pull up in steady motion to raise screen. Hook bail
    onto upright gooseneck (see Fig. 4). Adjust upright again if necessary.
    Figure 4
    Rotate carrying strap so it does not interfere with opening case. You can
    also remove the carrying strap by sliding down then off (see Fig. 2).
    Figure 1
    Unlatch and open screen case.
    Remove upright from clips in case behind screen.
    If you encounter any diffi culties installing or ser vic ing your Traveller, call your
    dealer or Draper, Inc., in Spiceland, Indiana, 765/987-7999; or fax 765/987-7142.
    Audience
    Telescoping
    Upright
    Screen case
    Lid
    Legs
    Case latches
    Caution:
    Beware of pinching
    hands and fi ngers when
    adjusting upright.
    Caution:
    Beware of pinch-
    ing hands and
    ngers when
    adjusting upright.
Lego Traveller

Need help?

Number of questions: 0

Do you have a question about the Lego Traveller or do you need help? Ask your question here. Provide a clear and comprehensive description of the issue and your question. The more detail you provide for your issue and question, the easier it will be for other Lego Traveller owners to properly answer your question.

View the manual for the Lego Traveller here, for free. This manual comes under the category Toys and has been rated by 1 people with an average of a 8.6. This manual is available in the following languages: English. Do you have a question about the Lego Traveller or do you need help? Ask your question here