Kubota SCL1000 manual

Kubota SCL1000
8.2 · 4
PDF manual
 · 82 pages
English
manualKubota SCL1000
Section 5: Maintenance & Lubrication
SCL1000 Stand-on Compact Loader 725-137MK6/30/21
63

Table of Contents

Every 500 Hours

For your own safety and to assure the long life of your
machine, the following maintenance should be
performed every 500 hours.
Change the Hydraulic Oil
!

DANGER

To avoid serious injury or death:
When it is required that the machine be elevated off the ground
to perform maintenance, make certain the machine is being
hoisted up by a capable hoist and straps. Make sure to use
solid, non-concrete blocks or jack stands that are sturdy and
are capable of bearing the machine’s weight. Make sure the
engine is shut off.
Refer to Figure 5-41:
1. Hoist the machine onto solid, non concrete supports.
2. Remove the belly access panel (#1) by removing six
5/16"-18 x 5/8" GR5 flange bolts (#2) with a ratchet
and a 1/2" socket.
3. Remove hydraulic oil plug (#3) using a 5/16" allen
wrench and drain the oil into a bucket or an oil catch.
4. When all the hydraulic oil has been drained, re-install
hydraulic oil plug (#3).
5. Re-attach belly access panel (#1) to the machine’s
frame with six 5/16"-18 x 5/8" GR5 flange bolts (#2).
Tighten to correct torque.
Refer to Figure 5-42:
6. Open the machine’s hood. See “Opening & Closing
the Hood” on page 48.
7. Remove hydraulic cap lock (#5) by removing 3/8-16 X
3/4 GR5 flanged bolt (#6). Remove dust and dirt from
hydraulic oil tank (#4) and hydraulic oil tank cap (#3).
8. Remove hydraulic oil tank cap (#3) and add hydraulic
oil up to the middle of oil level sight (#1). It is
important for the protection of the hydraulic system to
only use the recommended hydraulic oil.
See “Recommended Fluids” on page 69.
9. Replace oil tank cap (#3) then replace hydraulic cap
lock (#5) with 3/8-16 X 3/4 GR5 flanged bolt (#6).
10. Turn the machine on and allow machine to idle for 1
minute before operating any hydraulics to allow the
hydraulic oil to be filtered before reaching any
contamination-sensitive areas.
11. Operate the hydraulic controls for five minutes, then
shut the machine down again.
12. Check the oil level. Oil level should be at or near the
middle of oil sight (#7). Repeat steps 6-10 to add
hydraulic oil as needed.
13. Properly dispose of old hydraulic oil.
NOTE: There are 2 belly access panels under the
machine. For this procedure, remove the front most
access panel.
Belly Access Panel & Oil Plug
Figure 5-41
Hydraulic Oil Level Check
Figure 5-42
IMPORTANT: Do not over-fill the hydraulic oil tank
over its specified limit. Use only the recommended
hydraulic oil. See “Recommended Fluids” on page
69. Using the wrong hydraulic oil can result in
damage to the hydraulic system.
2
73745
3
1
5
3
6
2
1
4
73743

View the manual for the Kubota SCL1000 here, for free. This manual comes under the category lawnmowers and has been rated by 4 people with an average of a 8.2. This manual is available in the following languages: English. Do you have a question about the Kubota SCL1000 or do you need help? Ask your question here

Need help?

Do you have a question about the Kubota and is the answer not in the manual?

  • Receive updates on solutions
  • Get answers to your question

Question and answer

Number of questions: 1
I
IsraelOctober 20, 2023

How do i input number code when i turn on machine it has acode i just cant seem to find numbers or how to get them in

How do i input number code when i turn on machine it has acode i just cant seem to find numbers or how to get them in
zoom-in
View photo

The Kubota SCL1000 is a lawnmower designed for efficient mowing of large areas. It features a powerful engine that provides reliable performance and ensures smooth operation. The lawnmower is equipped with a wide cutting deck, allowing for quick and efficient mowing, reducing the time required to complete the task. The SCL1000 is built with premium materials, ensuring durability and longevity. Its sturdy construction enables it to withstand tough conditions and heavy usage without compromising its performance. The lawnmower is designed for comfort, with adjustable seating positions and ergonomic controls, allowing the operator to maintain a comfortable position during operation. The Kubota SCL1000 is equipped with advanced technological features that contribute to its efficiency. It incorporates a cutting-edge cutting system that ensures a consistent and clean cut, leaving a well-manicured lawn behind. The lawnmower also includes safety features such as automatic shut-off and blade engagement, ensuring the operator's safety during operation. In summary, the Kubota SCL1000 is a high-quality lawnmower that offers powerful performance, durability, and efficiency. Its advanced features and sturdy construction make it an excellent choice for mowing large areas, providing a reliable and comfortable experience for the operator.

General
BrandKubota
ModelSCL1000
Productlawnmower
LanguageEnglish
FiletypeUser manual (PDF)

Can't find the answer to your question in the manual? You may find the answer to your question in the FAQs about the Kubota SCL1000 below.

How short should I cut the grass?

When the grass is longer than 4.5cm, the grass should be cut. The ideal length is between 3 and 4.5cm.

How often should I cut the grass?

In the spring, the grass should be cut every week, while in the summer once every two weeks is sufficient.

Can I mow the lawn when the grass is wet?

You can, but the result is better in dry weather. When the grass is wet, grass clumps can easily form and clog the mower.

Why won't my Kubota SCL1000 lawnmower start?

Check if the fuel tank is filled with gasoline, the ignition switch is turned on, and the engine control lever is set to the correct position.

How do I adjust the cutting height on my Kubota SCL1000 lawnmower?

Locate the cutting height adjustment lever on the deck of the lawnmower and move it to the desired cutting height position.

What should I do if my Kubota SCL1000 lawnmower is not cutting the grass evenly?

Ensure that the mower blades are sharp and properly installed. If the issue persists, consider adjusting the deck level or inspecting the grass discharge chute for any blockages.

What could be causing excessive vibration in my Kubota SCL1000 lawnmower?

Check if the cutting blades are balanced and securely fastened. If they are damaged or bent, they may need to be replaced.

How do I clean the air filter on my Kubota SCL1000 lawnmower?

Locate the air filter housing, remove the cover, and take out the air filter. Clean the filter using compressed air or gently wash it with mild soap and warm water. Allow it to dry completely before reinstalling.

Is the manual of the Kubota SCL1000 available in English?

Yes, the manual of the Kubota SCL1000 is available in English .

Is your question not listed? Ask your question here

No results