Kubota SCL1000 manual

Kubota SCL1000
8.2 · 4
PDF manual
 · 82 pages
English
manualKubota SCL1000
Section 3: Operating
SCL1000 Stand-on Compact Loader 725-137MK 6/30/21
36

Table of Contents

Safe Operating Practices

It is absolutely essential that no one operates the
machine unless they have read, fully understood, and are
totally familiar with the Operator’s Manual. It is imperative
that the Operator comply with the safety instructions and
practices and always pay attention to the danger, warning
and caution alerts. Failure to comply with these
instructions and practices may result in injury or death.
!

DANGER

To avoid serious injury or death:

Do not operate this machine under the influence of alcohol

or drugs, or if the Operator is ill or excessively tired.

Check clearances when driving under objects such as

doorways or large branches. Be aware of all overhead
utility and electrical lines as well as having all underground
lines marked if digging or trenching will take place.

Never operate the machine in the vicinity of explosive

gases. Always keep exhaust from machine away from any
combustible material.

Do not operate the machine in an enclosed area without

proper ventilation.

Always operate the machine in adequate light that will

allow the Operator to identify any holes or other hazards.

Make sure all guards and shields are installed and in good

working condition when operating the machine.

Keep bystanders and animals away while the machine and/

or attachment is in use. A person or animal can be crushed,
ran-over, entangled or suffer other serious injury. Stop the
machine if anyone enters the work area.

Never exceed the machine’s rated lift capacity. Exceeding

the rated lift capacity can result in equipment damage, roll
over or other hazards.

Use caution when raising loads and make sure not to

overload the bucket/attachment. Maintain level when
raising, as materials can fall back onto the Operator.

Whenever the machine is in motion, keep the bucket/

attachment as close to the ground as possible. Never change
directions when the bucket/attachment is in the raised
position. If you must move the machine with the bucket/
attachment raised, take care to travel at low speeds in order
to maintain control of the machine at all times.

Pay attention to weather conditions. Rain or snow can

make working conditions difficult and unsafe. Pay
particular attention to lightning in your area. Do not
operate the machine if lightning is seen, seek shelter.
!

WARNING

To avoid serious injury or death:

Only use this machine for its intended purposes.

Do not operate machine on loose rock or gravel.

Always avoid working on an incline as the machine can

become unstable and rollover.

Read the attachment Operator’s Manual before operating.

Never use the machine to move material or perform work

that exceeds the capacity of the bucket or attachment.

Transport loads as low to the ground as possible to help

prevent losing control of or tipping the machine. Practicing
this caution will also prevent loads from shifting and falling.

Do not alter the engine governor to over-speed machine.

Never leave the machine running and unattended. Shut the

machine down using shut down procedures provided in this
manual before leaving the operator platform.

Do not jerk the drive handle or the loader arm/tilt lever.

Use the grip bars for leverage to help in operating in a
steady motion.

Only operate this machine in areas that you can maneuver

the machine safely.

Use only Kubota approved attachments with this machine.

Using other brand attachments may create an unsafe
operating environment and/or damage the machine.

Check hitch fit-up frequently. An improper fit-up can cause

the attachment to come loose from the loader hitch plate
and fall.

Never carry riders on the machine or its attachments.

Riders can obstruct the Operator’s view, interfere with
control of the machine, be pinched by moving components,
become entangled in rotating components, be struck by
objects, be thrown or fall from the equipment, etc.
!

CAUTION

To avoid minor or moderate injury: Keep hands on the
machine’s control handles or grip bars when in operation.
Make sure the pin cover is in place. When the pin cover is in
place it will help keep hand from being in an area where it can
be pinched while raising loader arms. See Figure 3-33.
IMPORTANT: Never scoop or grade areas while the
tilt cylinder is fully extended. Extremely heavy loads
apply excessive force to the tilt cylinder and can
cause damage.
IMPORTANT: Avoid hitting attachments against
rocks or similar solid material, which can damage
the attachment or machine.
IMPORTANT: Never fully extend cylinders to
perform an operation. Working while cylinders are
fully extended can cause damage from excessive
force.
IMPORTANT: Never use an attachment in a way it
is not intended for. Refer to the attachments
Operator’s manual.

View the manual for the Kubota SCL1000 here, for free. This manual comes under the category lawnmowers and has been rated by 4 people with an average of a 8.2. This manual is available in the following languages: English. Do you have a question about the Kubota SCL1000 or do you need help? Ask your question here

Need help?

Do you have a question about the Kubota and is the answer not in the manual?

  • Receive updates on solutions
  • Get answers to your question

Question and answer

Number of questions: 1
I
IsraelOctober 20, 2023

How do i input number code when i turn on machine it has acode i just cant seem to find numbers or how to get them in

How do i input number code when i turn on machine it has acode i just cant seem to find numbers or how to get them in
zoom-in
View photo

The Kubota SCL1000 is a lawnmower designed for efficient mowing of large areas. It features a powerful engine that provides reliable performance and ensures smooth operation. The lawnmower is equipped with a wide cutting deck, allowing for quick and efficient mowing, reducing the time required to complete the task. The SCL1000 is built with premium materials, ensuring durability and longevity. Its sturdy construction enables it to withstand tough conditions and heavy usage without compromising its performance. The lawnmower is designed for comfort, with adjustable seating positions and ergonomic controls, allowing the operator to maintain a comfortable position during operation. The Kubota SCL1000 is equipped with advanced technological features that contribute to its efficiency. It incorporates a cutting-edge cutting system that ensures a consistent and clean cut, leaving a well-manicured lawn behind. The lawnmower also includes safety features such as automatic shut-off and blade engagement, ensuring the operator's safety during operation. In summary, the Kubota SCL1000 is a high-quality lawnmower that offers powerful performance, durability, and efficiency. Its advanced features and sturdy construction make it an excellent choice for mowing large areas, providing a reliable and comfortable experience for the operator.

General
BrandKubota
ModelSCL1000
Productlawnmower
LanguageEnglish
FiletypeUser manual (PDF)

Can't find the answer to your question in the manual? You may find the answer to your question in the FAQs about the Kubota SCL1000 below.

How short should I cut the grass?

When the grass is longer than 4.5cm, the grass should be cut. The ideal length is between 3 and 4.5cm.

How often should I cut the grass?

In the spring, the grass should be cut every week, while in the summer once every two weeks is sufficient.

Can I mow the lawn when the grass is wet?

You can, but the result is better in dry weather. When the grass is wet, grass clumps can easily form and clog the mower.

Why won't my Kubota SCL1000 lawnmower start?

Check if the fuel tank is filled with gasoline, the ignition switch is turned on, and the engine control lever is set to the correct position.

How do I adjust the cutting height on my Kubota SCL1000 lawnmower?

Locate the cutting height adjustment lever on the deck of the lawnmower and move it to the desired cutting height position.

What should I do if my Kubota SCL1000 lawnmower is not cutting the grass evenly?

Ensure that the mower blades are sharp and properly installed. If the issue persists, consider adjusting the deck level or inspecting the grass discharge chute for any blockages.

What could be causing excessive vibration in my Kubota SCL1000 lawnmower?

Check if the cutting blades are balanced and securely fastened. If they are damaged or bent, they may need to be replaced.

How do I clean the air filter on my Kubota SCL1000 lawnmower?

Locate the air filter housing, remove the cover, and take out the air filter. Clean the filter using compressed air or gently wash it with mild soap and warm water. Allow it to dry completely before reinstalling.

Is the manual of the Kubota SCL1000 available in English?

Yes, the manual of the Kubota SCL1000 is available in English .

Is your question not listed? Ask your question here

No results