Kubota SCL1000 manual

Kubota SCL1000
8.2 · 4
PDF manual
 · 82 pages
English
manualKubota SCL1000
Section 3: Operating
SCL1000 Stand-on Compact Loader 725-137MK 6/30/21
18

Table of Contents

Operator Platform Adjustment

Refer to Figure 3-2:
The operator platform can be adjusted for heavier or
lighter operators to ensure that the operator presence
control functions properly.
1. Lift operator platform (#1) to access rubber bumper
assembly (#3).
2. Loosen flange nuts (#2) enough to adjust rubber
bumper assembly (#3).
3. Adjust rubber bumper assembly to desired location
by sliding it forward or back.
4. Tighten flange nuts (#2) to correct torque.
Operator Platform Adjustment
Figure 3-2

Starting The Engine

!

DANGER

To avoid serious injury or death:
Do not operate the machine in an enclosed area without
proper ventilation.
!

WARNING

To avoid serious injury or death:

Always start the engine from the operator's platform. Do

not start the engine while standing next to the machine.
NOTE: The rubber bumper assembly adjusts to
allow more or less “suspension” on the operating
platform. Moving the rubber bumpers towards the
front of the machine makes the operator platform
more springy, moving them towards the back of the
machine makes the operator platform more firm.
Typically, for lighter operators, the rubber bumper
assembly should be adjusted towards the front of
the machine and towards the back for heavier
operators.
2
3
2
1

Before starting engine, be sure no one is near the machine.

The Operator should not depend solely on the warning

lamps, but should always perform the operating checklist.
See “Operating Checklist” on page 17.
Perform the following steps to start the engine.
1. Set the throttle lever to low throttle.
2. Flip power switch to the on position.
3. A start up screen will appear on the monitor. It will
ask for your passcode. Enter your passcode using
the buttons on the control monitor.
4. When correct passcode has been entered, you will
advance to a new screen. Proceed as follows.
Under normal conditions press the middle button
on the monitor to start the engine.
Under cold conditions press the button under the
glow plug lamp. The glow plug lamp will then turn
green. Wait for the green glow plug lamp to turn off.
Press middle button to start the machine. Let the
engine warm up after start-up for approximately 5
minutes under no load conditions. If the hydraulic
fluid temperature is too low, the operations or the
function of the pilot controls will be affected. Do not
operate the machine under full load before the
engine has warmed up.

Starting With An Auxiliary Battery

Refer to Figure 3-3:
!

WARNING

To avoid serious injury or death:

Do not smoke and keep sparks and flames away. Battery

gases can explode.

Do not start the engine with an auxiliary battery if machine

battery is frozen.
Observe the following guidelines when starting with an
auxiliary battery.
1. Bring the helping machine with the same battery
voltage as near as possible to the machine.
IMPORTANT: Do not use starting fluid or ether.
IMPORTANT: In order not to overload the battery
and starter, avoid start-ups of more than 10
seconds. When the engine does not start in 10
seconds, wait 20 seconds or more, before trying to
start again. If the battery is dead and must be
connected to another battery with jumper cable, be
sure to use a 12V battery. Never use 24V batteries.
NOTE: A passcode will be provided by your dealer
at the time of purchase. You can then change the
passcode whenever desired.

View the manual for the Kubota SCL1000 here, for free. This manual comes under the category lawnmowers and has been rated by 4 people with an average of a 8.2. This manual is available in the following languages: English. Do you have a question about the Kubota SCL1000 or do you need help? Ask your question here

Need help?

Do you have a question about the Kubota and is the answer not in the manual?

  • Receive updates on solutions
  • Get answers to your question

Question and answer

Number of questions: 1
I
IsraelOctober 20, 2023

How do i input number code when i turn on machine it has acode i just cant seem to find numbers or how to get them in

How do i input number code when i turn on machine it has acode i just cant seem to find numbers or how to get them in
zoom-in
View photo

The Kubota SCL1000 is a lawnmower designed for efficient mowing of large areas. It features a powerful engine that provides reliable performance and ensures smooth operation. The lawnmower is equipped with a wide cutting deck, allowing for quick and efficient mowing, reducing the time required to complete the task. The SCL1000 is built with premium materials, ensuring durability and longevity. Its sturdy construction enables it to withstand tough conditions and heavy usage without compromising its performance. The lawnmower is designed for comfort, with adjustable seating positions and ergonomic controls, allowing the operator to maintain a comfortable position during operation. The Kubota SCL1000 is equipped with advanced technological features that contribute to its efficiency. It incorporates a cutting-edge cutting system that ensures a consistent and clean cut, leaving a well-manicured lawn behind. The lawnmower also includes safety features such as automatic shut-off and blade engagement, ensuring the operator's safety during operation. In summary, the Kubota SCL1000 is a high-quality lawnmower that offers powerful performance, durability, and efficiency. Its advanced features and sturdy construction make it an excellent choice for mowing large areas, providing a reliable and comfortable experience for the operator.

General
BrandKubota
ModelSCL1000
Productlawnmower
LanguageEnglish
FiletypeUser manual (PDF)

Can't find the answer to your question in the manual? You may find the answer to your question in the FAQs about the Kubota SCL1000 below.

How short should I cut the grass?

When the grass is longer than 4.5cm, the grass should be cut. The ideal length is between 3 and 4.5cm.

How often should I cut the grass?

In the spring, the grass should be cut every week, while in the summer once every two weeks is sufficient.

Can I mow the lawn when the grass is wet?

You can, but the result is better in dry weather. When the grass is wet, grass clumps can easily form and clog the mower.

Why won't my Kubota SCL1000 lawnmower start?

Check if the fuel tank is filled with gasoline, the ignition switch is turned on, and the engine control lever is set to the correct position.

How do I adjust the cutting height on my Kubota SCL1000 lawnmower?

Locate the cutting height adjustment lever on the deck of the lawnmower and move it to the desired cutting height position.

What should I do if my Kubota SCL1000 lawnmower is not cutting the grass evenly?

Ensure that the mower blades are sharp and properly installed. If the issue persists, consider adjusting the deck level or inspecting the grass discharge chute for any blockages.

What could be causing excessive vibration in my Kubota SCL1000 lawnmower?

Check if the cutting blades are balanced and securely fastened. If they are damaged or bent, they may need to be replaced.

How do I clean the air filter on my Kubota SCL1000 lawnmower?

Locate the air filter housing, remove the cover, and take out the air filter. Clean the filter using compressed air or gently wash it with mild soap and warm water. Allow it to dry completely before reinstalling.

Is the manual of the Kubota SCL1000 available in English?

Yes, the manual of the Kubota SCL1000 is available in English .

Is your question not listed? Ask your question here

No results