Krups XP5000 manual

Krups XP5000
7.4 · 1
PDF manual
 · 22 pages
English
manualKrups XP5000
6
XP7000/XP5000/XP3500/XP2500/XP1000 Owner’s Manual

Controls and Functions

Front Panel

1
POWER switch and indicator
Press this to turn the power on or off. The POWER/
STANDBY indicator lights up in green when the power
is ON. If the amplifier has been set to STANDBY mode,
the indicator is lit in orange.
2
TEMP indicator
Lights up red if the heat sink temperature exceeds 85°C
(185°F).
3
PROTECTION indicator
When the protection system is active, the PROTECT
indicator light up in red and the speakers are automati-
cally disconnected from the amplifier’s outputs. The
protection system activates in the following situations:
When the amplifier is turned on
The protection system activates for approximately
three seconds when the amplifier is turned on. After
three seconds, the protection system deactivates auto-
matically and the amplifier is ready for normal opera-
tion.
If a DC voltage is detected at the amplifier’s
outputs
XP7000/5000: Power shut down and the indicator is
not lit.
XP3500/2500/1000: The protection system is active.
Once the DC voltage problem is corrected, the protec-
tion system deactivates automatically and the ampli-
fier is ready for normal operation.
If the amplifier overheats
When overheating occurs, the PROTECT/MUTE
indicator lights. You should immediately turn off the
amplifier and allow it time to cool down. See the Pre-
cautions section of this Owner’s Manual for ways to
prevent the amplifier from overheating.
4
CLIP indicator
Lights up red when the output signal distortion on the
corresponding channel rises above 1% — indicating
that “clipping” has occurred bacause the signal level is
too high.
5
SIGNAL indicator
Lights up green when the corresponding channel’s out-
put level exceeds 2 Vrms (equivalent to 1/2 W into an 8
load, or 1 W into a 4
load).
6
Volume control knobs
Each control knob adjusts the volume of the corre-
sponding channel, in 31 steps from -
dB to 0 dB.
* If you wish to lock in the knob settings, you can
fasten the supplied security cover over the
knobs so that the settings will not be disturbed.
How to install the security cover
(1) Use the supplied hex wrench to remove the four
attachment screws from the amplifier.
(2) Adjust the security cover to the position of screw
holes. Fasten it into place using the same screws.
7
Air intakes
The amplifier uses forced-air cooling. The cooling fans
draw air in from the front and exhaust it through the
rear. Please be sure that you do not block the air intakes
or exhaust vents.
* The fans do not come on at initial power-on, but
will switch on automatically when the temperature
of the heat sink rises above 50°C (122°F). The fan
speed will then vary automatically as the tempera-
ture changes.
* The illustration shows model XP7000.
176
2
37
4
5
Front Rear
Air
exhaust
Air
intake

View the manual for the Krups XP5000 here, for free. This manual comes under the category coffee makers and has been rated by 1 people with an average of a 7.4. This manual is available in the following languages: English. Do you have a question about the Krups XP5000 or do you need help? Ask your question here

Need help?

Do you have a question about the Krups and is the answer not in the manual?

  • Receive updates on solutions
  • Get answers to your question

Question and answer

Number of questions: 0

The Krups XP5000 is a coffee maker designed to brew coffee using ground coffee beans. It features a built-in grinder that allows users to grind the beans fresh before each brew. The machine has a programmable timer, so users can set it to start brewing at a specific time. The XP5000 also has a steam wand for frothing milk to make cappuccinos and lattes. The water reservoir of the Krups XP5000 has a capacity of 1.5 liters, allowing for multiple cups to be brewed before needing a refill. The machine is equipped with a heating element that ensures the water reaches the optimal temperature for brewing. The XP5000 has a stainless steel construction, which provides a sleek appearance and durability. Additionally, the Krups XP5000 has a removable drip tray and filter holder for easy cleaning. The machine also features a descaling program to help maintain its performance over time. The XP5000 is designed to be user-friendly, with intuitive controls for selecting brew settings and adjusting the grinder.

General
BrandKrups
ModelXP5000
Productcoffee maker
LanguageEnglish
FiletypeUser manual (PDF)

Can't find the answer to your question in the manual? You may find the answer to your question in the FAQs about the Krups XP5000 below.

How often should I descale my coffee maker?

How often a coffee machine needs to be descaled depends on how often it is used and the hardness of the water. If hard water is used it is recommended to descale once a month, if soft water is used once a quarter is sufficient.

What is the best way to descale my coffee maker?

To descale the coffee maker, it is recommended to use a liquid descaling agent which is labelled as suitable for coffee machines.

What is espresso?

Espresso is a small amount of concentrated coffee.

How long can I keep coffee beans?

The best-before date can be found on the packaging of the coffee beans. This best-before date applies as long as the bag is closed.

What is the best way to store coffee?

It is recommended to store coffee in an airtight and clean container.

What does the grind say about the taste of the coffee?

How the coffee beans are ground strongly influences the taste of the coffee. If the coffee beans are very finely ground you will have a stronger taste and if the grind is coarser you will have a milder taste.

How do I operate the controls and functions of the Krups XP5000 coffee maker?

To operate the controls and functions of the Krups XP5000 coffee maker, follow these steps: 1. Ensure the coffee maker is plugged in and turned on. 2. Fill the water tank with fresh water and the coffee bean container with your desired coffee beans. 3. Press the power button to start the machine. 4. Use the control panel to select your desired coffee type, such as espresso or cappuccino. 5. Adjust the settings for coffee strength and cup size using the buttons on the control panel. 6. Press the start button to begin the brewing process. 7. Wait for the coffee maker to finish brewing, then enjoy your freshly brewed coffee. These steps will help you effectively operate the controls and functions of the Krups XP5000 coffee maker.

What should I do if the front panel of the Krups XP5000 coffee maker is not responding?

If the front panel of the Krups XP5000 coffee maker is not responding, follow these steps: 1. Check the power cord connection to ensure it is securely plugged into a working outlet. 2. Verify that the power switch is turned on and the coffee maker is receiving power. 3. Inspect the front panel for any visible damage or debris that may be affecting its functionality. 4. Try unplugging the coffee maker for a few minutes and then plugging it back in to reset the system. 5. If the issue persists, contact Krups customer support for further assistance.

Is the manual of the Krups XP5000 available in English?

Yes, the manual of the Krups XP5000 is available in English .

Is your question not listed? Ask your question here

No results