Korg SoundLink DRS 1212 I/O manual

Korg SoundLink DRS 1212 I/O
7.5 · 1
PDF manual
 · 58 pages
English
manualKorg SoundLink DRS 1212 I/O
Installation
Korg 1212 I/O 3
English
Hold the 1212 I/O by its edges
Did we already mention that the 1212 I/O uses a whole bunch of delicate
electronic components? Well, OK, so we’ve said it again. To avoid
damaging those lovely little silicon jewels,
always hold the 1212 I/O by the
edges of the card,
or by the metal jack panel (where the connectors are).
Don’t touch the electronic parts, the PCI connector pins, or any of the traces
on the board (those little silvery paths that run between the components).
There, we’re done nagging now.

Analog levels: +4 or -10

The 1212 I/O’s analog inputs and outputs can be configured for use with
either +4 dBu or -10 dBV signal levels, to allow clean interfacing with a
wide variety of equipment. You can even set the input and output levels
independently, if desired, so that you can record at -10 and play back at +4,
or vice versa.
The 1212 I/O ships from the factory configured for -10 input and output. If
you will be working with -10 levels, then you can jump ahead to the next
section, “Installing the 1212 I/O card in your computer,” on page 5. If you
need to switch either inputs or outputs to operate at +4, read on.
Setting the analog levels
The nominal analog signal levels are set by several
jumpers
on the card’s
circuit board. A jumper is a small black connector which fits over a pair of
metal pins mounted on the board. The jumper makes an electrical
connection between the pins, just as if you were to solder a wire between
them. Unlike a wire, however, jumpers can be easily installed and
removed. The diagram below shows what they look like:
Jumpers, installed and removed
There are six jumpers on the 1212 I/O circuit board; each one is labeled
with a small “JP” (for “jumper”) followed by a number. The upper group of
four jumpers, labeled JP1 through JP4, set the input level; the lower group
of two, labeled JP5 and JP6, set the output level. The locations of the
jumpers are shown in the diagram below.
Jumper Removed (+4 dBu) Jumper Installed (-10 dBV)

Manual

View the manual for the Korg SoundLink DRS 1212 I/O here, for free. This manual comes under the category hi-fi systems and has been rated by 1 people with an average of a 7.5. This manual is available in the following languages: English. Do you have a question about the Korg SoundLink DRS 1212 I/O or do you need help? Ask your question here

Index

Need help?

Do you have a question about the Korg and is the answer not in the manual?

  • Receive updates on solutions
  • Get answers to your question

Question and answer

Number of questions: 1
D
Davide VecchiOctober 25, 2020

E' compatibile con macOS 10.14.6

Korg SoundLink DRS 1212 I/O specifications

Below you will find the product specifications and the manual specifications of the Korg SoundLink DRS 1212 I/O.

General
BrandKorg
ModelSoundLink DRS 1212 I/O
Producthi-fi system
LanguageEnglish
FiletypeUser manual (PDF)

Frequently Asked Questions

Can't find the answer to your question in the manual? You may find the answer to your question in the FAQs about the Korg SoundLink DRS 1212 I/O below.

When is my volume too loud?

A volume above 80 decibels can be harmful to hearing. When the volume exceeds 120 decibels, direct damage can even occur. The chance of hearing damage depends on the listening frequency and duration.

Can bluetooth devices of different brands be connected to each other?

Yes, bluetooth is a universal method that allows different devices equipped with bluetooth to connect to each other.

What is bluetooth?

Bluetooth is a way of exchanging data wirelessly between electronic devices via radio waves. The distance between the two devices that exchange data can in most cases be no more than ten metres.

What is HDMI?

HDMI stands for High-Definition Multimedia Interface. An HDMI cable is used to transport audio and video signals between devices.

How can I best clean my hi-fi system?

A slightly damp cleaning cloth or soft, dust-free cloth works best to remove fingerprints. Dust in hard-to-reach places is best removed with compressed air.

Wat is Dolby Atmos?

Dolby Atmos is a technology that ensures that the sound is reflected from the ceiling to where you are listening. This makes it possible to create a 5.1 effect with only 1 speaker.

Is the manual of the Korg SoundLink DRS 1212 I/O available in English?

Yes, the manual of the Korg SoundLink DRS 1212 I/O is available in English .

Is your question not listed? Ask your question here

No results