Kingston Technology ValueRAM KVR1333D3S8R9S manual

Kingston Technology ValueRAM KVR1333D3S8R9S
7.5 · 1
PDF manual
 · 2 pages
manualKingston Technology ValueRAM KVR1333D3S8R9S

Memory Module Specification

Document No. VALUERAM0846-001.A00


1GB 128M x 72-Bit PC3-10600

CL9 Registered w/Parity 240-Pin DIMM

Page 1
This document describes ValueRAM's 128M x 72-bit 1GB (1024MB) DDR3-1333MHz CL9 SDRAM (Synchronous
DRAM) registered w/parity, (Intel
Compatibility Tested), single-rank memory module, based on nine 128M x 8-bit
DDR3-1333MHz FBGA components. The SPD is programmed to JEDEC standard latency 1333MHz timing of 9-9-9 at
1.5V. This 240-pin DIMM uses gold contact fingers and requires +1.5V. The electrical and mechanical specifications
are as follows:
JEDEC standard 1.5V ± 0.075V Power Supply
VDDQ = 1.5V ± 0.075V
667MHz fCK for 1333Mb/sec/pin
8 independent internal bank
Programmable CAS Latency: 6,7,8,9,10
Programmable Additive Latency: 0, CL - 2, or CL - 1 clock
Programmable CAS Write Latency(CWL) = 7(DDR3-1333)
8-bit pre-fetch
Burst Length: 8 (Interleave without any limit, sequential with starting address “000” only), 4 with tCCD = 4
which does not allow seamless read or write [either on the fly using A12 or MRS]
Bi-directional Differential Data Strobe
Internal(self) calibration : Internal self calibration through ZQ pin (RZQ : 240 ohm ± 1%)
On Die Termination using ODT pin
On-DIMM thermal sensor (Grade B)
Average Refresh Period 7.8us at lower then TCASE 85°C, 3.9us at 85°C < TCASE . 95°C
Asynchronous Reset
PCB : Height 1.180" (30.00mm), double sided component
CL(IDD) 9 cycles
Row Cycle Time (tRCmin) 49.5ns (min.)
Refresh to Active/Refresh Command Time (tRFCmin) 110ns (min.)
Row Active Time (tRASmin) 36ns (min.)
Power 2.137 W (operating)
UL Rating 94 V - 0
Operating Temperature 0
C to 85
Storage Temperature -55
C to +100


View the manual for the Kingston Technology ValueRAM KVR1333D3S8R9S here, for free. This manual comes under the category Not categorized and has been rated by 1 people with an average of a 7.5. This manual is available in the following languages: English. Do you have a question about the Kingston Technology ValueRAM KVR1333D3S8R9S or do you need help? Ask your question here

Need help?

Do you have a question about the Kingston Technology ValueRAM KVR1333D3S8R9S and the answer is not in the manual? Ask your question here. Provide a clear and comprehensive description of the problem and your question. The better your problem and question is described, the easier it is for other Kingston Technology ValueRAM KVR1333D3S8R9S owners to provide you with a good answer.

Number of questions: 0

Kingston Technology ValueRAM KVR1333D3S8R9S specifications

Below you will find the product specifications and the manual specifications of the Kingston Technology ValueRAM KVR1333D3S8R9S.

Brand Kingston Technology
Model ValueRAM KVR1333D3S8R9S | KVR1333D3S8R9S/1GI
Product Not categorized
EAN 740617162707, 0740617162707
Language English
Filetype Usermanual (PDF)
Internal memory 1 GB
Internal memory type DDR3
Memory form factor 240-pin DIMM
Memory clock speed 1333 MHz
Buffered memory type Registered (buffered)
Row cycle time 49.5 ns
Refresh row cycle time 110 ns
Row active time 36 ns
Memory voltage 1.5 V
Memory layout (modules x size) 1 x 1 GB
CAS latency 9
Memory bus 72 bit
Memory type DDR3
Lead plating Gold
Operational conditions
Operating temperature (T-T) 0 - 85 °C
Other features
Chips organisation X8
show more

Frequently Asked Questions

Can't find the answer to your question in the manual? You may find the answer to your question in the FAQs about the Kingston Technology ValueRAM KVR1333D3S8R9S below.

Is your question not listed? Ask your question here

No results