Kawasaki Vulcan 500 LTD manual

Kawasaki Vulcan 500 LTD
8.7 · 31
PDF manual
 · 351 pages
English
manualKawasaki Vulcan 500 LTD

13-4 STEERING

Steerin g
Steering Inspection
Check the steering.
Lift the front wheel off the ground using the jack.
Special Tool - Jack: 57001-1238
With the front w heel pointing straight ahead, alternately
tap each end of the handlebar. The front wheel should
swing fully left and right from the force of gravity until the
fork hits the stop.
If the wheel binds or catches before the stop, the steering
is too tight.
Stand in front of the motorcycle and grasp the lower ends
of fork near the axle.
Feel for steering looseness by pushing [A] and pulling [B]
the forks.
If you feel looseness, the steering is too loose.
NOTE
The cables and wiring will have some effect on the mo-
tion of the fork which must be taken into account. Be
sure the wires and cables are properly routed.
The bearings must be in good condition and properly
lubricated in order for any test to be valid.
Steering Adjustment
Remove:
Fuel Tank (see Fuel Tank Rem oval in the Fuel System
chapter)
Loosen:
Front Fork Lower Clamp Bolts [A]
Stem Head Bolt [B]
Steering Stem Locknut [C]
Adjust the steering.
If the steering is too tight, loosen the stem nut [A] a fraction
of a turn.
If the s teering is too loose, tighten the stem nut a fraction
of a turn.
Special Tool - Steering Stem Nut Wrench: 57001-1100 [B]
NOTE
T
urn the stem nut a 1/8 turn at maximum at a time .
Torque - Steering Stem Nut: 4.9 N·m (0.5 kgf·m, 43 in·lb, for
reference)
While holding the stem nut, hand tighten the stem locknut
against the stem nut.

View the manual for the Kawasaki Vulcan 500 LTD here, for free. This manual comes under the category motorcycles and has been rated by 31 people with an average of a 8.7. This manual is available in the following languages: English. Do you have a question about the Kawasaki Vulcan 500 LTD or do you need help? Ask your question here

Need help?

Do you have a question about the Kawasaki and is the answer not in the manual?

  • Receive updates on solutions
  • Get answers to your question

Question and answer

Number of questions: 6
V
VagoDecember 11, 2022

What is the screw like that the engine has on top of the engine on one side of the gear on the outside?

What is the screw like that the engine has on top of the engine on one side of the gear on the outside?
zoom-in
View photo
This message has been automatically translated
D
daniel jimenezMarch 27, 2024

Hi in the compartment where the stator goes, is it normal to have oil or does it have a seal to prevent that?

Hi in the compartment where the stator goes, is it normal to have oil or does it have a seal to prevent that?
zoom-in
View photo
This message has been automatically translated
C
CodyMay 30, 2023

What to do when your motorcycle won’t start

S
ShaneJune 3, 2023

Can't find the drain bolt on my 94 vulcan 500

Can't find the drain bolt on my 94 vulcan 500
zoom-in
View photo
R
Robinson Guerra March 4, 2023

Qué medidas tiene el manubrio de la Vulcan 500 modelo 1993

K
KennySeptember 24, 2023

Does a800 Vulcan have a fuesbox

The Kawasaki Vulcan 500 LTD is a motorcycle that was produced by the Japanese manufacturer Kawasaki from 1990 to 2009. It falls under the category of cruiser motorcycles and is designed for riders who prefer a more relaxed and comfortable riding experience. The Kawasaki Vulcan 500 LTD is equipped with a liquid-cooled, 498cc parallel twin engine. This engine configuration provides a balanced power delivery and contributes to the motorcycle's smooth and manageable performance. It features a six-speed transmission, allowing for precise and smooth gear changes. With a relatively lightweight design and a low seat height, the Kawasaki Vulcan 500 LTD offers excellent maneuverability and ease of handling. This makes it an ideal choice for riders who are new to motorcycles or prefer a more manageable ride. In terms of suspension, the Kawasaki Vulcan 500 LTD features a front telescopic fork and rear twin shock absorbers. These suspension components are designed to provide a comfortable and stable ride, absorbing uneven road surfaces and minimizing rider fatigue. The Kawasaki Vulcan 500 LTD is equipped with a disc brake on the front wheel and a drum brake on the rear wheel, ensuring reliable and efficient braking performance. It also features a fuel capacity of approximately 4.0 gallons, allowing for a decent cruising range. Overall, the Kawasaki Vulcan 500 LTD is a reliable and practical cruiser motorcycle, suitable for riders who prioritize comfort, smooth performance, and ease of handling.

General
BrandKawasaki
ModelVulcan 500 LTD
Productmotorcycle
LanguageEnglish
FiletypeUser manual (PDF)

Can't find the answer to your question in the manual? You may find the answer to your question in the FAQs about the Kawasaki Vulcan 500 LTD below.

How do I convert miles into kilometres?

1 mile equals 1.609344 kilometers and 1 kilometer equals 0.62137119 miles.

What is the difference between E10 and E5 petrol?

E10 petrol consists of up to ten per cent ethanol while E5 petrol will contain less than five per cent ethanol. As a result, the percentage of E10 petrol is lower than that of E5 petrol, making it less bad for the environment.

How often should I replace the oil filter on my Kawasaki engine?

An oil filter must be replaced every 6000 kilometres (approx. 4000 miles) for most engines.

How often should I change the oil of my Kawasaki engine?

The oil must be changed every 6000 kilometres (approx. 4000 miles) for most engines.

How do I remove rust from my Kawasaki motorcycle?

1. Soak the rusty part in vinegar until completely soaked through. 2. Let the vinegar work on the rust for 24 hours. 3. Remove the rust with a wire brush or aluminium foil.

How do I check and adjust the tire pressure on my Kawasaki Vulcan 500 LTD?

To check and adjust tire pressure, you need to use a tire pressure gauge and locate the recommended pressure range specified by the manufacturer (usually found on the tire's sidewall). Use a reliable air pump to add or release air until the pressure is within the recommended range.

What should I do if my Kawasaki Vulcan 500 LTD won't start?

Firstly, ensure the motorcycle is in neutral and the engine kill switch is set to "on." Check the battery to ensure it has sufficient charge. If the battery is fine, check for any loose or corroded connections in the ignition circuit. If the issue persists, it would be best to consult a qualified technician.

How do I properly adjust the clutch lever on my Kawasaki Vulcan 500 LTD?

Adjusting the clutch lever requires locating the adjuster nut, often found near the clutch lever perch. Loosening or tightening this nut will change the lever's position. Find the position that provides a comfortable reach while still engaging the clutch effectively.

How do I change the engine oil on my Kawasaki Vulcan 500 LTD?

Start by warming up the motorcycle's engine. Next, locate the oil drain plug underneath the engine and use a suitable wrench to remove it. Allow the old oil to drain completely. Then, remove the oil filter and replace it with a new one. Finally, reinstall the drain plug and fill the engine with the recommended amount and type of fresh oil.

How do I adjust the rear suspension on my Kawasaki Vulcan 500 LTD?

To adjust the rear suspension, locate the preload adjuster on the rear shock absorbers. Turning the adjuster clockwise increases the preload, providing stiffer suspension, while turning it counterclockwise decreases the preload, resulting in a softer ride. Find the appropriate setting that suits your riding preferences and weight.

Is the manual of the Kawasaki Vulcan 500 LTD available in English?

Yes, the manual of the Kawasaki Vulcan 500 LTD is available in English .

Is your question not listed? Ask your question here

No results