Junker JD66SE50 manual

Junker JD66SE50
7.9 · 1
PDF manual
 · 40 pages
English
manualJunker JD66SE50
18
2.Screw on brackets for the extractor hood hand-tight, max. 3
Nm.
©
3.Screw in threaded pin, leaving it protruding out of the wall by
5 - 9 mm..
ª

Attaching and aligning the appliance

1.Initially remove the protective foil from the back of the
appliance and, following installation, remove the foil
completely.
2.When attaching the appliance, ensure that it engages firmly
with the brackets.
«
3.Align the appliance horizontally by turning the brackets. If
required, the appliance can be moved to the right or left.
¬
Securing the appliance
1.Press the safety caps with the arrow upwards onto the
brackets until they engage.
®
2.Screw on the knurled nut and washer firmly. ¯
Removing the safety caps
If the safety caps must be removed, use a flat screwdriver.
[
%
NJONN
NBYNN

&

'

(
)
*

Manual

View the manual for the Junker JD66SE50 here, for free. This manual comes under the category exhaust hoods and has been rated by 1 people with an average of a 7.9. This manual is available in the following languages: English. Do you have a question about the Junker JD66SE50 or do you need help? Ask your question here

Index

Need help?

Do you have a question about the Junker and is the answer not in the manual?

  • Receive updates on solutions
  • Get answers to your question

Question and answer

Number of questions: 0

Junker JD66SE50 specifications

Below you will find the product specifications and the manual specifications of the Junker JD66SE50.

General
BrandJunker
ModelJD66SE50
Productexhaust hood
LanguageEnglish
FiletypeUser manual (PDF)

Frequently Asked Questions

Can't find the answer to your question in the manual? You may find the answer to your question in the FAQs about the Junker JD66SE50 below.

When should I replace the carbon filter on my extractor hood?

The carbon filter should be replaced every three to twelve months.

How often should I clean the metal hood grease filters?

The metal grease filters should be cleaned every eight to ten weeks.

Where can I find the model number of my cooker ectractor hood?

The model number of the hood is usually found on a white label inside the hood.

Is the manual of the Junker JD66SE50 available in English?

Yes, the manual of the Junker JD66SE50 is available in English .

Is your question not listed? Ask your question here

No results