Junker JD66SE50 manual

Junker JD66SE50
7.9 · 1
PDF manual
 · 40 pages
English
manualJunker JD66SE50
17

Installation

Pipe dimensions

Note: The device manufacturer does not assume any warranty
for complaints attributable to the pipe section.
The device achieves its optimum performance by means of a
short, straight exhaust air pipe and as large a pipe diameter
as possible.
Because of long rough exhaust air pipes, many of which are
pipe bends or have diameters smaller than 150 mm, the
optimum extraction performance is not achieved and fan
noise is increased.
The pipes or hoses for laying the exhaust air line must
consist of non-combustible material.
Round pipes
An inner diameter of 150 mm, but at least 120 mm, is
recommended.
Flat ducts
The inner cross-section must correspond to the diameter of the
round pipes.
Ø 150 mm approx. 177 cm
2
Ø 120 mm approx. 113 cm
2
Flat ducts should have no sharp deflections.
Use sealing strip for deviating pipe diameters.

Checking the wall

The wall must be level, vertical and adequately load-bearing.
The depth of the bore holes must be the same length as the
screws. The wall plugs must have a secure grip.
The enclosed screws and wall plugs are suitable for solid
brickwork. Suitable fasteners must be used for other
structures (e.g. plasterboard, porous concrete, poroton
bricks).
The max. weight of the extractor hood is 40 kg.

Preparing the installation

1. Mark a vertical centre line on the wall from the ceiling
to the lower edge of the extractor hood.
2. Mark positions for the screws and the contour
of the attachment area.
3. Drill five 8 mm Ø holes to a depth of 80 mm
for the attachments and press in the wall plugs flush with
the wall.

Installation

1. Screw on the fixing bracket for the flue duct. ¨
[
PP
PP
PP
PLQPP
PD[PP
PP
PP
[
$

Manual

View the manual for the Junker JD66SE50 here, for free. This manual comes under the category exhaust hoods and has been rated by 1 people with an average of a 7.9. This manual is available in the following languages: English. Do you have a question about the Junker JD66SE50 or do you need help? Ask your question here

Index

Need help?

Do you have a question about the Junker and is the answer not in the manual?

  • Receive updates on solutions
  • Get answers to your question

Question and answer

Number of questions: 0

Junker JD66SE50 specifications

Below you will find the product specifications and the manual specifications of the Junker JD66SE50.

General
BrandJunker
ModelJD66SE50
Productexhaust hood
LanguageEnglish
FiletypeUser manual (PDF)

Frequently Asked Questions

Can't find the answer to your question in the manual? You may find the answer to your question in the FAQs about the Junker JD66SE50 below.

When should I replace the carbon filter on my extractor hood?

The carbon filter should be replaced every three to twelve months.

How often should I clean the metal hood grease filters?

The metal grease filters should be cleaned every eight to ten weeks.

Where can I find the model number of my cooker ectractor hood?

The model number of the hood is usually found on a white label inside the hood.

Is the manual of the Junker JD66SE50 available in English?

Yes, the manual of the Junker JD66SE50 is available in English .

Is your question not listed? Ask your question here

No results