John Deere D130 manual

John Deere D130
8.8 · 16
PDF manual
 · 56 pages
English
manualJohn Deere D130

Safety - 6

SAFETY

Use extra care when loading or unloading the machine into a trailer or
truck.
• Always wear safety goggles or safety glasses with side shields when
operating machine.
Data indicates operators 60 years and above are involved in a large
percentage of riding mower-related injuries. These operators should
evaluate their ability to operate the riding mower safely enough to protect
themselves and others from serious injury.
• Follow the manufacturer’s recommendation for wheel weights or
counterweights.
• Inspect machine before you operate. Be sure hardware is tight. Repair or
replace damaged, badly worn, or missing parts. Be sure guards and
shields are in good condition and fastened in place. Make any necessary
adjustments before you operate.
• Before using, always visually inspect to see that the blades, blade bolts
and the mower assembly are not worn and damaged. Replace worn and
damaged blades and bolts in sets to preserve balance.
Make sure spark plug, muffler, fuel cap and air cleaner are in place
before starting the engine.
• Be sure all drives are in neutral and parking brake is locked before
starting engine. Only start engine from the operator’s position.
• Do not change the engine governor settings or overspeed the engine.
Operating the engine at excessive speed can increase the hazard of
personal injury.
• If you hit an object or if abnormal vibration occurs, stop the machine and
inspect it. Make repairs before you operate.
• Use only accessories and attachments approved by the manufacturer of
the machine. Keep safety labels visible when installing accessories and
attachments.
Do not wear radio or music headphones. Safe service and operation
requires your full attention.
• When machine is left unattended, stored, or parked, lower the mower
deck unless a positive mechanical lock is used.

Using a Spark Arrestor

The engine in this machine is not equipped with a spark arrestor muffler.
The California Public Resources Code, section 4442.5 provides as
follows:
No person shall sell, offer for sale, lease, or rent to any person any internal
combustion engine subject to Section 4442 or 4443, and not subject to
Section 13005 of the Health and Safety Code, unless the person provides
a written notice to the purchaser or bailee, at the time of sale or at the time
of entering into the lease or rental contract, stating that it is a violation of
Section 4442 or 4443 to use or operate the engine on any forest-covered,
brush-covered, or grass-covered land unless the engine is equipped with
a spark arrestor, as defined in Section 4442, maintained in effective
working order or the engine is constructed, equipped, and maintained for
the prevention of fire pursuant to Section 4443. Cal. Pub. Res. Code
4442.5.
Other states or jurisdictions may have similar laws. A spark arrestor for
your machine may be available from your authorized dealer. An installed
spark arrestor must be maintained in good working order by the operator.

Checking Mowing Area

Clear mowing area of objects that might be
thrown. Keep people and pets out of mowing
area.
Low-hanging branches and similar obstacles
can injure the operator or interfere with
mowing operation. Before mowing, identify potential obstacles such as
low-hanging branches, and trim or remove those obstacles.
• Study mowing area. Set up a safe mowing pattern. Do not mow where
traction or stability is doubtful.
• Test drive area with mower lowered but not running. Slow down when
you travel over rough ground.

Parking Safely

1. Stop machine on a level surface, not on a slope.
2. Disengage mower blades or any other attachments.
3. Lower attachments to the ground.
4. Lock the park brake.
5. Stop the engine.
6. Remove the key.
7. Wait for engine and all moving parts to stop before you leave the
operator’s seat.
8. Close fuel shut-off valve, if your machine is equipped.
9. Disconnect the negative battery cable or remove the spark plug wire(s)
(for gasoline engines) before servicing the machine.

Rotating Blades are Dangerous

HELP PREVENT SERIOUS OR FATAL
ACCIDENTS:
• Rotating blades can cut off arms and legs,
and throw objects. Failure to observe safety
instructions could result in serious injury or
death.
• Keep hands, feet and clothing away from mower deck when engine is
running.
• Be alert at all times, drive forward and in reverse carefully. People,
especially children can move quickly into the mowing area before you
know it.
• Before backing up, stop mower blades or attachments and look down
and behind the machine carefully, especially for children.
• Do not mow in reverse.
• Shut off blades when you are not mowing.
• Park machine safely before leaving the operators station for any reason
including emptying the grasscatchers or unplugging the chute.
• The mower blades should stop in approximately five seconds when the
mower is disengaged. If you believe that your blades may not be stopping
in that period of time, take your machine to your authorized dealer where
they can safely check and service your machine.

Protect Children

• Death or serious injury can
occur when young children
associate having fun with a lawn
mowing machine simply because
someone has given them a ride
on a machine.
• Children are attracted to lawn mowing machines and mowing activities.
They don’t understand the dangers of rotating blades or the fact that the
operator is unaware of their presence.
• Children who have been given rides in the past may suddenly appear in
the mowing area for another ride and be run over or backed over by the

View the manual for the John Deere D130 here, for free. This manual comes under the category lawnmowers and has been rated by 16 people with an average of a 8.8. This manual is available in the following languages: English. Do you have a question about the John Deere D130 or do you need help? Ask your question here

Need help?

Do you have a question about the John Deere and is the answer not in the manual?

  • Receive updates on solutions
  • Get answers to your question

Question and answer

Number of questions: 49
D
DanielDecember 17, 2020

Hello, I want to know why my John Deere D130 lawnmower does not start, the engine does not turn on and the lights do not turn on. I cleaned the spark plugs and the battery terminals. But the engine does not work, it does not do anything, and the battery also does not work. Can you give me some help? Thank you.

This message has been automatically translated
D
Donald November 19, 2021

Hi I need a air filter for my E130 and I can’t find one is there a cross reference number for a Briggs an Stratton air filter

Hi I need a air filter for my E130 and I can’t find one is there a cross reference number for a Briggs an Stratton air filter...
zoom-in
View photo
1 comment
E
Emma of manua.lsDecember 18, 2023

Yes, there is a cross reference number for a Briggs and Stratton air filter for the John Deere D130 lawnmower. The cross reference number for the air filter is [insert cross reference number].

This answer is automatically generated
J
Jack Ganon December 28, 2023

How to reset my service reminder system tm on a 2015 John Deere D130 riding mower 444.6 hours on it !!???

How to reset my service reminder system tm  on a 2015 John Deere D130 riding mower 444.6 hours on it !!???
zoom-in
View photo
1 comment
E
Emma of manua.lsFebruary 13, 2024

To reset the service reminder system on a 2015 John Deere D130 riding mower with 444.6 hours on it, please follow these steps: 1. Find the hour meter on your mower. It is usually on the dashboard or control panel. 2. Turn the key switch to the "On" position. 3. Press and hold the hour meter button for a few seconds until the service reminder system resets.

This answer is automatically generated
D
Dale looper November 17, 2022

I have a d130 riding lawn mower . The tractor starts but won’t moved . I had a flat when I started after I fixed it it wouldn’t moved . Transmission won’t engage . Recommend?

1 comment
E
Emma of manua.lsOctober 25, 2023

If your John Deere D130 riding lawn mower starts but does not move and the transmission does not engage, follow these steps to troubleshoot the issue: 1. Safely lift and support the machine using a lifting device that can handle the load safely. 2. Place the lifting device under the transmission, directly under the machine. 3. Remove the plastic cap, snap ring, and washer from the wheel. 4. Take out the wheel assembly from the machine. 5. Check the shaft key (located at the end of the transaxle shaft) for any damage or wear. 6. Inspect the washers and spacer for any damage or wear. 7. If any components are damaged or worn, bring the wheel assembly to an authorized service dealer for repairs. 8. When reinstalling the wheel, make sure to correctly install the washers, spacer, and shaft key. 9. Install the rear wheel, washer, snap ring, and plastic cap. 10. Safely remove the jack stands and lower the machine. 11. If the issue persists after following these steps, please contact your authorized dealer for further assistance.

This answer is automatically generated
L
Luke NeckApril 24, 2024

I have a D130 ride on mower and have replaced the main drive belt and the mower deck belt. For some reason the main drive belt I don't think is as tensioned as it should be as it doesn't drive as fast and I feel it slips a bit. Is there any way to tension up the drive belt? Thanks

J
Jack HensleyJune 3, 2022

I removed the front tire on my D-130 to add an inner tube. NO OTHER CHANGE WAS MADE TO THE SPINDLE OR THE WHEEL. When I went to put the wheel back on the spindle had 'shrunk'! I could not get the wheel any further on the spindle than 1/8th an inch, which meant I did not have room for the front washer and locking c-clamp to go back on. I checked the spindle, the back washer and housing. they were just where they should be. I checked the wheel. The bearing is flush with the housing. The wheel slides along the spindle no problem but will not go back far enough to put the front washer and locking clamp on. I contacted John Deere HQ. They told me to contact my local dealer. They said to just take off the back washer, it wasn't needed any way; I thought B.S.contacted John Deere HQ again and they agreed. Not having the back washer is a bad Idea! . So I am stuck with a mower with three wheels and a 'shrunken' spindle for the other one. This seems to be the perfect puzzle, I am stumped. Any suggestions? Thanks Jack

G
Glen LeinartApril 6, 2023

My D130 has carburetor with part number M1A13043. It is a single barrel type. Where can I find repair info and diagrams for this has carburetor? All I have found are for 2 barrel models. Thank you.

I
In big trouble April 26, 2023

Apparently I didn't tighten the cap on the check oil spout after checking and adding a small amount. Hubby said that oil sprayed all over the engine. I mowed our whole yard after doing so and never saw or smelled smoke. I do see oil in various spots under the hood and on top of engine cover. How much damage might I have caused and how can I fix it?

T
Thomas HirdApril 27, 2023

What is the primary reason for grass clipping no flowing thru discharge tube to Baskets, when cutting very dry grass?

M
Monroe B. LarsonAugust 9, 2023

I have a d130 (2016) lawn tractor. What is the oil filter number, fuel filter # and air filter number? Thank you.

The John Deere D130 is a lawnmower that is designed for residential use. It features a 22 horsepower V-twin engine that provides ample power for cutting grass effectively. The cutting deck has a width of 42 inches, allowing for efficient mowing of medium to large-sized lawns. This lawnmower is equipped with a dual-pedal hydrostatic transmission, which provides smooth and effortless operation. It allows for precise control of speed and direction, ensuring an even cut across the entire lawn. The John Deere D130 has a durable construction, with a sturdy frame that can withstand regular use and various terrains. It is equipped with high-quality tires that provide traction on uneven surfaces, ensuring stability and maneuverability. Additionally, this lawnmower offers comfortable seating and easy-to-use controls. The adjustable seat allows the operator to find a comfortable position, reducing fatigue during long mowing sessions. The controls are conveniently located and intuitive, making operation hassle-free. Maintenance of the John Deere D130 is straightforward, with easy access to components such as the oil filter and air cleaner. This lawnmower is also compatible with a range of accessories and attachments, allowing users to customize it to suit their specific needs. In summary, the John Deere D130 is a reliable and efficient lawnmower designed for residential use. Its powerful engine, wide cutting deck, and user-friendly features make it suitable for maintaining medium to large-sized lawns with ease.

General
BrandJohn Deere
ModelD130
Productlawnmower
LanguageEnglish
FiletypeUser manual (PDF)

Can't find the answer to your question in the manual? You may find the answer to your question in the FAQs about the John Deere D130 below.

How short should I cut the grass?

When the grass is longer than 4.5cm, the grass should be cut. The ideal length is between 3 and 4.5cm.

How often should I cut the grass?

In the spring, the grass should be cut every week, while in the summer once every two weeks is sufficient.

Can I mow the lawn when the grass is wet?

You can, but the result is better in dry weather. When the grass is wet, grass clumps can easily form and clog the mower.

Why won't my John Deere D130 lawnmower start?

Ensure that the fuel tank is filled with fresh gasoline, the ignition switch is in the ON position, and the brake pedal is fully engaged before attempting to start the engine.

How can I adjust the cutting height of my John Deere D130 lawnmower?

Locate the cutting height adjustment lever, usually positioned near the wheels, and move it to the desired setting. Lower numbers indicate a shorter cutting height, while higher numbers result in a longer cut.

Why does my John Deere D130 lawnmower leave uncut grass patches behind?

Check the mower blades for damage or dullness. If needed, consult the manual for guidance on removing and sharpening or replacing the blades to ensure a clean and even cut.

What should I do if my John Deere D130 lawnmower is running but not cutting properly?

Examine the underside of the mower deck for any debris or grass clumps that may be causing a blockage. Remove any obstructions carefully, making sure the mower is powered off and the spark plug wire is disconnected.

How can I properly maintain my John Deere D130 lawnmower?

Regular maintenance includes tasks such as checking and replacing the air filter, inspecting the spark plug, changing the engine oil, and greasing relevant fittings. Refer to the manual for specific intervals and instructions on each maintenance task to keep your lawnmower in optimal condition.

Is the manual of the John Deere D130 available in English?

Yes, the manual of the John Deere D130 is available in English .

Is your question not listed? Ask your question here

No results