We take pride in our products and fully stand behind them.
GO AIR POP
EARBUDS
YOUR WARRANTY
All warranty claims are subject to JLab authorization
and at our sole discretion. Retain your proof of
purchase to ensure warranty coverage.
CONTACT US
Reach out to us at support@jlab.com
or visit jlab.com/contact
Remove tab and close door.
ADDING NEW / ADDITIONAL BLUETOOTH DEVICES:
Turn OFF Bluetooth from any previously connected
device. Turn ON Bluetooth from new device.
Take earbuds out of the case.
Earbuds will automatically enter Bluetooth Pairing.
Select “JLab GO Air Pop” in device settings to connect.
BLUETOOTH PAIRING
1
One earbud will blink blue/white indicating
ready to pair to your device.
3
Red light on case indicates charge.
Remove earbuds from case.
2
Select “JLab GO Air Pop” in your device's
Bluetooth settings to connect.
Voice prompt “You’re connected” followed by
blinking white lights will indicate you are connected.
4
Bluetooth
Settings
JLab GO Air Pop
REGISTER TODAY
jlab.com/register
Product updates | How-to tips
FAQs & more
L
I
M
I
T
E
D
T
W
O
Y
E
A
R
W
A
R
R
A
N
T
Y
S
U
P
P
O
R
T
T
E
A
M
#
T
E
A
M
J
L
A
B
View the manual for the JLab GO Air POP here, for free. This manual comes under the category Earphones and has been rated by 1 people with an average of a 9. This manual is available in the following languages: English. Do you have a question about the JLab GO Air POP or do you need help? Ask your question here
Need help?
Do you have a question about the JLab and the answer is not in the manual? Ask your question here. Provide a clear and comprehensive description of the problem and your question. The better your problem and question is described, the easier it is for other JLab owners to provide you with a good answer.
Brii • 25-1-2023No comments
I turned off Bluetooth on my phone so I could show someone a video. The ear bud will not power back on and connect unless I place it in the charging box. Is there a way to manually turn them back on without placing them in the box? Also, I have held the buds for 3+secs and nothing happens
Answer this question
Melinda Dempsey • 2-2-2023No comments
How do you get the earbuds to pair with one another?
Answer this question
Donald Hogan • 20-1-2023No comments
When I charge my earbuds the light says it is fully charged, but, when I take them out of the case to use it immediately says that the battery is only half full. It will not fully charge. I bought the earbuds in September of 2021. They're not that old.
Answer this question
Matt Sandifer • 19-1-2023No comments
The right earbud is the only one that pairs, the left earbud does nothing
Answer this question
Leeone Gilland • 7-1-2023No comments
My ear buds are not linked together. They show up as 2 separate buds.
Can't find the answer to your question in the manual? You may find the answer to your question in the FAQs about the JLab GO Air POP below.
When is my volume too loud?
A volume above 80 decibels can be harmful to hearing. When the volume exceeds 120 decibels, direct damage can even occur. The chance of hearing damage depends on the listening frequency and duration.
Can I make hands-free calls with my Earphone?
The newer Earphones generally have a small microphone built in which allows for calling.
What is noise cancelling?
Noise cancelling ensures that ambient noise is reduced.
What is bluetooth?
Bluetooth is a way of exchanging data wirelessly between electronic devices via radio waves. The distance between the two devices that exchange data can in most cases be no more than ten metres.
Is the manual of the JLab GO Air POP available in English?
Yes, the manual of the JLab GO Air POP is available in English .
Need help?
Do you have a question about the JLab and the answer is not in the manual? Ask your question here. Provide a clear and comprehensive description of the problem and your question. The better your problem and question is described, the easier it is for other JLab owners to provide you with a good answer.
I turned off Bluetooth on my phone so I could show someone a video. The ear bud will not power back on and connect unless I place it in the charging box. Is there a way to manually turn them back on without placing them in the box? Also, I have held the buds for 3+secs and nothing happens
How do you get the earbuds to pair with one another?
When I charge my earbuds the light says it is fully charged, but, when I take them out of the case to use it immediately says that the battery is only half full. It will not fully charge. I bought the earbuds in September of 2021. They're not that old.
The right earbud is the only one that pairs, the left earbud does nothing
My ear buds are not linked together. They show up as 2 separate buds.
How dobi turn up the volume on the ear buds
Number of questions: 6