Remote Level Control For JL Audio HD / MHD Amplifiers
CONTROL CABLE:
18 ft. (5.5 m) in Length
CONTROL KNOB:
Attenuates Level
TO AMPLIFIER:
Plug into “Remote
Level Control” Jack
on equipped Amplifier
This product will only work with HD and MHD Amplifiers.
Installation Procedure:
1. Find an appropriate location to mount the control assembly on the dash or
console of the vehicle. You will need access to the rear of the mounting panel
for installation. The area will require the following minimum and maximum
dimensions:
Area Behind Panel: 1 1/8” square x 3/4” deep (28mm x 28mm x 19 mm)
Mounting Panel Thickness: 1/8 inch (3.2mm) maximum
2. Drill a 3/8” (9mm) hole in the center of the mounting area.
3. Remove the knob from the HD-RLC’s shaft. Do NOT remove the nut and washer.
4. Insert the HD-RLC’s shaft through the drilled hole from behind the panel and
place the knob on the shaft from
the front, pushing it as far as it will go.
5. If the knob does not fit flush to the panel, remove the HD-RLC and use one of
the extra washers or nuts or both to space the assembly back from the panel
until the knob is flush. Once the appropriate shaft-depth has been achieved,
remove the knob.
6. Place the remaining nut and washer on the front of the shaft and tighten with
a 12 mm deep-well socket or wrench. Take care not to over-tighten this nut,
especially when attaching the HD-RLC to a plastic surface.
7. Place the knob on the shaft so that the pointer is at 7:00 with the control turned
fully counter-clockwise.
8. Route the control cable to the amplifier and connect one end to the jack labeled
“Remote Level Control”. Connect the other end to the female jack on the HD-RLC
controller.
9. Refer to the Amplifier Owner’s Manual for an explanation of
control operation.
Note: Should a replacement control cable be needed, you can use any standard telephone-to-wall-jack cable with six position terminations. The
cable itself can be 2-conductor, 4-conductor or 6 conductor.
View the manual for the JL Audio HD-RLC here, for free. This manual comes under the category remote controllers and has been rated by 1 people with an average of a 7.5. This manual is available in the following languages: English. Do you have a question about the JL Audio HD-RLC or do you need help? Ask your question here
Need help?
Do you have a question about the JL Audio and is the answer not in the manual?
Can't find the answer to your question in the manual? You may find the answer to your question in the FAQs about the JL Audio HD-RLC below.
A battery in my remote controller has started to corrode. Is the device still safe to use?
The product can still be used safely after proper cleaning. Remove the battery with gloves and clean the battery compartment with a toothbrush and vinegar. After drying, new batteries can be inserted into the device.
Is the manual of the JL Audio HD-RLC available in English?
Yes, the manual of the JL Audio HD-RLC is available in English .
Need help?
Do you have a question about the JL Audio and is the answer not in the manual?
Question and answer
Number of questions: 0