ICOM IC-M330G manual

ICOM IC-M330G
9.6 · 2
PDF manual
 · 72 pages
English
manualICOM IC-M330G
iii

For Display unit:

R WARNING! NEVER let metal, wire or other
objects contact the inside of the display unit, or make
incorrect contact with connectors on the rear panel.
This could cause an electric shock or damage the
display unit.
R WARNING! NEVER apply AC voltage to the DC
connector of the display unit. This could cause a re
or damage the display unit.
R WARNING! NEVER apply more than 42 V DC
to the DC connector of the display unit. This could
cause a re or damage the display unit.
R WARNING! NEVER touch or operate the display
unit with wet hands. This could cause an electric
shock or damage the display unit.
R WARNING! NEVER open the display unit. There
are no user adjustment points. This could cause an
electric shock and incorrect reassembly may cause a
re hazard.
R WARNING! NEVER operate the radar during a
lightning storm. It may result in an electric shock, cause
a re or damage the display unit. Always disconnect the
power source and scanner unit before a storm.
R WARNING! NEVER reverse the DC power cable
polarity. This could cause a re or damage the display
unit.
R WARNING! NEVER remove the fuse holder on the
DC power cable. Excessive current caused by a short
could cause a re or damage the display unit.
CAUTION: DO NOT use or place the display unit in
areas with temperature below –15˚C (+5˚F) or above
+55˚C (+131˚F).
CAUTION: DO NOT
use harsh solvents such as
Benzine or alcohol when cleaning, the display unit, as
they will damage the display unit surfaces.
CAUTION: DO NOT place the display unit in
excessively dusty environments.
DO NOT place the display unit near heating
equipment or in direct sunlight or where hot or cold
air blows directly onto it.
DO NOT place the display unit in areas that could
block air passage or put anything around the display
unit. This will obstruct heat dissipation.
KEEP the display unit out of the reach of
unauthorized persons.
KEEP the display unit away from heavy rain, and
never immerse it in the water.
The display unit meets IPX4 requirements for splash
resistance when the supplied connection cable,
scanner unit are connected.
However, if it is dropped, splash resistance cannot be
guaranteed because of possible damage to the case
or the waterproof seals.
The LCD display may have cosmetic imperfections
that appear as small dark or light spots. This is not a
malfunction or defect, but a normal characteristic of
LCD display.

For Scanner unit:

R DANGER: HIGH VOLTAGE! NEVER open the
scanner unit. The scanner unit contains high voltage
that could be fatal. And there are no user adjustment
points. All repairs and adjustments MUST be made
by a qualied electronics technician at your Marine
Navigation Dealer.
For qualied electronics technician only:
R
DANGER: HIGH VOLTAGE! High voltages of up to
3,500 volts are used in the scanner unit. Although
prudent measures for safety have been adopted,
sufcient care must be taken in the operation,
maintenance and adjustment of the scanner unit.
Electric shock of 1,000 volts or more may cause
electrocution and death; even an electric shock of
only 100 volts may be fatal.
R DANGER: HIGH VOLTAGE! DO NOT turn OFF the
radar
’s power and do not reach inside the scanner
unit before you have:
discharged the capacitors by disconnecting the
system cable from the radar unit for 5 minutes.
checked that no electric charges remain inside
the device.
Also, it is recommended to wear dry insulated
rubber gloves. NEVER use both hands
simultaneously; keep one hand in your pocket.
R
WARNING: RADIATION HAZARD!
Radiation emitted from the scanner unit can be
harmful, particularly to your eyes. To avoid harmful
radiation, turn
OFF the radar’s power
before
working on the scanner unit.
DO NOT use or place the scanner unit in areas with
temperature below –25˚C (–13˚F) or above +70˚C
(+158˚F).
NEVER immerse the scanner unit in the water.
The scanner unit meets IPX6
*
requirements for high-
pressure water jet resistance.
However, if the scanner unit is dropped, high-
pressure water jet resistance cannot be guaranteed
because of possible damage to the cases or the
waterproof seals.
*
Except for the cable connectors. They meet IPX4
requirements while connecting to the radar unit.

PRECAUTIONS

For U.S.A. only
CAUTION: Changes or modifications to this radar,
not expressly approved by Icom Inc., could void your
authority to operate this device under FCC regulations.

Manual

View the manual for the ICOM IC-M330G here, for free. This manual comes under the category radios and has been rated by 2 people with an average of a 9.6. This manual is available in the following languages: English. Do you have a question about the ICOM IC-M330G or do you need help? Ask your question here

Index

Need help?

Do you have a question about the ICOM and is the answer not in the manual?

  • Receive updates on solutions
  • Get answers to your question

Question and answer

Number of questions: 1
R
Richard BarbaresiMay 19, 2024

Where can I buy the manual

ICOM IC-M330G specifications

Below you will find the product specifications and the manual specifications of the ICOM IC-M330G.

The ICOM IC-M330G is a marine radio designed specifically for marine radio service. This radio features a built-in GPS satellite system, allowing users to accurately determine their position on the water. With an on/off switch, it offers convenient control for users to power the device as needed. In terms of dimensions, the IC-M330G has a width of 156.5 millimeters, a depth of 110.1 millimeters, and a height of 66.5 millimeters. It weighs approximately 730 grams, making it relatively lightweight for easy portability. The radio is equipped with a backlight display, ensuring visibility even in low-light conditions. The IC-M330G has a single antenna connector, allowing users to connect an external antenna if desired. It also carries an International Protection (IP) code of IPX7, indicating its resistance to water submersion up to a depth of 1 meter for 30 minutes. Key features of the ICOM IC-M330G include its GPS satellite system, on/off switch, compact dimensions, lightweight design, backlight display, and single antenna connector. These specifications make it suitable for marine applications, providing users with reliable communication and navigation capabilities while out on the water. To sum up, the ICOM IC-M330G is a marine radio that combines the functionality of a radio with the convenience of built-in GPS technology. With its compact and lightweight design, it enables users to communicate and navigate effectively in marine environments.

General
BrandICOM
ModelIC-M330G | IC-M330G
Productradio
LanguageEnglish
FiletypeUser manual (PDF)
Performance
PurposeMarine Radio Service
- channels
Operating frequency156.025 - 163.275 MHz
Maximum range- m
Ports & interfaces
GPS (satellite)Yes
Number of antenna connectors1
Antenna connector typeSO-239
Technical details
Product colorWhite
On/off switchYes
International Protection (IP) codeIPX7
Weight & dimensions
Width156.5 mm
Depth110.1 mm
Height66.5 mm
Weight730 g
Display
Backlight displayYes
Packaging content
ManualYes
Operational conditions
Operating temperature (T-T)-20 - 60 °C
show more

Frequently Asked Questions

Can't find the answer to your question in the manual? You may find the answer to your question in the FAQs about the ICOM IC-M330G below.

What is the weight of the ICOM IC-M330G?

The ICOM IC-M330G has a weight of 730 g.

What is the difference between FM and AM?

FM stands for Frequency Modulation and AM stands for Amplitude Modulation. The biggest difference between FM radio stations compared to AM radio stations is the sound quality.

When is my volume too loud?

A volume above 80 decibels can be harmful to hearing. When the volume exceeds 120 decibels, direct damage can even occur. The chance of hearing damage depends on the listening frequency and duration.

How can I best clean my radio?

A slightly damp cleaning cloth or soft, dust-free cloth works best to remove fingerprints. Dust in hard-to-reach places is best removed with compressed air.

What is bluetooth?

Bluetooth is a way of exchanging data wirelessly between electronic devices via radio waves. The distance between the two devices that exchange data can in most cases be no more than ten metres.

What is the height of the ICOM IC-M330G?

The ICOM IC-M330G has a height of 66.5 mm.

What is the width of the ICOM IC-M330G?

The ICOM IC-M330G has a width of 156.5 mm.

What is the depth of the ICOM IC-M330G?

The ICOM IC-M330G has a depth of 110.1 mm.

How do I turn on the IC-M330G radio?

To turn on the IC-M330G radio, simply press and hold the Power button until the display lights up.

How can I adjust the volume on the IC-M330G radio?

To adjust the volume on the IC-M330G radio, rotate the Channel Selector knob clockwise to increase the volume and counterclockwise to decrease it.

How can I change the channel on the IC-M330G radio?

To change the channel on the IC-M330G radio, simply rotate the Channel Selector knob to select the desired channel number or use the Up/Down buttons to move through the available channels.

How can I switch between different frequency bands on the IC-M330G radio?

To switch between different frequency bands on the IC-M330G radio, press the Band button to toggle between the available options, such as VHF and UHF.

How do I transmit a message using the IC-M330G radio?

To transmit a message using the IC-M330G radio, press and hold the Push-To-Talk (PTT) button located on the microphone, speak clearly into the microphone, and release the PTT button when you finish speaking.

Does the ICOM IC-M330G have GPS?

Yes, the ICOM IC-M330G has a GPS feature. This allows the user to accurately determine their location while on the water, providing added safety and convenience.

Does the ICOM IC-M330G have an on/off switch?

Yes, the ICOM IC-M330G is equipped with an on/off switch. This allows for easy control and power management of the radio.

Does the ICOM IC-M330G have a backlight display?

Yes, the ICOM IC-M330G features a backlight display. This ensures visibility and readability in various lighting conditions, enhancing user convenience and usability.

How many antenna connectors does the ICOM IC-M330G have?

The ICOM IC-M330G has one antenna connector. This is sufficient for most marine radio applications and ensures reliable signal transmission.

What is the IP code of the ICOM IC-M330G?

The ICOM IC-M330G has an IPX7 rating, indicating it is protected against the effects of immersion in water up to a depth of 1 meter for up to 30 minutes. This high level of water resistance makes it suitable for use in demanding marine environments.

Is the manual of the ICOM IC-M330G available in English?

Yes, the manual of the ICOM IC-M330G is available in English .

Is your question not listed? Ask your question here

No results