View the manual for the Husqvarna Z146 here, for free. This manual comes under the category lawnmowers and has been rated by 1 people with an average of a 7.9. This manual is available in the following languages: English. Do you have a question about the Husqvarna Z146 or do you need help? Ask your question here
Can't find the answer to your question in the manual? You may find the answer to your question in the FAQs about the Husqvarna Z146 below.
When the grass is longer than 4.5cm, the grass should be cut. The ideal length is between 3 and 4.5cm.
In the spring, the grass should be cut every week, while in the summer once every two weeks is sufficient.
You can, but the result is better in dry weather. When the grass is wet, grass clumps can easily form and clog the mower.
To properly clean below the mower deck of the Husqvarna Z146 lawnmower, follow these steps: 1. After using the mower and allowing it to cool down, do not spray water on the top of the mower deck. 2. Use compressed air to clean the top side of the mower deck, avoiding high-pressure washers or steam cleaners. 3. Clean the underside of the deck with normal water pressure by attaching a garden hose to the quick connect from the accessory packet. 4. Snap the hose to the cleanout port and turn on the water supply to wash away debris. 5. Remember to replace the special blade bolt with a Husqvarna bolt if needed and avoid using lower-grade hardware. 6. Check the cutting blades for damage and sharpen or replace them as necessary, ensuring proper installation and tightening of the blade bolt. 7. Use the spinning action of the blades to wash away debris, keeping the hose away from the mower blades and wearing protective glasses during cleaning.
To maintain the Husqvarna Z146 lawnmower blades, follow these steps: 1. Regularly clean the mower, especially under the deck, after each use to increase its lifespan. 2. Avoid spraying water on the top of the mower deck and use compressed air to clean it. 3. Clean the underside of the deck with normal water pressure using a garden hose. 4. Check the blades for damage and replace any that are bent or cracked from hitting obstacles. 5. Let a service workshop decide if blades with large nicks can be repaired or need replacement. 6. Balance the blades after sharpening and check the blade mounts. 7. To replace the blades, remove the blade bolt, install the new blade with the grass side facing down, tighten the bolt securely, and torque it to 45-60 ft/lbs. 8. Restart the mower to wash away debris and ensure safety precautions like wearing protective glasses and gloves.
Yes, the manual of the Husqvarna Z146 is available in English .
Is your question not listed? Ask your question here
No results
Need help?
Do you have a question about the Husqvarna and is the answer not in the manual?
Question and answer
Number of questions: 1Why does my new z146 zero turn pull to the left .. won’t go straight