Husqvarna Z 554 manual

Husqvarna Z 554
7.5 · 1
PDF manual
 · 84 pages
English
manualHusqvarna Z 554

CONFORMITY CERTIFICATES

USA requirements

Labels are placed on the engine and/or in the engine compartment stating that the machine
will fulll the requirements. This is also applicable to special requirements for any of the states,
(California emission rules etc.). Do not remove these labels. Certicates can also be supplied
with the machine at delivery or written in the Engine manual. Take care of them as they are
valuable documents.
WARNING! The rollover protection
system's capabilities may be impaired by
damage if the mower is overturned or if
alteration to the ROPS occurs. If these
conditions take place, the total structure MUST
be replaced.
When this product is worn out and no longer
used, return it to the reseller or other party for
recycling.
To implement improvements, specications
and designs can be altered without prior
notication.
Note that no legal demands can be placed
based on the information contained in these
instructions.
Use only original parts for repairs. The use of
other parts voids the warranty.
Do not modify or install non-standard
equipment to the unit without consent from the
manufacturer. Modications to the unit may
cause unsafe operations or damage the unit.
WARNING! Failure to follow cautious
operating practices can result in dangerous
injury to the operator or other persons. The
owner must understand these instructions,
and must let only approved persons who
understand these instructions to operate the
mower.
Each person operating the mower must be of
sound mind and body and must not be under
the inuence of mind altering substances.
WARNING! Engine exhaust, some of its
constituents, and certain vehicle components
contain or emit chemicals known to the State of
California to cause cancer and birth defects or
other reproductive harm.
WARNING! Battery posts, terminals
and related accessories contain lead and lead
compounds, chemicals known to the State of
California to cause cancer and birth defects
or other reproductive harm. Clean your hands
after handling.
WARNING! Engine exhaust and certain
vehicle components contain or emit chemicals
considered to cause cancer, birth defects,
or other reproductive system damage. The
engine exhaust contains carbon monoxide,
which is an odorless, colorless, poisonous gas.
Do not use the machine in enclosed spaces.
©2017 All rights reserved.
Orangeburg SC. Printed in U.S.A.

View the manual for the Husqvarna Z 554 here, for free. This manual comes under the category lawnmowers and has been rated by 1 people with an average of a 7.5. This manual is available in the following languages: English. Do you have a question about the Husqvarna Z 554 or do you need help? Ask your question here

Need help?

Do you have a question about the Husqvarna and is the answer not in the manual?

  • Receive updates on solutions
  • Get answers to your question

Question and answer

Number of questions: 1
H
Henry PoplerMay 7, 2022

Drive belt number for iz 61-5 zero turn

The Husqvarna Z 554 is a lawnmower designed for efficient and reliable grass cutting. It is engineered with high-quality materials to ensure durability and long-lasting performance. This lawnmower is specifically built for professional use, capable of handling demanding tasks with ease. The Husqvarna Z 554 features a powerful engine, providing ample power to tackle large areas quickly and effectively. The cutting deck is designed to be wide, allowing for efficient cutting and reducing the number of passes needed to complete the task. This lawnmower also offers an adjustable cutting height, providing versatility to accommodate various grass lengths. Equipped with ergonomic controls, the Husqvarna Z 554 ensures ease of use and operator comfort. The intuitive design of the controls allows for precise maneuverability and excellent handling on different terrains. It also features a durable and comfortable seat, providing a smooth and comfortable ride for the operator during long hours of operation. In terms of safety, the Husqvarna Z 554 incorporates necessary features like a robust braking system to ensure reliable and precise stopping when needed. It also has excellent visibility, allowing the operator to have a clear view of the cutting area for enhanced safety. Overall, the Husqvarna Z 554 is a high-performance lawnmower suitable for professionals seeking efficiency, reliability, and durability. Its powerful engine, wide cutting deck, ergonomic design, and safety features make it an ideal choice for those in need of a professional-grade lawnmower.

General
BrandHusqvarna
ModelZ 554
Productlawnmower
LanguageEnglish
FiletypeUser manual (PDF)

Can't find the answer to your question in the manual? You may find the answer to your question in the FAQs about the Husqvarna Z 554 below.

How short should I cut the grass?

When the grass is longer than 4.5cm, the grass should be cut. The ideal length is between 3 and 4.5cm.

How often should I cut the grass?

In the spring, the grass should be cut every week, while in the summer once every two weeks is sufficient.

Can I mow the lawn when the grass is wet?

You can, but the result is better in dry weather. When the grass is wet, grass clumps can easily form and clog the mower.

How do I adjust the steering controls on the Husqvarna Z 554 lawnmower?

To adjust the steering controls on the Husqvarna Z 554 lawnmower, follow these steps: 1. Locate the steering control levers on the lawnmower. These controls are used to adjust the speed and direction of the machine. 2. The steering controls can be moved forward or backward around a neutral position. There is a neutral position that is locked if the controls are moved out. 3. When the two controls are in the neutral position (N), the lawnmower stands still. Moving both controls forward or backward will make the lawnmower move in a straight line in that direction. 4. To turn right while moving forward, move the right control towards the neutral position. This will reduce the rotation of the right wheel and make the lawnmower turn to the right. 5. Zero turn can be achieved by moving one control backward (behind the neutral position) and carefully moving the other steering control forward from its neutral position. The rotation direction when zero turning is determined by which steering control is moved backward behind the neutral position. 6. If the steering controls are not in even positions when standing still or do not fit in the slots for moving the controls out, they can be adjusted. 7. To engage the park brake, move the two steering control levers out from the neutral position. To release the park brake, pull the two levers inwards to the neutral position at the same time. 8. It is important to bring the steering/park brake controls inward at the same time to prevent the unit's safety system from shutting down. By following these steps, you can adjust the steering controls on the Husqvarna Z 554 lawnmower.

Why is the park brake not engaging on the Husqvarna Z 554 lawnmower?

The park brake on the Husqvarna Z 554 lawnmower may not be engaging due to a faulty adjustment. Here are the steps to troubleshoot and adjust the park brake: 1. Visually inspect the steering control levers, links, and switches belonging to the park brake for any damage. 2. Perform a standstill test to check if there is sufficient braking action. 3. Make equal adjustments on the two park brake controls. To do this, remove the rivet pins from the boot and slide the boot up. 4. If the park brake position does not pass the standstill test or has required maintenance, it may need adjustment. The spring should measure a compressed length of 1/2" (12.7 mm) shorter than the free length. Tighten the nuts holding the brake spring if necessary. 5. To change the park brake action, tighten the pivot bolt until the desired braking feel is correct. 6. Perform a neutral adjustment if either wheel turns while the park brake is engaged. a. Raise the rear wheels of the lawnmower and support it with jack stands. b. Start the engine and observe if either wheel turns. c. Access the control rod linkage by unlatching and rotating the seat forward. d. Remove and retain the pin from the front coupler. e. Turn the hex nut in either direction until the wheel stops turning. f. Count the number of turns with the flat surfaces of the nut and stop turning when the wheel spins in the opposite direction. g. Turn the nut back one half of the amount of turns counted in the previous step. h. Repeat the process with the opposite wheel if necessary. By following these steps, you can troubleshoot and adjust the park brake on the Husqvarna Z 554 lawnmower.

How do I adjust the tracking controls on the Husqvarna Z 554 lawnmower?

To adjust the tracking controls on the Husqvarna Z 554 lawnmower, follow these steps: 1. Start by checking the air pressure in the two rear tires. The recommended air pressure for the rear tires is 15 psi (1 bar). 2. Locate the tracking bolts, which act as limiting devices for the motion control levers when in the full-forward position. 3. Move the unit to an open, unobstructed area such as an empty parking lot or open field for preliminary tracking adjustment. 4. Back out the tracking bolts until they are flush with the nut. 5. Test operate the lawnmower by driving it at full throttle and the full forward position on the two steering control levers. 6. Gradually turn in the tracking bolt on the right-hand side until the lawnmower noticeably starts drifting to the right. 7. Drive forward at full throttle with the two steering control levers in the full forward position. 8. Gradually turn in the left-hand tracking bolt until the lawnmower tracks straight. By following these steps, you can adjust the tracking controls on the Husqvarna Z 554 lawnmower.

Why is the fuel gauge not showing the correct level on the Husqvarna Z 554 lawnmower?

The fuel gauge on the Husqvarna Z 554 lawnmower may not be showing the correct level due to various reasons. Here are the steps to troubleshoot the issue: 1. Check the fuel tank cap and ensure it is properly tightened. A loose or damaged cap can cause inaccurate readings. 2. Inspect the fuel tank for any signs of damage or leaks. A damaged tank can affect the fuel gauge's accuracy. 3. Verify that the fuel tank is filled with the recommended type of fuel. The Husqvarna Z 554 lawnmower requires a minimum of 87-octane unleaded gasoline. Using the wrong type of fuel can affect the fuel gauge readings. 4. Check the fuel gauge wiring connections for any loose or damaged wires. Secure or repair any faulty connections. 5. Clean the fuel gauge sensor located inside the fuel tank. Use a clean cloth or brush to remove any dirt or debris that may be affecting the sensor's accuracy. 6. If the above steps do not resolve the issue, it is recommended to contact a qualified technician or Husqvarna customer support for further assistance. By following these steps, you can troubleshoot the fuel gauge issue on the Husqvarna Z 554 lawnmower.

How do I reset the service meter on the Husqvarna Z 554 lawnmower?

To reset the service meter on the Husqvarna Z 554 lawnmower, follow these steps: 1. Locate the service meter on the lawnmower. It is usually located on the control panel or dashboard. 2. Turn the ignition key to the "On" position to power on the lawnmower. 3. Press and hold the reset button on the service meter. The reset button is typically labeled with an icon or text indicating its function. 4. Continue holding the reset button until the service meter resets to zero or the desired value. 5. Release the reset button once the service meter has been reset. 6. Turn off the ignition key to power off the lawnmower. 7. The service meter should now be reset and ready for the next service interval. By following these steps, you can reset the service meter on the Husqvarna Z 554 lawnmower.

How do I open the fuel tank cap on the Husqvarna Z 554 lawnmower?

To open the fuel tank cap on the Husqvarna Z 554 lawnmower, follow these steps: 1. Locate the fuel tank cap on the lawnmower. It is usually located on the top of the fuel tank, near the rear of the machine. 2. Check that the lawnmower is turned off and the engine is cool before attempting to open the fuel tank cap. 3. Grip the fuel tank cap firmly with your hand. 4. Rotate the fuel tank cap counterclockwise to loosen it. 5. Continue rotating the fuel tank cap until it is fully unscrewed from the fuel tank. 6. Lift the fuel tank cap off the fuel tank and set it aside in a safe place. 7. Refuel the lawnmower as needed, ensuring that you use the recommended type of fuel and fill the tank to the appropriate level. 8. After refueling, place the fuel tank cap back onto the fuel tank. 9. Rotate the fuel tank cap clockwise to tighten it securely. 10. Ensure that the fuel tank cap is tightly closed to prevent fuel leakage. By following these steps, you can safely and correctly open the fuel tank cap on the Husqvarna Z 554 lawnmower.

Is the manual of the Husqvarna Z 554 available in English?

Yes, the manual of the Husqvarna Z 554 is available in English .

Is your question not listed? Ask your question here

No results