Husqvarna Z 448 manual

Husqvarna Z 448
7.5 · 1
PDF manual
 · 244 pages
English
manualHusqvarna Z 448
Cleaning the battery and terminals
Battery Removal
Corrosion and dirt on the battery and terminals
can cause the battery to lose power.
1. Lift and rotate the seat fully forward until
supported.
2. Remove the bolt and nut from the battery
bracket and remove the bracket from the
battery.
3. Using a wrench, disconnect the BLACK
battery cable then the RED battery cable.
4. Carefully remove the battery from the mower
and clean if required.
5. Rinse the battery with plain water and dry.
6. Clean the terminals and battery cable ends
with a wire brush.
7. Reinstall battery with terminals in the same
position as prior to removal.
8. Connect RED battery cable rst to positive (+)
battery terminal.
9. Connect BLACK grounding cable to negative
(-) battery terminal.
10. Fasten the battery in place with bracket
removed in Step 2.
IMPORTANT INFORMATION Do not open
or remove caps or covers. Adding or checking
level of electrolyte is not necessary.
Always use two wrenches for the terminal
screws.
CAUTION! Always wear eye
protection when around batteries.
CAUTION! Lead-acid batteries generate
explosive gases. Keep sparks, ame and
smoking materials away from batteries.

Battery

If the battery is too weak to start the engine, it
must be recharged.
Jumper Cable Use
1. Connect each end of the RED cable to the
POSITIVE (+) terminal on each battery, taking
care not to short against chassis.
2. Connect one end of the BLACK cable to the
NEGATIVE (-) terminal of the fully charged
battery.
3. Connect the other end of the BLACK cable
to a good CHASSIS GROUND on the mower
with the discharged battery, away from the
fuel tank and battery.
To remove cables, reverse order
1. Remove BLACK cable rst from chassis and
then from the fully charged battery.
2. Remove RED cable last from both batteries.
The mower has a maintenance free battery
and does not need servicing. However, periodic
charging of the battery with an automotive type
battery charger will extend its life.
Keep battery and terminals clean.
Keep battery bolts tight.
See chart for charging times.
STD
BATTERY
STATE
OF
CHARGE
APPROXIMATE CHARGING TIME*
TO FULL CHARGE AT 80
O
F
Maximum Rate at:
50 Amps 30 Amps 20 Amps 10 Amps
12.6V 100%
- FULL CHARGE -
12.4V 75% 20 min. 35 min. 48 min. 90 min.
12.2V 50% 45 min. 75 min. 95 min. 180 min.
12.0V 25% 65 min. 115 min. 145 min. 280 min.
11.8V 0% 85 min. 150 min. 195 min. 370 min.
*Charging time depends on battery capacity,
condition, age, temperature and eciency of charger
23

MAINTENANCE

View the manual for the Husqvarna Z 448 here, for free. This manual comes under the category lawnmowers and has been rated by 1 people with an average of a 7.5. This manual is available in the following languages: English. Do you have a question about the Husqvarna Z 448 or do you need help? Ask your question here

Need help?

Do you have a question about the Husqvarna and is the answer not in the manual?

  • Receive updates on solutions
  • Get answers to your question

Question and answer

Number of questions: 0

The Husqvarna Z 448 is a lawnmower designed for residential use. It features a 48-inch cutting deck made of durable materials for long-lasting performance. The lawnmower is powered by a reliable engine that provides sufficient power for cutting grass effectively. With a hydrostatic transmission, the Husqvarna Z 448 offers smooth and effortless operation, allowing users to easily maneuver around obstacles in the yard. The lawnmower is equipped with comfortable seating and ergonomic controls for user convenience. It also has adjustable cutting heights to accommodate different grass lengths. The Husqvarna Z 448 is designed to provide a clean and precise cut, leaving the lawn looking well-maintained. Additionally, it has a compact design for easy storage when not in use. Overall, the Husqvarna Z 448 is a practical and efficient option for homeowners looking to maintain their lawn with ease.

General
BrandHusqvarna
ModelZ 448
Productlawnmower
LanguageEnglish
FiletypeUser manual (PDF)

Can't find the answer to your question in the manual? You may find the answer to your question in the FAQs about the Husqvarna Z 448 below.

How short should I cut the grass?

When the grass is longer than 4.5cm, the grass should be cut. The ideal length is between 3 and 4.5cm.

How often should I cut the grass?

In the spring, the grass should be cut every week, while in the summer once every two weeks is sufficient.

Can I mow the lawn when the grass is wet?

You can, but the result is better in dry weather. When the grass is wet, grass clumps can easily form and clog the mower.

How do I engage the park brake on the Husqvarna Z 448 lawnmower?

To engage the park brake on the Husqvarna Z 448 lawnmower, follow these steps: 1. Stop the engine. 2. Remove the ignition key. 3. Ensure the park brake is engaged. 4. Avoid making any adjustments unless the engine is stopped and the ignition key is removed. 5. Be cautious when loading the machine onto a truck or trailer using ramps to prevent any potential injuries. 6. Remember that once the bypasses are engaged and the steering controls are moved to release the parking brake, the unit is free to roll and may cause harm. 7. Use extra care when operating the park brake to ensure safety for yourself and others. 8. Always refer to the operator manual for detailed instructions and safety precautions.

What should I do if the throttle is not responding on the Husqvarna Z 448 lawnmower?

If the throttle is not responding on the Husqvarna Z 448 lawnmower, follow these steps: 1. Check if the throttle control is not stuck or obstructed. 2. Inspect the throttle cable for any damage or disconnection. 3. Ensure that the throttle linkage is properly connected and functioning. 4. Verify that the throttle lever on the engine is moving freely. 5. Clean any debris or dirt around the throttle mechanism. 6. Lubricate the throttle cable and linkage if necessary. 7. If the issue persists, consult a professional for further inspection and repair.

Is the manual of the Husqvarna Z 448 available in English?

Yes, the manual of the Husqvarna Z 448 is available in English .

Is your question not listed? Ask your question here

No results