Husqvarna Z 448 manual

Husqvarna Z 448
7.5 · 1
PDF manual
 · 244 pages
English
manualHusqvarna Z 448

Cutting Height Pedal

The desired cutting height is set with the height
pin. The cutting height pedal releases the deck lift
to place the deck at the selected height.
For transport, push the lift pedal fully forward
until the deck lift latches in the transport (highest)
position.

Tracking

If the mower is not tracking straight, check the
air pressure in both rear tires. Recommended air
pressure for the rear tires is 15 psi (1 bar).
1. Tracking adjustments are made using the
tracking bolts.
2. For preliminary tracking adjustment, move
unit to an open, unobstructed area such as an
empty parking lot or open eld.
3. Turn the tracking bolts in as far as possible.
4. Back the tracking bolts out 4 full turns. Any
more than four turns could damage the unit.
5. Test operate unit by driving it at full throttle
and the full forward position on both motion
control levers. Gradually turn in the tracking
bolt on the right hand side until the unit
noticeably starts drifting right.
6. Drive forward at full throttle with both motion
control levers in the full forward position.
Gradually turn in the tracking bolt (left side)
until unit tracks straight.

Hydro Release Levers

Transmission bypass levers must be engaged
when pushing or pulling the machine.
Transmissions are put into bypass mode by
rotating the levers to the horizontal position. The
bypass levers are located at the front of both
transmissions. See Manual Transport in the
Operation section.
IMPORTANT INFORMATION Always raise the
deck to the highest position for transport.

Fuel Tank

Read the safety instructions before refueling. The
capacity for the tank is ve gallons.
Regularly check the gas cap gasket for damage
and keep the cap correctly tightened.
The engine will run on a minimum of 87-octane
unleaded gasoline (no oil mix). Environmentally
adapted alkylate gasoline can be used. See
Technical Data concerning ethanol fuel. Methanol
fuel is not allowed. Do not use E85 alcohol based
fuel. Damage to the engine and components can
occur.
When operating in temperatures below 32°F, use
fresh, clean winter grade gasoline to ensure good
cold weather starting.
15

CONTROLS

View the manual for the Husqvarna Z 448 here, for free. This manual comes under the category lawnmowers and has been rated by 1 people with an average of a 7.5. This manual is available in the following languages: English. Do you have a question about the Husqvarna Z 448 or do you need help? Ask your question here

Need help?

Do you have a question about the Husqvarna and is the answer not in the manual?

  • Receive updates on solutions
  • Get answers to your question

Question and answer

Number of questions: 0

The Husqvarna Z 448 is a lawnmower designed for residential use. It features a 48-inch cutting deck made of durable materials for long-lasting performance. The lawnmower is powered by a reliable engine that provides sufficient power for cutting grass effectively. With a hydrostatic transmission, the Husqvarna Z 448 offers smooth and effortless operation, allowing users to easily maneuver around obstacles in the yard. The lawnmower is equipped with comfortable seating and ergonomic controls for user convenience. It also has adjustable cutting heights to accommodate different grass lengths. The Husqvarna Z 448 is designed to provide a clean and precise cut, leaving the lawn looking well-maintained. Additionally, it has a compact design for easy storage when not in use. Overall, the Husqvarna Z 448 is a practical and efficient option for homeowners looking to maintain their lawn with ease.

General
BrandHusqvarna
ModelZ 448
Productlawnmower
LanguageEnglish
FiletypeUser manual (PDF)

Can't find the answer to your question in the manual? You may find the answer to your question in the FAQs about the Husqvarna Z 448 below.

How short should I cut the grass?

When the grass is longer than 4.5cm, the grass should be cut. The ideal length is between 3 and 4.5cm.

How often should I cut the grass?

In the spring, the grass should be cut every week, while in the summer once every two weeks is sufficient.

Can I mow the lawn when the grass is wet?

You can, but the result is better in dry weather. When the grass is wet, grass clumps can easily form and clog the mower.

How do I engage the park brake on the Husqvarna Z 448 lawnmower?

To engage the park brake on the Husqvarna Z 448 lawnmower, follow these steps: 1. Stop the engine. 2. Remove the ignition key. 3. Ensure the park brake is engaged. 4. Avoid making any adjustments unless the engine is stopped and the ignition key is removed. 5. Be cautious when loading the machine onto a truck or trailer using ramps to prevent any potential injuries. 6. Remember that once the bypasses are engaged and the steering controls are moved to release the parking brake, the unit is free to roll and may cause harm. 7. Use extra care when operating the park brake to ensure safety for yourself and others. 8. Always refer to the operator manual for detailed instructions and safety precautions.

What should I do if the throttle is not responding on the Husqvarna Z 448 lawnmower?

If the throttle is not responding on the Husqvarna Z 448 lawnmower, follow these steps: 1. Check if the throttle control is not stuck or obstructed. 2. Inspect the throttle cable for any damage or disconnection. 3. Ensure that the throttle linkage is properly connected and functioning. 4. Verify that the throttle lever on the engine is moving freely. 5. Clean any debris or dirt around the throttle mechanism. 6. Lubricate the throttle cable and linkage if necessary. 7. If the issue persists, consult a professional for further inspection and repair.

Is the manual of the Husqvarna Z 448 available in English?

Yes, the manual of the Husqvarna Z 448 is available in English .

Is your question not listed? Ask your question here

No results