Husqvarna Z 254F manual

Husqvarna Z 254F
7.5 · 1
PDF manual
 · 72 pages
English
manualHusqvarna Z 254F
21

MAINTENANCE

Battery

If the battery is too weak to start the engine, it
must be recharged.
Jumper Cable Use
1. Connect each end of the RED cable to the
POSITIVE (+) terminal on each battery, taking
care not to short against chassis.
2. Connect one end of the BLACK cable to the
NEGATIVE (-) terminal of the fully charged
battery.
3. Connect the other end of the BLACK cable
to a good CHASSIS GROUND on the mower
with the discharged battery, away from the
fuel tank and battery.
To remove cables, reverse order
1. Remove BLACK cable rst from chassis and
then from the fully charged battery.
2. Remove RED cable last from both batteries.
The mower is equipped with a maintenance
free battery and does not need servicing.
However, periodic charging of the battery with an
automotive type battery charger will extend its life.
Keep battery and terminals clean.
Keep battery bolts tight.
See chart for charging times.
STD
BATTERY
STATE
OF
CHARGE
APPROXIMATE CHARGING TIME*
TO FULL CHARGE AT 80
O
F
Maximum Rate at:
50 Amps 30 Amps 20 Amps 10 Amps
12.6V 100%
- FULL CHARGE -
12.4V 75% 20 min. 35 min. 48 min. 90 min.
12.2V 50% 45 min. 75 min. 95 min. 180 min.
12.0V 25% 65 min. 115 min. 145 min. 280 min.
11.8V 0% 85 min. 150 min. 195 min. 370 min.
*Charging time depends on battery capacity,
condition, age, temperature and efciency of charger
Cleaning battery and terminals
Corrosion and dirt on the battery and terminals
can cause the battery to lose power.
1. Loosen the two nuts attached to the side
J bolts just enough that the battery mount
bracket slides down off the battery.
2. Using two 1/2" wrenches disconnect BLACK
battery cable then RED battery cable.
3. Carefully remove the battery from the mower
4. Rinse the battery with plain water and dry.
5. Clean terminals and battery cable ends with a
wire brush until shiny.
6. Coat the terminals with grease or petroleum
jelly.
Replacing battery
1. Install the new battery with terminals in the
same position as the old battery.
2. Connect RED battery cable rst to positive (+)
battery terminal.
3. Connect BLACK grounding cable to negative
(-) battery terminal.
4. Slide mount bracket back up over battery and
tighten nuts.
5. Replace terminal boot cover.
IMPORTANT INFORMATION Do not open
or remove battery caps or covers. Adding or
checking level of electrolyte is not necessary.
Always use two wrenches for the terminal
screws.
CAUTION! Lead-acid batteries generate
explosive gases. Keep sparks, ame and
smoking materials away from batteries. Always
wear eye protection when around batteries.

View the manual for the Husqvarna Z 254F here, for free. This manual comes under the category lawnmowers and has been rated by 1 people with an average of a 7.5. This manual is available in the following languages: English. Do you have a question about the Husqvarna Z 254F or do you need help? Ask your question here

Need help?

Do you have a question about the Husqvarna and is the answer not in the manual?

  • Receive updates on solutions
  • Get answers to your question

Question and answer

Number of questions: 1
T
Tom GibbsMarch 8, 2024

How to remove the brake interlock switch

The Husqvarna Z 254F is a lawnmower designed for efficient grass cutting. It features a 54-inch cutting deck made of reinforced steel, providing durability and stability during operation. The mower is equipped with a 26 HP Kohler engine, ensuring powerful performance for both residential and commercial use. The hydrostatic transmission enables smooth speed adjustment without the need to change gears. The lawnmower is designed with air induction mowing technology, which improves airflow within the deck, resulting in a cleaner and more even cut. The high-back seat and ergonomic steering wheel provide a comfortable and easy-to-control riding experience. The Husqvarna Z 254F also comes with a pedal-operated deck lift system for convenient cutting height adjustment. Additionally, the lawnmower features a removable foot pan for easy access to the deck and engine maintenance. The heavy-duty frame and cast iron blade spindles enhance the overall durability of the machine. Overall, the Husqvarna Z 254F is a reliable and efficient lawnmower suitable for various grass cutting needs.

General
BrandHusqvarna
ModelZ 254F
Productlawnmower
LanguageEnglish
FiletypeUser manual (PDF)

Can't find the answer to your question in the manual? You may find the answer to your question in the FAQs about the Husqvarna Z 254F below.

How short should I cut the grass?

When the grass is longer than 4.5cm, the grass should be cut. The ideal length is between 3 and 4.5cm.

How often should I cut the grass?

In the spring, the grass should be cut every week, while in the summer once every two weeks is sufficient.

Can I mow the lawn when the grass is wet?

You can, but the result is better in dry weather. When the grass is wet, grass clumps can easily form and clog the mower.

How should I properly load the lawnmower onto a trailer or truck using full-width ramps?

To properly load the Husqvarna Z 254F lawnmower onto a trailer or truck using full-width ramps, follow these steps: 1. Drive the machine slowly up the ramps without lifting it by hand. 2. Engage the hydro bypass levers on both sides and pull both steering/park brake controls inwards to manually push the machine if needed. 3. Be cautious as you load the machine onto the trailer or truck using ramps to avoid the risk of injury or accidents. 4. Ensure that the machine is correctly fastened to the transport vehicle to prevent tipping over during transport. 5. Always reverse the machine onto the transport vehicle to enhance stability and safety. 6. Do not exceed the maximum recommended operation angle of 10 degrees when loading or removing the machine. Remember to use full-width ramps and exercise extreme care to prevent any mishaps during the loading process.

What precautions should I take when transporting the lawnmower on roads to ensure safety?

When transporting the Husqvarna Z 254F lawnmower on roads, follow these precautions for safety: 1. Ensure the fuel filler cap is tightly mounted and no flammable substances are kept in an open vessel. 2. Disconnect the grounding cable from the battery first and reconnect it last to prevent sparking. 3. Use full-width ramps for loading the machine into a trailer or truck. 4. Secure the machine with front and rear tie-down straps directed down and out from the machine. 5. Check and comply with local traffic regulations before transporting the machine on roads. 6. Use an approved trailer to transport the machine and turn off the fuel supply. 7. Do not tow the machine or tow trailers with the mower to avoid damage and injuries. 8. Load the unit onto the truck or trailer by driving up ramps of sufficient strength using a slow speed; do not lift the machine by hand. 9. Always reverse the machine onto the transport vehicle to prevent tipping over during transport.

Is the manual of the Husqvarna Z 254F available in English?

Yes, the manual of the Husqvarna Z 254F is available in English .

Is your question not listed? Ask your question here

No results