HP c3000 DDR2 Onboard

Administrator

Installation Instructions

for HP BladeSystem c3000 and c3000 Tower Enclosure

Introduction

There are two optional Onboard Administrator modules available

with the enclosure:

• HP c3000 DDR2 Onboard Administrator module, part number

488099-B21

• HP c3000 Dual Onboard Administrator module, part number

488100-B21

To use the Onboard Administrator modules, you must have HP

BladeSystem Onboard Administrator version 2.30 or greater

installed. For more information on using the Onboard Administrator

software, see the

HP BladeSystem Onboard Administrator User

Guide.

You can install the optional HP c3000 DDR2 Onboard Administrator

module in the enclosure without a second module.

Before you install an HP c3000 Dual Onboard Administrator in the

enclosure, you must have installed the c3000 DDR2 Onboard

Administrator module.

NOTE: The HP BladeSystem c3000 Enclosure is shown

in the illustrations throughout this document. The HP

BladeSystem c3000 Tower Enclosure is rotated 90

degrees clockwise from what is shown in the

illustrations.

HP c3000 DDR2 Onboard

Administrator module components

Item Name Description

1 Insight Display A display that

provides

information about

the health and

operation of the

enclosure

2 Serial connector Serial RS232 DB-9

connector with PC

standard pinout.

3 UID LED Blue = UID on

Dark = UID off

Item Name Description

4 Active Onboard

Administrator LED

An LED that

indicates which

Onboard

Administrator is

active

5 Health LED Green = OK

Red = Critical error

6 USB A USB 2.0 Type A

connector that

connects supported

USB devices

7 Reset button —

HP c3000 Dual Onboard

Administrator module components

Item Name Description

1 Serial connector Serial RS232 DB-9

connector with PC

standard pinout

2 UID LED Blue = UID on

Dark = UID off

3 Active Onboard

Administrator LED

An LED that

indicates which

Onboard

Administrator is

active

4 Health LED Green = OK

Red = Critical error

5 USB USB 2.0 Type A

connector that

connects supported

USB devices

6 Reset button —

Upgrading an HP Onboard

Administrator module to an HP

c3000 DDR2 Onboard

Administrator module

1. Disconnect all cables from the HP Onboard Administrator

module.

2. Remove the HP Onboard Administrator module.

3. Slide either the c3000 Dual Onboard Administrator module (if

ordered) or an Onboard Administrator blank into the c3000

DDR2 Onboard Administrator module, and close the handle.

The information contained herein is subject to change without notice. The

only warranties for HP products and services are set forth in the express

warranty statements accompanying such products and services. Nothing

herein should be construed as constituting an additional warranty. HP shall

not be liable for technical or editorial errors or omissions contained herein.

Bluetooth is a trademark owned by its proprietor and used by Hewlett-

Packard Com

under license.

Part Number 488456-002

September 2009 (Second Edition)

Need help?

Number of questions: 0

Do you have a question about the HP BLc3000 or do you need help? Ask your question here. Provide a clear and comprehensive description of the issue and your question. The more detail you provide for your issue and question, the easier it will be for other HP BLc3000 owners to properly answer your question.

Index

About the HP BLc3000

View the manual for the HP BLc3000 here, for free. This manual comes under the category Servers and has been rated by 1 people with an average of a 9.9. This manual is available in the following languages: English. Do you have a question about the HP BLc3000 or do you need help? Ask your question here