Panic Alarm Station Configuration Guide
68
Block List
The IP address in this list will be blocked. Other IP address can communicate normally.
Allow List
Only the IP address in this list can communicate normally. Other IP address will be blocked.
Note
You can only enable one kind of list.
Security Service
Click Maintenance and Security → Security → Security Service.
Enable SSH, and click Save.
Note
SSH is used for remote debugging. For your safety, it is recommended to disable SSH when it is
not needed.
Locking User
Steps
1. Click Maintenance and Security → Security → Locking User.
2. Enable Locking, set parameters.
Max. Failure Attempts
The default setting is 7 times, and the setting range is 3 to 10.
Locking Duration
The default setting is 600 seconds, and the setting range is 10 to 3600.
3. Click Save.
Note
If you enter the wrong password more than the set number of times, the IP address of the login
terminal of the locked user will be displayed in the list.
4. (Optional) The user can be unlocked through the following operations.
Click to unlock the locked user in the list.
Click Unlock All to unlock all locked users.
Need help?
Do you have a question about the Hikvision and is the answer not in the manual?
Question and answer
Number of questions: 0