Hikvision DS-2DF8250I5X-AELW manual

Hikvision DS-2DF8250I5X-AELW
9.4 · 1
PDF manual
 · 138 pages
English
manualHikvision DS-2DF8250I5X-AELW
© Hikvision
Figure 5-2 Record Parameters
Pre-record: The time you set to start recording before the scheduled time or the event.
For example, if an alarm triggers recording at 10:00, and the pre-record time is set as 5
seconds, the camera starts to record at 9:59:55.
The pre-record time can be configured as No Pre-record, 5 s, 10 s, 15 s, 20 s, 25 s, 30 s or
not limited.
Note:
The pre-record time changes according to the video bitrate.
Post-record: The time you set to stop recording after the scheduled time or the event.
For example, if an alarm triggered recording ends at 11:00, and the post-record time is
set as 5 seconds, the camera records until 11:00:05.
The Post-record time can be configured as 5 s, 10 s, 30 s, 1 min, 2 min, 5 min or 10 min.
Stream Type: You can select the stream type for recording; Main Stream and Sub-stream
are selectable. If you select Sub-stream, you can record for a longer time with the same
storage capacity.
Overwrite: If you enable his function and the HDD is full, the new record files overwrite
the oldest record files automatically.
Note:
The Pre-record and Post-record parameters vary depending on different camera models.
4. Click OK to save the advanced setting.
5. Select a Record Type. The record type can be Continuous, Motion, Alarm, Motion | Alarm,
Motion & Alarm, and Event.
Normal: If you select Continuous, the video will be recorded automatically according to
the time of the schedule.
Record Triggered by Motion Detection: If you select Motion, the video will be recorded
when the motion is detected. Besides configuring the recording schedule, you have to
set the motion detection area and check the checkbox of Trigger Channel in the Linkage
Method of Motion Detection settings interface. For detailed information, refer to
Section 5.2.1 Configuring Motion Detection.
Record Triggered by Alarm: If you select Alarm, the video will be recorded when the
alarm is triggered via the external alarm input channels. Besides configuring the
recording schedule, you have to set the Alarm Type and check the checkbox of Trigger
Channel in the Linkage Method of Alarm Input settings interface. For detailed
information, refer to Section 5.2.3 Configuring Alarm Input.
Record Triggered by Motion | Alarm: If you select Motion | Alarm, the video will be
recorded when the external alarm is triggered or the motion is detected. Besides

Manual

View the manual for the Hikvision DS-2DF8250I5X-AELW here, for free. This manual comes under the category security cameras and has been rated by 1 people with an average of a 9.4. This manual is available in the following languages: English. Do you have a question about the Hikvision DS-2DF8250I5X-AELW or do you need help? Ask your question here

Index

Need help?

Do you have a question about the Hikvision and is the answer not in the manual?

  • Receive updates on solutions
  • Get answers to your question

Question and answer

Number of questions: 0

Hikvision DS-2DF8250I5X-AELW specifications

Below you will find the product specifications and the manual specifications of the Hikvision DS-2DF8250I5X-AELW.

General
BrandHikvision
ModelDS-2DF8250I5X-AELW | DS-2DF8250I5X-AELW
Productsecurity camera
EAN0842571110074
LanguageEnglish
FiletypeUser manual (PDF), Quickstart Guide (PDF)
Performance
TypeIP security camera
Wide Dynamic Range (WDR)Yes
Day/night modeYes
Maximum operating distance1.5 m
PTZ modes4 Pattern
Auto-trackingYes
Alarm input/outputYes
PTZ protocolsPelco-P/D
PTZ controlYes
Placement supportedIndoor & outdoor
Infrared (IR) cut-off filterYes
Connectivity technologyWired
Video
Total megapixels2 MP
Maximum resolution1920 x 1080 pixels
Full HDYes
Analog signal format systemNTSC, PAL
Back Light Compensation (BLC)Yes
Highlight Compensation (HLC)Yes
Privacy maskingYes
Frame rate60 fps
Video compression formatsH.264, H.264+, H.265, H.265+, M-JPEG
Region of Interest (ROI) encodingYes
Noise reductionYes
3D NR (Noise Reduction)Yes
Video streamingYes
Noise reduction technology3D noise reduction
Image sensor
Progressive scanYes
Sensor typeCMOS
Optical sensor size1/2.8 "
Number of sensors1
Camera
Minimum illumination0 lx
Pan range0 - 360 °
Pan preset speed280 °/sec
Tilt preset speed250 °/sec
Tilt angle range-20 - 90 °
Preset programs quantity300
White balanceATW, Auto, Fluorescent, Indoor, Lamp, Manual, Outdoor, Sodium lamp
Camera shutter speed1/1 - 1/30000 s
Lens system
Digital zoom16 x
FocusMotorized/Manual
Focal length range- mm
Optical zoom50 x
Maximum aperture number5.5
Minimum aperture number1.8
Number of lenses-
Zoom capabilityYes
Night vision
Night visionYes
Night vision distance500 m
LED typeIR
Network
Ethernet LANYes
Cabling technology10/100Base-T(X)
Ethernet interface typeFast Ethernet
Supported network protocolsIPv4/IPv6, HTTP, HTTPS, 802.1x, QoS, FTP, SMTP, UPnP, SNMP, DNS, DDNS, NTP, RTSP, RTCP, RTP, TCP/IP, DHCP, PPPoE, Bonjour
Quality of Service (QoS) supportYes
Number of users32 user(s)
Networking standardsIEEE 802.1x
Wi-Fi-
Bluetooth-
Streaming methodMulticast
Audio
Audio formats supportedG.711, G.722.1, G.726, MP2L2, PCM
Audio input channels1 channels
Audio output channels1 channels
Storage
Card reader integratedYes
Compatible memory cardsMicroSD (TransFlash), MicroSDHC, MicroSDXC
Built-in HDD-
Maximum memory card size256 GB
Security
IP address filteringYes
Intelligent Video Surveillance (IVS) system featuresAbandoned object, Crossing line, Face detection, Intrusion, Missing object
Management features
Web browserYes
Behavior analysisIntrusion detection, Line crossing detection, Object removal detection, Unattended baggage detection
Power
Power source typeAC
Power consumption (max)60 W
AC input voltage24 V
Operational conditions
Operating temperature (T-T)-40 - 70 °C
Operating relative humidity (H-H)0 - 90 %
Design
International Protection (IP) codeIP67
IK codeIK10
Housing materialAluminum
Form factorDome
Product colorBlack, White
Mounting typeCeiling/wall
Weight & dimensions
Height410 mm
Diameter266.6 mm
Weight8000 g
Ports & interfaces
RS-485 ports1
BNC output ports1
InterfaceRJ-45/BNC
Ethernet LAN (RJ-45) ports1
Packaging content
Number of cameras1
Other features
Number of simultaneous users20 user(s)
show more

Frequently Asked Questions

Can't find the answer to your question in the manual? You may find the answer to your question in the FAQs about the Hikvision DS-2DF8250I5X-AELW below.

What is the weight of the Hikvision DS-2DF8250I5X-AELW?

The Hikvision DS-2DF8250I5X-AELW has a weight of 8000 g.

What is a megapixel?

The number of megapixels denotes how many pixels there are in the sensor. 1 megapixel equals 1 million pixels. The more pixels, the higher the potential image quality.

What does the abbreviation 'MP' stand for?

MP stands for MegaPixels.

What is the height of the Hikvision DS-2DF8250I5X-AELW?

The Hikvision DS-2DF8250I5X-AELW has a height of 410 mm.

Is the manual of the Hikvision DS-2DF8250I5X-AELW available in English?

Yes, the manual of the Hikvision DS-2DF8250I5X-AELW is available in English .

Is your question not listed? Ask your question here

No results