Hikvision DS-2CE56C2T-IRP(3.6MM) manual

Hikvision DS-2CE56C2T-IRP(3.6MM)
9.2 · 1
PDF manual
 · 2 pages
English
manualHikvision DS-2CE56C2T-IRP(3.6MM)
5.Adjust the surveillance angle.
1).Loosen No.3 adjusting screw to adjust the
panning position 0 ~ 360 . °)
.2).Tighten No.3 adjusting screw
3).Loosen the No.2 adjusting screw to adjust the
tilting position 0 ~ 90 °).
4).Tighten No.2 adjusting screw.
5).Loosen No.1 adjusting screw to adjust the
azimuth angle of the image 0 ~ 360 °).
.6).Tighten No.1 adjusting screw
Figure 2-3 3-axis Adjustment
3.Connect the corresponding power cable and
video cable.
4.Fix the camera to the ceiling with the supplied
screws.
Figure 2-2 Fix the Camera to the Ceiling
360°
90°
360°
3
2
1
2.2 Installation of Type II Camera
Steps:
1.Drill the screw holes according to the drill
template.
Figure 2-4 The Drill Template
2. Screw the clip plate onto the mounting base
loosely.
Figure 2-5 Screw the Clip Plate
Clip PlateFigure 2-1 The Drill TemplateScrew hole
Figure 2-6 Fix the the Camera
6.Adjust the camera according to the figure below
to get an optimum angle.
Figure 2-7 3-axis Adjustment

0 ~360°°

0~75°°

0 ~360°°

Clip Plate

3. Fix the mounting base to the ceiling with the
supplied screws.
4.Route the cables through the side opening and
connect the corresponding power cable and
video cable.
5.Pull out the clip plate and secure the camera
with the trim ring to the mounting base.
6.Push the clip plate in and tighten the lock screw
to secure the trim ring.
2.3 Installation of Type CameraIII
1.Drill the screw holes and the cable hole on the
ceiling according to the supplied drill template.
Steps:
Figure 2-8 The Drill Template
Figure 2-9 Fix the Mounting Base and Camera
2.Fix the mounting base to the ceiling with the
supplied screws.
3.Route the cables to the cable hole and connect
corresponding power cable and video cable.
4.Secure the camera to the mounting base.
5.
Adjust the camera according to the figure below
to get an optimum angle.
0~360°°
0~75°°
0~360°°
Figure 2-10 3-axis Adjustment
Screw HoleCable Hole7.Adjust the camera according to the figure 2-7 to
get an optimum angle and tighten the trim ring.
Steps:
1.Drill the screw holes in the ceiling according
to the supplied drill template.
2.Hammer the supplied plastic expansion bolt into
the screw holes.
Screw hole

Side Opening

2.1 Ceiling Mounting for Type I
Camera
Both wall mounting and ceiling mounting are
suitable for type bullet camera. Ceiling mountingI
will be taken as an example in the section. And you
can take steps of ceiling mounting as a reference
if wall mounting is adopted.

Manual

View the manual for the Hikvision DS-2CE56C2T-IRP(3.6MM) here, for free. This manual comes under the category security cameras and has been rated by 1 people with an average of a 9.2. This manual is available in the following languages: English. Do you have a question about the Hikvision DS-2CE56C2T-IRP(3.6MM) or do you need help? Ask your question here

Need help?

Do you have a question about the Hikvision and is the answer not in the manual?

  • Receive updates on solutions
  • Get answers to your question

Question and answer

Number of questions: 0

Hikvision DS-2CE56C2T-IRP(3.6MM) specifications

Below you will find the product specifications and the manual specifications of the Hikvision DS-2CE56C2T-IRP(3.6MM).

General
BrandHikvision
ModelDS-2CE56C2T-IRP(3.6MM) | DS-2CE56C2T-IRP(3.6MM)
Productsecurity camera
EAN6954273620899
LanguageEnglish
FiletypeUser manual (PDF)
Performance
Type-
Placement supportedIndoor
Connectivity technologyWired
Day/night modeYes
Network
Wi-FiNo
Ethernet LAN-
Design
Form factorDome
Product colorWhite
Mounting typeCeiling
Audio
Signal-to-Noise Ratio (SNR)62 dB
Video
Maximum resolution1280 x 960 pixels
Supported video modes720p
Analog signal format systemNTSC, PAL
Total megapixels1.3 MP
Full HDNo
Frame rate30 fps
Weight & dimensions
Height69.8 mm
Diameter89.5 mm
Weight250 g
Power
Power over Ethernet (PoE)-
Power consumption (typical)4 W
DC output voltage12
Camera
Minimum illumination0.01 lx
Field of view (FOV) angle74.6 °
Tilt angle range0 - 75 °
Pan range0 - 360 °
Angle of rotation360 °
Camera shutter speed1/50000 - 1/30 s
Operational conditions
Operating temperature (T-T)-20 - 45 °C
Image sensor
Sensor typeCMOS
Packaging content
Number of cameras1
Storage
Built-in HDDNo
Night vision
Night visionYes
Night vision distance20 m
LED typeIR
show more

Frequently Asked Questions

Can't find the answer to your question in the manual? You may find the answer to your question in the FAQs about the Hikvision DS-2CE56C2T-IRP(3.6MM) below.

What is the weight of the Hikvision DS-2CE56C2T-IRP(3.6MM)?

The Hikvision DS-2CE56C2T-IRP(3.6MM) has a weight of 250 g.

What is a megapixel?

The number of megapixels denotes how many pixels there are in the sensor. 1 megapixel equals 1 million pixels. The more pixels, the higher the potential image quality.

What does the abbreviation 'MP' stand for?

MP stands for MegaPixels.

What is the height of the Hikvision DS-2CE56C2T-IRP(3.6MM)?

The Hikvision DS-2CE56C2T-IRP(3.6MM) has a height of 69.8 mm.

Is the manual of the Hikvision DS-2CE56C2T-IRP(3.6MM) available in English?

Yes, the manual of the Hikvision DS-2CE56C2T-IRP(3.6MM) is available in English .

Is your question not listed? Ask your question here

No results