2.Select the upgrade mode in the upgrade mode field
3.Enter the Firmware server path and config server path (192.168.0.254 is HTTP server).
4.Enter the HTTP server’s username and password (optional).
5.Click the button to save the configuration.
6.Restart the UC912P, IP Phone will restart and auto-get firmware files from HTTP server.
NOTES:
Htek recommends end-user use the Htek HTTP server. For large companies, we
recommend to maintain their own TFTP/HTTP/FTP/HTTPS server for upgrade and
provisioning procedures.
Once a “Firmware Server Path” is set, user needs to update the settings and restart the
IP Phone. If the configured firmware server is found and a new code image is available,
the UC912P will attempt to retrieve the new image files by downloading them into the
UC912P’s SDRAM. During this stage, the UC912P’s LEDs will blinkfastly until the
checking/downloading process is completed. Upon verification of checksum, the new
code image will then be saved into the Flash. If TFTP/HTTP/FTP/HTTPS fails for any
reason (e.g. TFTP/HTTP/FTP/HTTPS server is not responding, there are no code image
files available for upgrade, or checksum test fails, etc), the UC912P will stop the
TFTP/HTTP/FTP/HTTPS process and simply boot using the existing code image in the
flash.
Firmware upgrade may take as long as 3 to 8 minutes over Internet, or just 1 minutes if
it is performed on a LAN. It is recommended to conduct firmware upgrade in a
Manual
View the manual for the HanlongHanlong UC912P here, for free. This manual comes under the category phones and has been rated by 1 people with an average of a 8.8. This manual is available in the following languages: English. Do you have a question about the HanlongHanlong UC912P or do you need help? Ask your question here
Need help?
Do you have a question about the HanlongHanlong and is the answer not in the manual?
Question and answer
Number of questions: 0