2.Select the desired Key and select multicast paging in the Type.
3.Enter the multicast IP address and port number (e.g., 224.5.6.20:2000) in the Value field.
The valid multicast IP addresses range from 224.0.0.0 to 239.255.255.255.
4.Click the button to save the configuration.
Sending RTP Stream:
Press the multicast paging key when the phone is idle.
The phone sends RTP to a preconfigured multicast address (IP: Port). Any phone in the local
network then listens to the RTP on the preconfigured multicast address (IP:Port). For both
sending and receiving of the multicast RTP, there is no SIP signaling involved.
The multicast paging key LED illuminates solid green.
Receiving RTP Stream
You can configure the phone to receive a Real Time Transport Protocol (RTP) stream from the
pre-configured multicast address(es) without involving SIP signaling. You can specify up to 10
multicast addresses that the phone listens to on the network.
How the phone handles incoming multicast paging calls depends on Paging Barge and Paging
Priority Active parameters configured via web user interface.
Paging Barge
The paging barge parameter defines the priority of the voice call in progress. If the priority of an
incoming multicast paging call is lower than that of the active call, it will be ignored automatically.
If Disabled is selected from the pull-down list of Paging Barge, the voice call in progress will take
precedence over all incoming multicast paging calls.
Valid values in the Paging Barge field:
1 to 10: Define the priority of the active call, 1 with the highest priority, 10 with the lowest.
Disabled: The voice call in progress will take precedence over all incoming paging calls.
Paging Priority Active
The paging priority active parameter decides how the phone handles incoming multicast paging
calls when there is already a multicast paging call on the phone. If enabled, the phone will ignore
incoming multicast paging calls with lower priorities, otherwise, the phone will answer incoming
multicast paging calls automatically and place the previous multicast paging call on hold. If
disabled, the phone will automatically ignore all incoming multicast paging calls.
Multicast Codec:
You can only configure the codec by web interface.
To configure multicast codec key via web interface
1.Click Directory ->Multicast Paging:
2.Select the desired codec from the pull-down list of Multicast Codec
Manual
View the manual for the HanlongHanlong UC912P here, for free. This manual comes under the category phones and has been rated by 1 people with an average of a 8.8. This manual is available in the following languages: English. Do you have a question about the HanlongHanlong UC912P or do you need help? Ask your question here
Need help?
Do you have a question about the HanlongHanlong and is the answer not in the manual?
Question and answer
Number of questions: 0