Furuno 1732C manual

Furuno 1732C
5.5 · 1
PDF manual
 · 252 pages
English
manualFuruno 1732C
2. RADAR OPERATION

2-31

The equipment then searches for targets inside the guard zone to determine the
guard alarm type. If a target is found inside the guard zone the guard zone type
becomes an “Outward guard alarm”, and any target exiting, the guard zone will
trigger an alarm. If no target is found the guard zone type becomes an “Inward
guard alarm”, and any targets entering the guard zone will trigger the alarm. The
guard alarm type is shown as G1(G2) IN or G1(G2) OUT.
Note 1: When the radar range is less than the guard zone range, the audio
alarm sounds and the alarm icon is displayed (red on the color model).
Press the [CLEAR] key to silence the alarm. Press the [ALARM] key and
the message “GUARD1(2) IS OUTSIDE RADAR RANGE” appears.
Reselect appropriate range.
Note 2: If the network radar is set to standby while the guard alarm is active, the
guard alarm is cancelled. The guard alarm is redisplayed when the
radar is set to transmit again.
Note 3: If the network radar is set to standby while the radar picture is not
displayed, the alarm icon appears (red on the color model) and the
alarm sounds. Press the [ALARM] key and the message “STBY MODE
HAS BEEN SELECTED. GUARD/WTCHMN CANCELED.” or
“GUARD/WATCHMAN CANCELED. STBY/TX SELECTED.” appears.

2.22.2 When the alarm is violated…

Any radar target violating the guard zone will flash, the audio alarm sounds, and
the alarm icon appears (red on the color model). Additionally the message
“TARGET ENTERED INTO GUARD1(GUARD2)” or “TARGET LEFT FROM
GUARD1(GUARD2)” is displayed at the bottom of the screen, depending on the
guard zone type. Press the [CLEAR] key to silence the alarm. When this is done,
“G1(G2) ACK” replaces G1(G2) IN(OUT) at the top right corner of the display.
This means the alarm is temporarily deactivated. To reactivate the alarm, press
the SET GUARD1 or SET GUARD2 soft key as appropriate.

2.22.3 Canceling the guard alarm

1. Press the [ALARM] key to show the ALARM menu.
2. Press the ERASE GUARD1 or ERASE GUARD2 soft key as appropriate.
3. Press the RETURN soft key to finish.

Manual

View the manual for the Furuno 1732C here, for free. This manual comes under the category marine radars and has been rated by 1 people with an average of a 5.5. This manual is available in the following languages: English. Do you have a question about the Furuno 1732C or do you need help? Ask your question here

Index

Need help?

Do you have a question about the Furuno and is the answer not in the manual?

  • Receive updates on solutions
  • Get answers to your question

Question and answer

Number of questions: 0

Furuno 1732C specifications

Below you will find the product specifications and the manual specifications of the Furuno 1732C.

General
BrandFuruno
Model1732C
Productmarine radar
LanguageEnglish
FiletypeUser manual (PDF)

Frequently Asked Questions

Can't find the answer to your question in the manual? You may find the answer to your question in the FAQs about the Furuno 1732C below.

Is the manual of the Furuno 1732C available in English?

Yes, the manual of the Furuno 1732C is available in English .

Is your question not listed? Ask your question here

No results