Focal FDP 1.900 manual

Focal FDP 1.900
(1)
  • Number of pages: 8
  • Filetype: PDF
1

POWER PER CHANNEL:

1 x 500 wRMS @ 4ohms
1 x 850 wRMS @ 2ohms
1 x 500 wRMS @ 1 ohms
1 x 1700 wRMS (Two FDP 1.900s Bridged @ 4 ohms only)

INPUT/OUTPUT CONFIGURATIONS

Because this is a one channel amplifier, if both left and right inputs are used, they are mixed to mono, which is useful
for subwoofers.

CROSSOVER CONFIGURATION

The 24 dB per octave crossover can be adjusted so this amplifier can function as:
1. Full range
2. Low Pass for a subwoofer.
3. Band Pass for a subwoofer or midbass of a 3 way speaker.v
4. High Pass for a midbass, midrange or tweeter.
The amplifier can be used full range with switch in HP position and frequency set to 10 Hz.
HP is always on so it can be used as a subsonic filter.
HP X1 frequency range is 10 Hz to 400 Hz.
HP X10 frequency range is 100 Hz to 4000 Hz.
LP: Adjustment range is 30 Hz to 350 Hz.
Band Pass with switch in LP position and adjusting both HP and LP to desired frequency.
The remote volume control is always active.
There is a clip distortion light on the remote volume control.
If you see this light on, reduce volume until the light goes out so that you do not damage your speaker.
Phase is continuously adjustable between 0 degrees and 180 degrees. Adjust by measuring frequency response
at the crossover frequency. Frequency response should be as smooth as possible.
40 Hz EQ is adjustable between 0dB and +6dB.
Measure the subwoofer frequency response and adjust EQ to get the smoothest frequency response.
Avoid excess EQ boost because this will make the subwoofer sound “muddy” and cause the amplifier have clip
distortion prematurely.

AUTOMATIC POWER TURN ON/OFF

1. The best way to automatically turn the amplifier power on and off is to use the REM wire from your source radio
connected to the REM amplifier terminal.
2. If your original equipment stereo or source radio has a BTL amplifier then the RCA inputs have an auto turn
on sensing circuit. When you connect the high level BTL speaker wires to the RCA input the REM wire is not
necessary.

FDP 1.900 : ONE CHANNEL AMPLIFIER

Operation / Configuration

Focal FDP 1.900

Need help?

Number of questions: 0

Do you have a question about the Focal FDP 1.900 or do you need help? Ask your question here. Provide a clear and comprehensive description of the issue and your question. The more detail you provide for your issue and question, the easier it will be for other Focal FDP 1.900 owners to properly answer your question.

View the manual for the Focal FDP 1.900 here, for free. This manual comes under the category Receivers and has been rated by 1 people with an average of a 7.5. This manual is available in the following languages: English. Do you have a question about the Focal FDP 1.900 or do you need help? Ask your question here

Focal FDP 1.900 specifications

General
Brand Focal
Model FDP 1.900
Product Receiver
Language English
Filetype PDF

Frequently Asked Questions

Below, you will find the most frequently asked questions about the Focal FDP 1.900.

Is your question not listed? Ask your question here