Extron Show Me manual

Extron Show Me
5.7 · 1
PDF manual
 · 1 page
English
manualExtron Show Me

“Show Me” Cable Series

Share Button
INPUT
To Source
Device
OUTPUT
To Switcher
Three-Conductor
Pigtail for Contact
Closure and Tally
Extron
HDMI “Show MeCables
Tx Rx
RS-232 AUTO
REMOTE
1234G
CONTACT
1234
+v
TALLY OUT
Green
Yellow
Pigtail

Operation

Press the Share button to switch the connected source to the main
presentation display.
Pressing the Share button creates a momentary contact
closure, which triggers the switcher to select the connected
source device. If a tally output is available, the button
lights up blue.

NOTES:

The source device provides the +5 VDC supply voltage needed to illuminate the
Share button. This is standard for both analog (VGA) and digital source devices.
If the source device does not supply this +5 VDC, the Share button will not
illuminate. Some mobile devices do not provide the required voltage to light up
the button.
Digital “Show Me” cables support embedded audio and CEC signals. The VGA
“Show Me” cable does not support audio.
Share Button
INPUT
To Source
Device
OUTPUT
To Switcher
Three-Conductor
Pigtail for Contact
Closure and Tally
Extron
HDMI “Show MeCables
Tx Rx
RS-232 AUTO
REMOTE
1234G
CONTACT
1234
+v
TALLY OUT
Green
Yellow
Pigtail
68-2321-50
Rev. D
11 13

Installation

1. Connect the input end of the “Show Me” cable to the source device.

2. Connect the output end to the Extron switcher.

3. Connect the black (Tally Out) and red (Contact) pigtail wires as

shown at right. The number under the Tally Out and Contact pins
corresponds to that particular video input on the switcher.

NOTES:

The drain wire does not need to be wired to the
switcher. The “Show Me” cables are grounded via the
video connectors.
Do not connect the “Show Me” cable pigtail wires to
the +V pin on the Extron switcher.
The Extron “Show Me” cables are for use with Extron TeamWork
systems. They feature a Share button for remote input source selection and a control pigtail, which can be wired directly into Extron switchers with contact closure and tally outputs. All versions of the “Show Me” cable are male to male.
Tx Rx
RS-232 AUTO
REMOTE
1 234G
CONTACT
1 234
+v
TALLY OUT
Red
Black
Pigtail
Extron Headquarters
+1.800.633.9876 (Inside USA/Canada Only)
Extron Asia
+65.6383.4400
Extron China
+86.21.3760.1568)
Extron Korea
+82.2.3444.1571
Extron Europe
+31.33.453.4040
Extron Japan
+81.3.3511.7655
Extron Middle East
+971.4.299.1800
Extron India
+91.80.3055.3777
© 2013 Extron Electronics — All rights reserved. All trademarks mentioned are the property of their respective owners. www.extron.com

Manual

View the manual for the Extron Show Me here, for free. This manual comes under the category cables for computers and peripherals and has been rated by 1 people with an average of a 5.7. This manual is available in the following languages: English. Do you have a question about the Extron Show Me or do you need help? Ask your question here

Need help?

Do you have a question about the Extron and is the answer not in the manual?

  • Receive updates on solutions
  • Get answers to your question

Question and answer

Number of questions: 0

Extron Show Me specifications

Below you will find the product specifications and the manual specifications of the Extron Show Me.

General
BrandExtron
ModelShow Me | 26-683-12
Productcables for computers and peripherals
LanguageEnglish
FiletypeUser manual (PDF)
Features
Cable length3.6 m
Connector 1HDMI Type A (Standard)
Connector 2HDMI Type A (Standard)
Connector 1 genderMale
Connector 2 genderMale
Maximum resolution4096 x 2160 pixels
Maximum refresh rate60 Hz
Product colorBlack
Logistics data
Harmonized System (HS) code84733080
show more

Frequently Asked Questions

Can't find the answer to your question in the manual? You may find the answer to your question in the FAQs about the Extron Show Me below.

Is the manual of the Extron Show Me available in English?

Yes, the manual of the Extron Show Me is available in English .

Is your question not listed? Ask your question here

No results