Extron RS-232 and IR Control manual

Extron RS-232 and IR Control
7.8 · 1
PDF manual
 · 56 pages
English
manualExtron RS-232 and IR Control
4. When finished configuring, disconnect the USB cable from the MLC, and replace the
faceplate.
NOTES: The USB port cannot remain connected when the faceplate is attached.
If you want to upload a new configuration via USB after the MLC has been
mounted, you must remove the faceplate from the MLC (see Removing the
Faceplate from a Mounted Unit on page 17 for the procedures).

IR Learning

The IR learning sensor on the MLC front panel behind the faceplate can receive and
“learn” commands from the infrared remote controls of other devices via the MLC
configuration program. IR Learning enables you to create an IR driver file to control the
projector or output devices such as a VCR or DVD player. IR Learning of projector control
codes is necessary only if there is no Extron driver available for your projector or if you
need to customize the driver.
The IR sensor accepts infrared signals of 30 KHz to 300 KHz. Point the IR remote control
directly at the sensor for best results. The diagrams below indicate the best distances and
angles at which to hold the remote control.
ON
OFF
RESET
E
PC
VOL
VOL
VIDEO
4"–14"
(10–36 cm)
1 2 3
4 5 6
7 8
0
9
VIDEO
S-Video
RGB1
RGB2
INPUTS
SET
UP
PLAY
PRG+
PRG–
POWER
REW
TV
INPUT
PAUSE
FF
STOP
DIR A
DIR
B
S
LE
E
P
T
V
MU
T
E

TIME/

LEVEL–

DLY/CNT/REAR

TIME/

LEVEL+

UP

LEFT RIGHT

DOWN

SKIP/CHAPTER

+100
–+
D
EC
K
A
/B

EFFECT

ON/OFF

REC/

PAUSE

INPUT SELECT
CD TAPE TUNER
PHONO
TV/DBS
TEST
DVD/LD VCR
ENTDISP
IR Learning
Sensor

MLC 55 Front Panel

Figure 19. IR Learning on an MLC 55 RS
To prepare for IR Learning, remove the faceplate (see Removing and Replacing the
Faceplate on page 16).
To set up the MLC for IR Learning, use the MLC 55, 62 and 64 Series Configuration
Program (see the configuration program help file for the procedures).

MLC 55 Series MediaLink Controllers • Installation and Operation 20

Manual

View the manual for the Extron RS-232 and IR Control here, for free. This manual comes under the category remote controllers and has been rated by 1 people with an average of a 7.8. This manual is available in the following languages: English. Do you have a question about the Extron RS-232 and IR Control or do you need help? Ask your question here

Index

Need help?

Do you have a question about the Extron and is the answer not in the manual?

  • Receive updates on solutions
  • Get answers to your question

Question and answer

Number of questions: 0

Extron RS-232 and IR Control specifications

Below you will find the product specifications and the manual specifications of the Extron RS-232 and IR Control.

General
BrandExtron
ModelRS-232 and IR Control | 60-1390-03
Productremote controller
EAN5712505902448
LanguageEnglish
FiletypeUser manual (PDF)
Design
InterfaceIR Wireless/Wired
Product colorWhite
Remote control proper useAV switch
Input typePress buttons
Backlight buttonsYes
Display
Built-in displayNo
Performance
Number of devices supported-
Maximum range- m
Battery
RechargeableNo
Built-in batteryNo
Power
AC input voltage100-240 V
AC input frequency50 - 60 Hz
Power consumption (transmitter) (max)1.1 W
Operational conditions
Operating temperature (T-T)0 - 50 °C
Operating temperature (T-T)32 - 122 °F
Storage temperature (T-T)-40 - 70 °C
Storage temperature (T-T)-40 - 158 °F
Operating relative humidity (H-H)10 - 90 %
Storage relative humidity (H-H)10 - 90 %
Weight & dimensions
Width44.7 mm
Depth35.8 mm
Height71.4 mm
Weight100 g
Packaging data
Package width187 mm
Package depth264 mm
Package height76 mm
Package weight790 g
Logistics data
Harmonized System (HS) code85299097
show more

Frequently Asked Questions

Can't find the answer to your question in the manual? You may find the answer to your question in the FAQs about the Extron RS-232 and IR Control below.

What is the weight of the Extron RS-232 and IR Control?

The Extron RS-232 and IR Control has a weight of 100 g.

A battery in my remote controller has started to corrode. Is the device still safe to use?

The product can still be used safely after proper cleaning. Remove the battery with gloves and clean the battery compartment with a toothbrush and vinegar. After drying, new batteries can be inserted into the device.

What is the height of the Extron RS-232 and IR Control?

The Extron RS-232 and IR Control has a height of 71.4 mm.

What is the width of the Extron RS-232 and IR Control?

The Extron RS-232 and IR Control has a width of 44.7 mm.

What is the depth of the Extron RS-232 and IR Control?

The Extron RS-232 and IR Control has a depth of 35.8 mm.

Is the manual of the Extron RS-232 and IR Control available in English?

Yes, the manual of the Extron RS-232 and IR Control is available in English .

Is your question not listed? Ask your question here

No results