Extron RS-232 and IR Control manual

Extron RS-232 and IR Control
7.8 · 1
PDF manual
 · 56 pages
English
manualExtron RS-232 and IR Control

ATTENTION:

Installation and service must be performed by authorized personnel only. UL

listed junction boxes are recommended.

L’installation et l’entretien doivent être effectués par le personnel autorisé

uniquement. Des boîtiers électriques approuvés UL sont recommandés.

The length of the exposed wires in the stripping process is critical. The ideal

length is 3/16 inches (5 mm). If they are any longer, the exposed wires may

touch, causing a short circuit between them. If they are any shorter, the wires

can be easily pulled out even if tightly fastened by the captive screws.

La longueur des câbles exposés est primordiale lorsque l’on entreprend de

les dénuder. La longueur idéale est de 5mm (3/16inches). S’ils sont un peu

plus longs, les câbles exposés pourraient se toucher et provoquer un court

circuit. S’ils sont un peu plus courts, ils pourraient sortir, même s’ils sont

attachés par les vis captives.

2. Plug the connector into the orange 2-pole captive screw power connector on the rear

panel. In the example shown in figure 14, a power supply is being connected to the

power connector of an MLC 55 RS.

- to PS ground

12 VDC input
MLC 55 Rear Panel
Ground all devices.Extron PS 1205 C
Exter
nal Power Supply(12 VDC, 0.5 A max.)

Figure 14. Connecting a Power Supply to an MLC

Removing and Replacing the Faceplate

Each MLC model is delivered with a faceplate that is attached by a magnet in each of its

four corners. This faceplate can be removed if you need to connect the computer to the

USB configuration port, perform IR Learning, access the Reset button, or exchange the

faceplate or volume knob for another.

Replacement kits containing a faceplate and volume knob (if appropriate) can be ordered

for US models only (see the Extron website for information on parts that are provided or

available to order for each model). Black faceplate kits can also be ordered for US models

(the MLC 55 RS VC kit also contains a black volume knob).

Removing a Faceplate from an Unmounted Unit

In order to connect and mount the MLC, you must remove the faceplate. To detach the

faceplate from the unit, grasp the unit firmly with one hand and, with the other hand, pull

the faceplate off the MLC metal mounting plate, starting with a corner.

MLC 55 Series MediaLink Controllers • Installation and Operation 16

Manual

View the manual for the Extron RS-232 and IR Control here, for free. This manual comes under the category remote controllers and has been rated by 1 people with an average of a 7.8. This manual is available in the following languages: English. Do you have a question about the Extron RS-232 and IR Control or do you need help? Ask your question here

Index

Need help?

Do you have a question about the Extron and is the answer not in the manual?

  • Receive updates on solutions
  • Get answers to your question

Question and answer

Number of questions: 0

Extron RS-232 and IR Control specifications

Below you will find the product specifications and the manual specifications of the Extron RS-232 and IR Control.

General
BrandExtron
ModelRS-232 and IR Control | 60-1390-03
Productremote controller
EAN5712505902448
LanguageEnglish
FiletypeUser manual (PDF)
Design
InterfaceIR Wireless/Wired
Product colorWhite
Remote control proper useAV switch
Input typePress buttons
Backlight buttonsYes
Display
Built-in displayNo
Performance
Number of devices supported-
Maximum range- m
Battery
RechargeableNo
Built-in batteryNo
Power
AC input voltage100-240 V
AC input frequency50 - 60 Hz
Power consumption (transmitter) (max)1.1 W
Operational conditions
Operating temperature (T-T)0 - 50 °C
Operating temperature (T-T)32 - 122 °F
Storage temperature (T-T)-40 - 70 °C
Storage temperature (T-T)-40 - 158 °F
Operating relative humidity (H-H)10 - 90 %
Storage relative humidity (H-H)10 - 90 %
Weight & dimensions
Width44.7 mm
Depth35.8 mm
Height71.4 mm
Weight100 g
Packaging data
Package width187 mm
Package depth264 mm
Package height76 mm
Package weight790 g
Logistics data
Harmonized System (HS) code85299097
show more

Frequently Asked Questions

Can't find the answer to your question in the manual? You may find the answer to your question in the FAQs about the Extron RS-232 and IR Control below.

What is the weight of the Extron RS-232 and IR Control?

The Extron RS-232 and IR Control has a weight of 100 g.

A battery in my remote controller has started to corrode. Is the device still safe to use?

The product can still be used safely after proper cleaning. Remove the battery with gloves and clean the battery compartment with a toothbrush and vinegar. After drying, new batteries can be inserted into the device.

What is the height of the Extron RS-232 and IR Control?

The Extron RS-232 and IR Control has a height of 71.4 mm.

What is the width of the Extron RS-232 and IR Control?

The Extron RS-232 and IR Control has a width of 44.7 mm.

What is the depth of the Extron RS-232 and IR Control?

The Extron RS-232 and IR Control has a depth of 35.8 mm.

Is the manual of the Extron RS-232 and IR Control available in English?

Yes, the manual of the Extron RS-232 and IR Control is available in English .

Is your question not listed? Ask your question here

No results