Extron DA 12V/6V DUAL EQ manual

Extron DA 12V/6V DUAL EQ
9.8 · 1
PDF manual
 · 22 pages
English
manualExtron DA 12V/6V DUAL EQ
DA AV EQ Series • Quick Start GuideDA AV EQ Series • Table of Contents

Table of Contents

All trademarks mentioned in this manual are the properties of their respective owners.
68-977-01 Rev. B
09 07
Chapter 1 • Introduction .......................................................... 1-1
About this Manual ................................................................ 1-2
About the DA AV EQ Series .............................................. 1-2
Models .................................................................................... 1-2
Features .................................................................................. 1-3
Application diagrams ............................................................ 1-4
Chapter 2 • Installation and Rear Panel ........................ 2-1
Mounting the DA AV EQ Series ...................................... 2-2
Tabletop use ........................................................................... 2-2
Rack mounting....................................................................... 2-2
UL rack mounting requirements ..................................... 2-2
Rack mounting procedure .............................................. 2-3
Furniture mounting ............................................................... 2-4
Through-desk mounting ....................................................... 2-6
Rear Panel Features and Cabling .................................. 2-7
Setting the Audio Output Gain .................................... 2-12
Chapter 3 • Front Panel Features and Operation ... 3-1
Front Panel Features ............................................................ 3-2
Gain and Equalization Controls ..................................... 3-4
Settings for short cables ........................................................ 3-5
Adjusting for long cables ...................................................... 3-6
Adjusting with an oscilloscope ....................................... 3-6
Adjusting without an oscilloscope ................................. 3-6
Appendix A • Specifications, Parts, and
Accessories ........................................................................................ A-1
Specifications ......................................................................... A-2
Models ........................................................................................ A-6
Included Parts ......................................................................... A-7
Optional Accessories........................................................... A-7
Cables ......................................................................................... A-8
i
QS-2

Quick Start Guide — DA AV EQ Series, cont’d

Step 4
Connect the cables of the input and output devices to the
DA AV EQ, and power on all equipment.
S-video devices are connected to 4-pin mini DIN
connectors.
Composite video devices are connected to BNC
connectors.
Audio devices are connected to captive screw or RCA connectors.
Step 5
Adjust the potentiometers (pots) for the output cable lengths, if
necessary.
If using very short output cables, make sure that the
potentiometers are in the unity gain position; that is, with the
arrow on each pot pointing to the dot beside or above the pot.
If the pots are already in the unity gain position (factory default
settings), DO NOT CHANGE THEM. If they are not in the
unity gain position, rotate them into position, using an Extron
Tweeker. The illustration below shows the pots for outputs 1
and 2 at the unity gain position.
EQGAIN
YC
1/2
GAIN
EQGAIN
1/2
Composite Video ModelsS-video Models
Potentiometers at unity gain setting
If using long cables, follow these steps to adjust the pots:
a. Supply the Color Bars test signal to the input.
(Recommendation: Use an Extron VTG 300 Video Test
Generator to generate the test signal.)
b. Adjust the Gain pot(s) for output pair 1 and 2 until the
signal level at the far end is the same as the input (or the
display shows the correct brightness and contrast).
c. Adjust the EQ pot for outputs 1 and 2 so that no overshoot
or round front corners appear at the far end on the scope
(or until you see a sharp picture with no smearing).
d. Repeat steps b and c for the rest of the outputs.

Manual

View the manual for the Extron DA 12V/6V DUAL EQ here, for free. This manual comes under the category receivers and has been rated by 1 people with an average of a 9.8. This manual is available in the following languages: English. Do you have a question about the Extron DA 12V/6V DUAL EQ or do you need help? Ask your question here

Need help?

Do you have a question about the Extron and is the answer not in the manual?

  • Receive updates on solutions
  • Get answers to your question

Question and answer

Number of questions: 0

Extron DA 12V/6V DUAL EQ specifications

Below you will find the product specifications and the manual specifications of the Extron DA 12V/6V DUAL EQ.

General
BrandExtron
ModelDA 12V/6V DUAL EQ | 60-694-01
Productreceiver
LanguageEnglish
FiletypeUser manual (PDF)
Technical details
Bandwidth150 MHz
Product colorBlack
Power
AC input frequency50 - 60 Hz
Input voltage100 - 240 V
Operational conditions
Operating temperature (T-T)0 - 50 °C
Storage temperature (T-T)-40 - 70 °C
Operating relative humidity (H-H)10 - 90 %
Storage relative humidity (H-H)10 - 90 %
Inputs
BNC input ports2
Outputs
BNC output ports12
show more

Frequently Asked Questions

Can't find the answer to your question in the manual? You may find the answer to your question in the FAQs about the Extron DA 12V/6V DUAL EQ below.

When is my volume too loud?

A volume above 80 decibels can be harmful to hearing. When the volume exceeds 120 decibels, direct damage can even occur. The chance of hearing damage depends on the listening frequency and duration.

Can bluetooth devices of different brands be connected to each other?

Yes, bluetooth is a universal method that allows different devices equipped with bluetooth to connect to each other.

What is bluetooth?

Bluetooth is a way of exchanging data wirelessly between electronic devices via radio waves. The distance between the two devices that exchange data can in most cases be no more than ten metres.

What is HDMI?

HDMI stands for High-Definition Multimedia Interface. An HDMI cable is used to transport audio and video signals between devices.

How can I best clean my receiver?

A slightly damp cleaning cloth or soft, dust-free cloth works best to remove fingerprints. Dust in hard-to-reach places is best removed with compressed air.

Wat is Dolby Atmos?

Dolby Atmos is a technology that ensures that the sound is reflected from the ceiling to where you are listening. This makes it possible to create a 5.1 effect with only 1 speaker.

Is the manual of the Extron DA 12V/6V DUAL EQ available in English?

Yes, the manual of the Extron DA 12V/6V DUAL EQ is available in English .

Is your question not listed? Ask your question here

No results