Electro Harmonix Signal Pad manual

Electro Harmonix Signal Pad
7.5 · 1
PDF manual
 · 1 page
English
manualElectro Harmonix Signal Pad

SIGNAL PAD

Passive Attenuator
Congratulations on your purchase of the Signal Pad. The Signal Pad is a
passive attenuator that allows you to reduce the signal level of your
instrument at the touch of a button. The signal path through the Signal Pad
is completely passive; the effect does not require power to work. The Signal
Pad’s power connection is only for lighting the LED.
- SIGNAL PAD APPLICAITONS -
The Signal Pad is simplicity itself. It’s like having the volume control of your
guitar in a pedal. If you have a classic single channel amp, you basically
have only one gain available to you. The Signal pad allows you to set up an
alternate volume for controlling your amplifier. As an example, if your
amplifier is set for a high gain distortion, you can run through the Signal Pad,
to lower your signal level. As you step on the footswitch, your amplifier will
back down and give you a cleaner tone with the same clarity and
characteristics. You’ve just turned your vintage single channel amp into a
dual channel, foot switchable amp.
You can also use the Signal Pad to set up alternate volumes to drive other
pedals and pedal boards. For example, in front of an envelope follower
pedal, such as the Q-Tron, the Signal Pad will allow you to change the Q-
Tron’s sensitivity. You will be able to switch between two different filter
sounds without the need to bend over and turn the knobs on the Q-Tron.
- CONTROLS -
Volume Knob – Controls the output volume of the Signal Pad.
Status LED - When the LED is lit, the signal pad is active. When the LED is
off, the Signal Pad is in True Bypass mode. Power is required for the LED to
light.
INPUT Jack – This ¼” jack is the audio input to the Signal Pad. The input
impedance presented at this jack is 1M.
OUTPUT Jack – This ¼” jack is the audio output from the Signal Pad.
When the Signal Pad is in Bypass mode, the OUTPUT jack is connected
directly to the INPUT jack.
9V Power Jack – In order to light up the Signal Pad’s LED, a battery must
be installed into the Signal Pad or an external AC Adapter power supply must
be plugged into the Power jack at the top of the Signal Pad. The polarity of
the Power jack is center negative. It requires 9VDC at 25 mA. We
recommend the Electro-Harmonix US96DC-200BI power supply.

View the manual for the Electro Harmonix Signal Pad here, for free. This manual comes under the category Not categorized and has been rated by 1 people with an average of a 7.5. This manual is available in the following languages: English. Do you have a question about the Electro Harmonix Signal Pad or do you need help? Ask your question here

Need help?

Do you have a question about the Electro Harmonix and the answer is not in the manual? Ask your question here. Provide a clear and comprehensive description of the problem and your question. The better your problem and question is described, the easier it is for other Electro Harmonix owners to provide you with a good answer.

Number of questions: 0

General
Electro Harmonix
Signal Pad
Not categorized
English
User manual (PDF)

Can't find the answer to your question in the manual? You may find the answer to your question in the FAQs about the Electro Harmonix Signal Pad below.

Is your question not listed? Ask your question here

No results