View the manual for the Einhell TC-TS 2025/2 U here, for free. This manual comes under the category Saws and has been rated by 8 people with an average of a 7.8. This manual is available in the following languages: English. Do you have a question about the Einhell TC-TS 2025/2 U or do you need help? Ask your question here
Can't find the answer to your question in the manual? You may find the answer to your question in the FAQs about the Einhell TC-TS 2025/2 U below.
What is the best way to clean my saw blade?
1. Wipe sawdust from the saw blade with a brush. 2. Spray the saw blade with oven cleaner and leave for 30 minutes. 3. Remove the oven cleaner and dirt with a dry cloth. 4. Grease saw blade with Vaseline.
My saw blade is blunt. What now?
If there is resin or other debris on the blade, it may look like the blade is blunt. If the saw blade has been thoroughly cleaned and is still blunt, it is recommended to have the saw blade sharpened.
How do I remove rust from my Einhell Saw?
1. Soak the rusty part in vinegar until completely soaked through. 2. Let the vinegar work on the rust for 24 hours. 3. Remove the rust with a wire brush or aluminium foil.
What does '16V' or '20V' mean?
The maximum achievable charge level is expressed with 16V or 20V. The V in this case stands for Volt.
Do I have to wear hearing protection when using a Saw?
The amount of sound varies a lot per brand and type of Saw, it is therefore wise to wear hearing protection to be sure.
Is the manual of the Einhell TC-TS 2025/2 U available in English?
Yes, the manual of the Einhell TC-TS 2025/2 U is available in English .
Do you have a question about the Einhell and the answer is not in the manual? Ask your question here. Provide a clear and comprehensive description of the problem and your question. The better your problem and question is described, the easier it is for other Einhell owners to provide you with a good answer.
There is a polystyrene block in a sealed bag in the box. What is it for?
My Einhell TC-TS 2025/2 U trips the electricity circuit breaker every time I push the start button. This happened from new the first time I tried to use it. The blade spins freely by hand and I can't see anything wrong with the assembly. And information would be greatly appreciated
how to change bladehow to change angle of cut
Number of questions: 3