ECS TIGT-I2 manual

ECS TIGT-I2
7.9 · 1
PDF manual
 · 68 pages
English
manualECS TIGT-I2

Preface

Preface

Copyright

This publication, including all photographs, illustrations and software, is protected
under international copyright laws, with all rights reserved. Neither this manual, nor
any of the material contained herein, may be reproduced without written consent of
the author.
Version 1.0

Disclaimer

The information in this document is subject to change without notice. The manufac-
turer makes no representations or warranties with respect to the contents hereof and
specifically disclaims any implied warranties of merchantability or fitness for any
particular purpose. The manufacturer reserves the right to revise this publication and
to make changes from time to time in the content hereof without obligation of the
manufacturer to notify any person of such revision or changes.

Trademark Recognition

Microsoft, MS-DOS and Windows are registered trademarks of Microsoft Corp.
MMX, Pentium, Pentium-II, Pentium-III, Celeron are registered trademarks of Intel
Corporation.
Other product names used in this manual are the properties of their respective
owners and are acknowledged.

Federal Communications Commission (FCC)

This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installa-
tion. This equipment generates, uses, and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful inter-
ference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one
or more of the following measures:
Reorient or relocate the receiving antenna
Increase the separation between the equipment and the receiver
Connect the equipment onto an outlet on a circuit different from that to
which the receiver is connected
Consult the dealer or an experienced radio/TV technician for help
Shielded interconnect cables and a shielded AC power cable must be employed with
this equipment to ensure compliance with the pertinent RF emission limits govern-
ing this device. Changes or modifications not expressly approved by the system’s
manufacturer could void the user’s authority to operate the equipment.

View the manual for the ECS TIGT-I2 here, for free. This manual comes under the category Motherboards and has been rated by 1 people with an average of a 7.9. This manual is available in the following languages: English. Do you have a question about the ECS TIGT-I2 or do you need help? Ask your question here

Need help?

Do you have a question about the ECS and the answer is not in the manual? Ask your question here. Provide a clear and comprehensive description of the problem and your question. The better your problem and question is described, the easier it is for other ECS owners to provide you with a good answer.

Number of questions: 0

Easily connect with the convenient DVI port for stunning HD visuals through a high quality and reliable digital connecti...
General
ECS
TIGT-I2 | TIGT-I2 (V1.0)
Motherboard
English
User manual (PDF)
Memory
Maximum internal memory4 GB
Number of memory slots2
Supported memory clock speeds667,800 MHz
Processor
Processor socketBGA 437
Processor modelD410
Compatible processor series-
Processor manufacturerIntel
Internal I/O
Number of SATA connectors2
USB 2.0 connectors2
S/PDIF out connector
CPU fan connector
ATX Power connector (24-pin)
Chassis intrusion connector
Number of chassis fan connectors1
Number of Parallel ATA connectors-
Rear panel I/O ports
Parallel ports quantity1
Serial ports quantity1
PS/2 ports quantity2
USB 2.0 ports quantity4
Firewire (IEEE 1394) ports0
Ethernet LAN (RJ-45) ports1
Headphone outputs1
Microphone in
VGA (D-Sub) ports quantity1
eSATA ports quantity0
DVI-D ports quantity0
HDMI ports quantity0
USB 3.2 Gen 1 (3.1 Gen 1) Type-A ports quantity0
Features
Motherboard form factormini ITX
Compatible operating systems-
Audio chipRealtek ALC662
Audio output channels- channels
Power source typeATX
Graphics
Parallel processing technology supportNot supported
Maximum graphics card memory384 MB
On-board graphics card
Graphics cardGMA 3150
Expansion slots
PCI Express x1 slots1
Weight & dimensions
Width170 mm
Depth170 mm
BIOS
BIOS typeAMI
BIOS memory size64 Mbit
show more

Can't find the answer to your question in the manual? You may find the answer to your question in the FAQs about the ECS TIGT-I2 below.

Is your question not listed? Ask your question here

No results