Ebony SV45 manual

(1)
  • Number of pages: 2
  • Filetype: PDF
7
4
21
3
5
61514
8
9
10
11
13
12
28
21
17
16
18
19
20
22
23
24
25
26
27
38
39 40
46
The lowest position of the
rear standard is zero position.
41
42
43
44
4535
34
33
32
29
36 37
SV45

USER'S GUIDE

23 Focusing frame
24 Focusing screen
25 Sliding latch for focusing hood
26 Alignment points indicating
rear shift zero position
27 Shift scale
28 Tripod mounting plate
29 Bellows release knob
30 Rear standard
31 Rear rise arm
32 Rear rise knob
33 Rear base tilts knob
34 Rear center tilts knob
35 Rear base tilts arm
36 Rear focusing knob
37 Front focusing knob
38 Latch to secure folded camera
39 Bellows
40 Sliding latch for bellows
release
41 Front rise/fall arm
42 Front rise/fall knob
43 Front center tilts knob
44 Front base tilts knob
45 Front base tilts arm
46 Front focusing knob

PART NAMES

1 Accessory shoe
2 Spirit level
3 Front standard
4 Alignment points indicating
front rise/fall zero position
5 Lensboard slot
6 Shift scale
7 Alignment points indicating
front shift zero position
8 Hand strap
9 Sliding latch for lensboard
10 Rear focusing lock knob
11 Front focusing lock knob
12 Front focusing lock knob
13 Front shift/swing locking lever
(shown in locked position)
14 Camera Bed
15 Latch pin
16 Film holder back
17 Spring tab for focusing screen
18 Rear shift/swing locking lever
(shown in locked position)
19 Two-way spirit level with mirror
20 Sliding latch for removable back
21 Focusing frame release lever
22 Sliding latch for roll film holder

How to adjust the movements:

(In all cases adjustments refer to both the knob indicated
and the corresponding knob on the other side of the
camera)
(a) Rise/Fall
Front: Loosen knob 42, and while holding it raise or lower front standard.
Rear: Loosen knob 32, and while holding it raise or lower rear standard.
(b) Center Tilts
Front: Loosen knob 43, and holding lower part of front standard, push
forward or pull back.
Rear: Loosen knob 34, and holding lower part of rear standard, push
forward or pull back.
(c) Base Tilts
Front: Loosen knob 44, then release from notch in front base tilts arm (45).
Rear: Loosen knob 33, then release from notch in rear base tilts arm (35).
(d) Shift/Swing
Front: Unlock front locking lever (13), then swing or push front standard to
the left or right.
Rear: Unlock rear locking lever (18), then swing or push rear standard to
the left or right.
Points to remember:
1) After making each adjustment, be sure to retighten the knobs or lever. If two
pairs of knobs are loose at the same time, particularly 33 and 34, the camera
becomes difficult to handle.
2) Loosen lock knobs 11 and 12 before making front focusing adjustments, and
lock knob 10 before making rear adjustments. Tighten again afterwards.
To install/remove focusing frame (23), pull focusing frame release lever (21).
31
30

Need help?

Number of questions: 0

Do you have a question about the Ebony SV45 or do you need help? Ask your question here. Provide a clear and comprehensive description of the issue and your question. The more detail you provide for your issue and question, the easier it will be for other Ebony SV45 owners to properly answer your question.

View the manual for the Ebony SV45 here, for free. This manual comes under the category Digital cameras and has been rated by 1 people with an average of a 7.5. This manual is available in the following languages: English. Do you have a question about the Ebony SV45 or do you need help? Ask your question here

Ebony SV45 specifications

General
Brand Ebony
Model SV45
Product Digital Camera
Language English
Filetype PDF

Frequently Asked Questions

Below, you will find the most frequently asked questions about the Ebony SV45.

Is your question not listed? Ask your question here