View the manual for the Easy Home GT-FS-03 here, for free. This manual comes under the category wipers and has been rated by 1 people with an average of a 7.5. This manual is available in the following languages: English. Do you have a question about the Easy Home GT-FS-03 or do you need help? Ask your question here
The Easy Home GT-FS-03 is a wiper that is designed to efficiently clean and maintain the clarity of car windshields. It is specifically engineered to fit a wide range of car models, ensuring a perfect fit for each vehicle. Constructed with high-quality materials, the GT-FS-03 offers durability and long-lasting performance. It is designed to withstand various weather conditions, providing effective wiping even in extreme temperatures or heavy rain. Equipped with advanced wiping technology, the GT-FS-03 delivers efficient and streak-free cleaning. It effectively removes dirt, dust, and debris from the windshield, ensuring optimal visibility for the driver. The GT-FS-03 is easy to install, requiring minimal effort and no additional tools. It is designed to seamlessly integrate with the existing wiper mechanism of the car, allowing for a hassle-free installation process. With its smooth and quiet operation, the GT-FS-03 provides a comfortable driving experience. It is designed to minimize noise and vibration, ensuring a quiet and distraction-free ride. The Easy Home GT-FS-03 is a reliable and efficient wiper that offers superior performance and durability. Its custom-fit design, advanced wiping technology, and ease of installation make it a convenient choice for car owners looking to enhance their driving experience.
Can't find the answer to your question in the manual? You may find the answer to your question in the FAQs about the Easy Home GT-FS-03 below.
If the Easy Home GT-FS-03 wiper is not functioning, you can follow these steps to troubleshoot the issue: 1. Check the battery: Ensure that the battery is fully charged. If not, connect the wiper to the charging device and let it charge until the battery is fully charged. 2. Disconnect the charging device: If the wiper is still connected to the charging device, remove the charging cable. The wiper should not be connected to the charging device while in use. 3. Vacuuming issue: If the wiper is not vacuuming up water properly, guide the squeegee lip of the vacuum attachment slowly from top to bottom over the wet surface, moving parallel to the work surface. Pay attention to the correct angle of the wiper. 4. Water leakage: If you hear a buzzing noise and water is leaking out of the bottom of the wiper, hold the device vertically for a short time. This allows the water in the device to run into the water storage tank. If the issue persists after following these steps, please contact the supplier's Customer Service Hotline for further assistance.
To fix the issue of water not being vacuumed up properly by the Easy Home GT-FS-03 wiper, you can follow these steps: 1. Guide the squeegee lip of the vacuum attachment slowly from top to bottom over the wet surface, not sideways. Make sure to move the device parallel to the work surface. 2. Pay attention to the correct angle of the wiper. Hold the device parallel with the surface to be squeegeed to ensure that the squeegee lip is positioned at the correct angle. 3. If you are cleaning floor tiles in a horizontal position, hold the device vertically from time to time. This allows the water in the device to flow into the water storage tank. A valve prevents the water from flowing back. 4. Avoid guiding the squeegee lip sideways over the wet surface. This can cause the water to run down the side of the squeegee lip instead of being vacuumed up. 5. Once the surface is dry, switch off the device by pressing the On/Off button again. Remove any streaks or moisture residue with a dry cloth. Following these steps should help resolve the issue of water not being vacuumed up properly by the Easy Home GT-FS-03 wiper.
If water is leaking out of the Easy Home GT-FS-03 wiper, you can follow these steps to address the issue: 1. Hold the device vertically for a short time. This allows the water in the device to run into the water storage tank. This step helps prevent water from leaking out of the bottom of the device. 2. Check the non-return valve. Turn the non-return valve counter-clockwise and remove it. Empty out any dirty water from the tank. 3. Reinsert the non-return valve into the water tank and turn it clockwise until it is securely in place. Ensure that the valve is inserted properly and that the recesses and retaining lugs are perfectly fitted. 4. Make sure the water storage tank is properly reinserted into the device. Hold the tank by the recessed grips and insert it at an angle towards the front and down. By following these steps, you should be able to address the issue of water leaking out of the Easy Home GT-FS-03 wiper.
The battery type and capacity of the Easy Home GT-FS-03 wiper are as follows: - Battery Type: Li-Ion (Lithium-Ion) - Battery Capacity: 2,200 mAh (milliampere-hour) - Battery Voltage: 3.7 V (volts) These specifications indicate that the wiper is equipped with a rechargeable Li-Ion battery with a capacity of 2,200 mAh and a voltage of 3.7 V. The Li-Ion battery technology provides a good balance between power and energy efficiency, allowing for longer usage time on a single charge. Please note that these specifications are based on the available information in the manual for the Easy Home GT-FS-03 wiper.
The battery life of the Easy Home GT-FS-03 wiper when fully charged is not explicitly mentioned in the available manual. However, based on general industry standards and the capacity of the battery (2,200 mAh), we can estimate an approximate battery life. Typically, a wiper with a similar battery capacity can provide a battery life of around 45 minutes to 1 hour when fully charged. This estimation may vary depending on factors such as the usage intensity, surface conditions, and the age of the battery. To maximize the battery life, it is recommended to fully charge the battery before each use and avoid overcharging. Additionally, ensure that the wiper is used efficiently to minimize unnecessary power consumption. Please note that the provided estimation is based on industry standards and may vary in real-world usage scenarios.
The input voltage range of the charging device for the Easy Home GT-FS-03 wiper is 100-240 V~ with a frequency of 50/60 Hz. This means that the charging device can accept a wide range of input voltages, allowing it to be used in different regions with varying electrical systems. It is important to note that the charging device should be connected to a power source within this voltage range to ensure safe and proper charging of the wiper's battery. The charging device has an output voltage of 5 V and an output current of 800 mA. Please ensure that you use the provided charging device and connect it to a power source within the specified input voltage range to avoid any potential damage to the device or the charging process. These specifications are based on the available information in the manual for the Easy Home GT-FS-03 wiper.
The material used for the microfibre cover of the Easy Home GT-FS-03 wiper is not explicitly mentioned in the available information. However, based on the cleaning instructions provided in the manual, it is recommended to clean the microfibre cover by hand-washing it. The manual advises against bleaching, wringing out, drying in the tumble dryer, or ironing the microfibre cover. Microfibre is a common material used for cleaning purposes due to its absorbent and gentle properties. It is known for its ability to effectively trap and remove dirt, dust, and moisture from surfaces. To clean the microfibre cover, you can follow these steps: 1. Remove the microfibre cover from the wiper. 2. Hand-wash the microfibre cover using a mild detergent and lukewarm water. 3. Gently scrub the cover to remove any dirt or stains. 4. Rinse the cover thoroughly with clean water. 5. Squeeze out excess water without wringing or twisting the cover. 6. Allow the microfibre cover to air dry completely before reattaching it to the wiper. By following these steps, you can effectively clean the microfibre cover of the Easy Home GT-FS-03 wiper and maintain its cleaning performance.
I apologize, but I couldn't find specific information about how to contact the supplier's Customer Service Hotline for after-sales support for the Easy Home GT-FS-03 wiper in the available data. To obtain the contact information for the supplier's Customer Service Hotline, I recommend checking the packaging of the product or any accompanying documentation, such as a warranty card or user manual. The contact details for customer support are typically provided in these materials. If you are unable to find the contact information, you can try visiting the supplier's website and looking for a "Contact Us" or "Support" section. This section should provide you with the necessary contact details, such as a phone number or email address, to reach the supplier's Customer Service Hotline. Please note that the specific contact information may vary depending on your location and the supplier's policies.
Yes, the manual of the Easy Home GT-FS-03 is available in English .
Is your question not listed? Ask your question here
No results
Need help?
Do you have a question about the Easy Home and is the answer not in the manual?
Question and answer
Number of questions: 1I need a new water reservoir. Please can you tell me where I can get spares.