manualDJI NAZA-M LITE

NAZA-M LITE

User Manual

V 2.00

2014.04.21 Revision

For Firmware Version V1.00

& Assistant Software Version V1.00

Thank you for purchasing this DJI product. Please strictly follow these steps to mount and connect this system on

your aircraft, as well as to install the Assistant Software on your computer.

Please regularly check the NAZA-M LITE web page at our website www.dji.com for latest information. Product

information, technical updates and manual corrections will be available on this web page. Due to unforeseen changes

or product upgrades, the information contained in this manual is subject to change without notice.

* This manual is only for basic assembly and configuration; you can obtain more details and advanced instructions

when using the assistant software. To assure you have the latest information, please visit our website and download

the latest manual and current software version.

If you have any problem that you cannot solve during usage, please contact your authorized dealer.

www.dji.com

View the manual for the DJI NAZA-M LITE here, for free. This manual comes under the category not categorized and has been rated by 2 people with an average of a 9.4. This manual is available in the following languages: English. Do you have a question about the DJI NAZA-M LITE or do you need help? Ask your question here

Need help?

Do you have a question about the DJI and the answer is not in the manual? Ask your question here. Provide a clear and comprehensive description of the problem and your question. The better your problem and question is described, the easier it is for other DJI owners to provide you with a good answer.

Number of questions: 0

General

	DJI
	NAZA-M LITE
	not categorized
	English
	User manual (PDF)

Can't find the answer to your question in the manual? You may find the answer to your question in the FAQs about the DJI NAZA-M LITE below.

How do I calibrate the compass on my DJI NAZA-M LITE?

To calibrate the compass on your DJI NAZA-M LITE, start by connecting your drone to the assistant software. Then, select the "Basic" tab and click on "Calibrate Compass." Follow the on-screen instructions to complete the calibration process.

How can I set up failsafe for my DJI NAZA-M LITE?

Setting up failsafe for your DJI NAZA-M LITE is crucial for safety. Connect your drone to the assistant software and go to the "Receiver" tab. Enable failsafe and configure the desired actions for each channel in case of signal loss.

What are the steps to perform an ESC calibration on my DJI NAZA-M LITE?

ESC calibration is essential to ensure proper motor synchronization. First, disconnect the battery. Then, connect only the ESCs to the DJI NAZA-M LITE without the flight controller. Power on your transmitter in full throttle position, and then connect the battery. Wait for the ESCs to emit a tone indicating the successful calibration.

How can I adjust the gain settings on my DJI NAZA-M LITE?

Adjusting gain settings allows you to fine-tune the stability and control of your drone. Connect your drone to the assistant software and navigate to the "Basic" tab. Under the "Gain" section, you can adjust the values for roll, pitch, and yaw. Lower values provide more stability, while higher values increase responsiveness.

What is the recommended voltage range for my DJI NAZA-M LITE's power supply?

The recommended voltage range for the power supply of the DJI NAZA-M LITE is between 4.8V and 5.5V. Make sure not to exceed this range to prevent potential damage to the flight controller.