DeWalt DWS780 manual
PDF manual
·
168 pages
English
Manual
View the manual for the DeWalt DWS780 here, for free. This manual comes under the category Saws and has been rated by 8 people with an average of a 8.9. This manual is available in the following languages: English. Do you have a question about the DeWalt DWS780 or do you need help? Ask your question here
DeWalt DWS780 specifications
Below you will find the product specifications and the manual specifications of the DeWalt DWS780.
Power
| Input power | 1675 W |
| Power source | AC |
Packaging content
| Blade diameter | 305 mm |
| Blade bore | 30 mm |
| Saw blade included | ✓ |
| Dust bag included | ✓ |
Performance
| Idle speed (max) | 3800 RPM |
Other features
| Cutting capacity 45° mitre | 212 x 76 mm |
Features
| Spindle lock | ✓ |
Weight & dimensions
| Depth | 470 mm |
| Height | 396 mm |
| Weight | 24800 g |
Frequently Asked Questions
Can't find the answer to your question in the manual? You may find the answer to your question in the FAQs about the DeWalt DWS780 below.
What is the weight of the DeWalt DWS780?
What is the best way to clean my saw blade?
My saw blade is blunt. What now?
How do I remove rust from my DeWalt Saw?
What does '16V' or '20V' mean?
Do I have to wear hearing protection when using a Saw?
What is the height of the DeWalt DWS780?
What is the depth of the DeWalt DWS780?
Is the manual of the DeWalt DWS780 available in English?
Is your question not listed? Ask your question here
No results
Need help?
Do you have a question about the DeWalt DWS780 and the answer is not in the manual? Ask your question here. Provide a clear and comprehensive description of the problem and your question. The better your problem and question is described, the easier it is for other DeWalt DWS780 owners to provide you with a good answer.
I just purchased a DWS780 Double Sliding Compound Miter Saw and believe I properly worked through the set-up instructions but the blade is not lined up within the slot in the Kerf Plate. It is much closer to the left-hand side and at a slight angle. It is off enough that when I pull the saw out towards the lock handle, it scrapes along the left-hand side of the Kerf Plate (see attached photo). How do I center the blade within the Kerf Plate slot and ensure it is aligned with the slot?
Number of questions: 1