This page will allow you to change the administrator (Admin) password and
enable the HTTPS server. In the Management menu on the bar on the top of
the page, click SystemAdmin.
Admin Password
Password:Enter a new password for the administrator account. You will need to
enter this password whenever you congure Covr Point A using a web
browser.
Enable Graphical
Authentication
(CAPTCHA):
Enables a challenge-response test to require users to type letters or
numbers from a distorted image displayed on the screen to help prevent
online hackers and unauthorized users from access to your network.
Advanced Settings - Administration
Enable HTTPS
Server:
Check to enable HTTPS to connect to the extender securely. Instead of
using http://covr.local./, you must use https://covr.local./ in order to
connect to Covr Point A.
Note: If you previously changed the management link in the Network
section, replace covr.local./ with the new management link.
Enable Remote
Management:
Remote management allows Covr Point A to be congured from the
Internet by a web browser. A password is still required to access the web
management interface.
Enable Admin
Port:
The port number used in the URL to access Covr Point A.
Example: http://x.x.x.x:8080 where x.x.x.x is the Internet IP address of Covr
Point A and 8080 is the port used for the web management interface.
Note: If you enabled Use HTTPS and wish to access Covr Point A remotely
and securely, you must enter https:// at the beginning of the address.
Manual
View the manual for the D-Link AC2202 here, for free. This manual comes under the category access points and has been rated by 1 people with an average of a 6.4. This manual is available in the following languages: English. Do you have a question about the D-Link AC2202 or do you need help? Ask your question here
Need help?
Do you have a question about the D-Link and is the answer not in the manual?
Question and answer
Number of questions: 0